Empire Products DV-25T-1 manuale d’uso

Page 1 INST ALLA TION INSTRUCTIONS AND OWNER'S MANUAL W ARNING: If not installed, operated and maintained in accordance with the man ufac tur er's ins truct ions , th is pr oduct cou ld expose you to substances in fuel or fr om fuel combustion which can cause death or serious illness. Th i s ap pl i an ce ma y b e i ns ta ll ed in an af t[...]

131 17-9-0907 Page 2 SECTION P AGE Important Safety Information ......................................................................................................................3 V ent Kit Information .................................................................................................................................... 3 Safety In[...]

131 17-9-0907 Page 3 • Due to high temperatur es the appliance should be located out of traffic and away from furnitur e and draperies. • Children and adults should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or clothing ignition. • Y oung children should be car efully supervised when they are i[...]

131 17-9-0907 Page 4 Some people cannot smell well. Some people cannot smell the odor of the chemical put into the gas. Y ou must find out if you can smell the odorant in propane. Smoking can decrease your ability to smell. Being around an odor for a time can affect your sensitivity or ability to detect that odor . Sometimes other odors in the are[...]

131 17-9-0907 Page 5 REQUIREMENTS FOR MASSACHUSETTS For all side wall horizontally vented gas fueled equipment installed in every dwelling, building or structure used in whole or in part for residential purposes, including those owned or operated by the Commonwealth and where the side wall exhaust vent termination is less than seven (7) feet above [...]

131 17-9-0907 Page 6 Introduction Al w a ys c on s u lt y ou r l o ca l B ui l di n g D e pa r t me n t r e ga r d in g regulations, codes or ordinances which apply to the installation of a direct vent wall furnace. Instructions to Installer 1. Installer must leave instruction manual with owner after installation. 2. Installer must have owner fill[...]

131 17-9-0907 Page 7 Locating Gas Supply The gas line can enter the unit either through the floor or outside wall. The gas line opening should be made at this time. Location of the opening will be determined by the position of floor joists and the valve and union used for servicing. Recommended Gas Pipe Diameter Note: Never use plastic pipe. Chec[...]

131 17-9-0907 Page 8 1. In selecting a location for installation, it is necessary to provide adequate accessibility clearances for servicing and proper installation. 2. Unit is supported by a wall bracket secured to the wall. 3. Th e min imu m cle ara nce s fro m cas ing to com bus tib le co nst ruct ion is 48" (121cm) on top, 6" (152mm) [...]

131 17-9-0907 Page 9 Installing W all Mounting Bracket Locate and cut wall opening. If there is insulation above the wall open- ing (air inlet tube) a barrier should be installed above the wall opening (air inlet tube) to prevent insulation from coming in contact with the air inlet tube. The barrier must not penetrate into the 7 1/2" diameter [...]

131 17-9-0907 Page 10 Installing V ent Assembly Attention: Do not attempt to cut vent tubes. When you order appropriate vent kit for measured wall depth, the vent tubes will fit together . 1. Place provided caulking beneath the collar of the outside mounting plate. Use additional caulking to correct uneven wall surface, such as clapboard. 2. Inser[...]

131 17-9-0907 Page 1 1 Millivolt wall thermostats are specially designed for use on self-generating systems. They should never be used on line or low voltage A.C. circuits. Figure 9 Interior W all - The thermostat can also be installed on an inside wall away from the furnace but in the same room. It is important to use wire of a gauge proper for th[...]

131 17-9-0907 Page 12 FOR YOUR SAFETY READ BEFORE LIGHTING W ARNING: If you do not follow these instructions exactly , a fir e or explosion may result causing property damage, personal injury or loss of life. A. This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly . B. BEFORE LIGHTING[...]

131 17-9-0907 Page 13 The correct flame will be almost horizontal, blue and will extend past the thermopile 1/4" (6mm). The flame will surround the thermopile just below the tip. On propane (LP-gas) slight yellow might occur where the pilot flame and burner flame meet. Natural gas pilots require adjusting when the inlet pressure is above 5[...]

131 17-9-0907 Page 14 1. Lit match goes out as it enters lighter port. a. Certain wind conditions will blow out match. Ignite match, and as it flares, thrust match through opening. b. Open nearby door or window and relight pilot. 2. Pilot flames but goes out when knob is r eleased. a. See Lighting Instructions. Relight Pilot. b. Relight the pilot[...]

131 17-9-0907 Page 15 PLEASE NOTE: When ordering parts, it is very important that part number and description of part coincide. USE ONL Y MANUF ACTURER'S REPLACEMENT P AR TS. USE OF ANY OTHER P AR TS COULD CAUSE INJUR Y OR DEA TH. Parts can be ordered only through your service person or dealer . For best results, the service person or dealer s[...]

131 17-9-0907 Page 16 P AR TS VIEW[...]

131 17-9-0907 Page 17 OPTIONAL BLOWER DRB-1 Installing Optional DRB-1 Blower 1. Remove casing from front and heat shield 2. When facing appliance, insert blower assembly into the left section of the casing (adjacent to the combustion chamber). 3. Route cord set through ope ning in casing in bottom. The open ing in casing bottom is located beneath g[...]

131 17-9-0907 Page 18 Cleaning The blower wheel will collect lint and could require cleaning once a year . If the air output decreases or the noise level increases, it indicates a dirty wheel. Complete removal of the wheel and scrubbing it with a brush under flowing water is recommended. Oiling The blower motor has an oil hole located on each end [...]

131 17-9-0907 Page 19 SER VICE NOTES[...]

131 17-9-0907 Page 20 Empire Comfort Systems, Inc. 918 Freeburg A ve. Belleville, IL 62220 PH: 618-233-7420 or 800-851-3153 F AX: 618-233-7097 or 800-443-8648 info@empirecomfort.com www .empir ecomfort.com[...]