Majestic ODGSR36ANAU manual

MAJESTIC OUTDOOR GAS FIREPLACE Model: ODGSR36ANAU & ODGSR36APAU Installation and Operating Instructions Page 1 of 18[...]

CONTENTS Part 1: For Your Safety Part 2: Installation Instructions • General Information • Fireplace Dimensions • Clearance to Combustibles • Mantels • Mantel Chart • Hearth • Framing and Finishing • Final Finishing • Gas Specifications • Gas Inlet and Burner Pressures • High Elevations • Valve Access • Gas Fitting Line In[...]

Part 1: For Your Safety For your safety do not operate this appliance before reading this instruction book. WARNING: Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. For assistance or additional information consult with Raypak Australia, your Raypak distributor, qualified installer or accr e[...]

GENERAL INFORMATION FOR SAFE INSTALLATION AND OPERATION OF YOUR GAS APPLIANCE PLEASE NOTE THE FOLLOWING: a) This appliance gives o ff high temperatures and should be located out of high traffic areas and away from outdoor furn iture and blinds or curtains. b) Children and adults should be ale rted to th e hazards of high surf ace temperatures of th[...]

Ventilation Requirements Adequate combustion and ventilation air must be provided. The fl ow of combustion and ventilation air MUST NOT be obstructed. NOTE: THIS APPLIANCE MUST NOT BE INSTALLED OR USED IND OORS. This appliance shall only be used in an above ground, open-air sit uation with natural ventilation, without stagn a nt areas, where ga s l[...]

See examples below of Outdoor Areas: Figure 1: Overall and framing dimensions. Page 6 of 18[...]

Clearance to Combustibles (Refer Figure 1) Top framing …………………………………………………… 0 mm to standoff spacer Bottom……………………………… ……………………………0 mm Side framing …………………………………………… ……..0 mm to standoff spacer Back framing ………………?[...]

: A minimum of 100mm above th e fireplace must be non- combustible material (eg fibre cement sheeting). Figure 2a Figure 2b Framing and Finishing Warning: Check appliance to make sure it is levelled and properly positioned. The appliance should on ly be mounted on th e following surfaces: • A flat combustible (burnable) surface. • A raised wood[...]

Figure 3 Finishing CAUTION: All joints between the fini shed wall and the appliance surround (top and sides) may be sealed only with a non-combustible material. Only non-combustible material can be applied as facing to the appliance surround as per Figures 2a and 2b. Gas Specification (always refer to appliance Data plate) GAS SPECIFICATION MODEL G[...]

Valve Access Valve can be accessed in one of two ways: 1. Remove the front panel just below the fr ont of the hea rth pan. This is accomplished by lifting on the panel. To replace the valve access panel line up the two pins with the hole s in the surround bottom and push the panel over the hearth pan. (Refer Figure 4) 2. Lift the brick with Majesti[...]

Part 3: Operating Instructions Log Installation Warning: As with all plastic bags, th ese bags are not toys and should always be kept away from children and infants. 1. Remove logs from packaging. 2. Place left rear log on rear support. Ensure th at log is firmly positioned and there is no side to side movement. (Refer to Figure 11) 3. Carefully pl[...]

Flame Adjustment For units equipped with Hi/Lo valves, flame adjustment is achieved by rota ting the Hi/L o adjustment knob located near the centre of the gas control valve. Figure 12 – SIT 820 Gas Control Knob Flame Characteristics It is important to periodic ally perform a visual check of the pilot and the burner flames (refer Figures 13 & [...]

Page 13 of 18[...]

Troubleshooting Nova SIT 820 Standing Pilot S T A R T C H E C K Gas supply connected Gas Supply On Shut off valve open N o Lockout has engaged. Wait 60 seconds and try again. Piezo not tight enough for good ground. Y es For spark at electrode while depressing Piezo 1/8” gap to pilot hood required. Gas Supply On N o All wiring connections. Replace[...]

Maintenance Burner and burner compartment It is important to keep the burner and the burner compar tment clean. At least once a year the logs should be removed and the burner comp a rtment vacuumed and wiped out. Remove and replace the logs as per the instructions in this ma nual. Always handle the logs with care as th ey are fragile and may also b[...]

Parts List Page 16 of 18[...]

Part 6: Warranty LIMITED LIFETIME WARRANTY PRODUCT COVERED BY THIS WARRANTY All Vermont Castings gas stoves, gas inserts, and gas fi replaces, and all Majestic or Northern Flame brand gas fireplaces equipped with an Insta-Flame Ceramic Burner or steel tube burner. BASIC WARRANTY CFM Specialty H ome Products (hereinafter ref erred to coll ectively a[...]

IF WARRANTY SERVICE IS NEEDED... 1) Contact your supplier. Make sure you hav e your warranty, yo ur sales receipt, and the model/serial number of your Raypak Majestic Gas Log fire. 2) DO NOT ATTEMPT TO DO ANY SERVICE WORK YOURSELF Distributed By: Raypak Australia 39 Koornang Road Scoresby Victoria 3179 Ph: 03 9757 3333 Fax: 03 9757 3350 For Service[...]