United States Stove 6039HF manual

USSC 1 851672 CORN & PELLET MUL TIFUEL ST OVE 6039HF OWNER’S MANUAL Installation - Operation - Maintenance Instructions - Repair Parts READ THIS ENTIRE MANUAL , THOROUGHL Y , BEFORE A T TEMPTING TO INST ALL AND/OR BURN YOUR NEW HEAR TH FOCUS CORN AND PELLET MUL TI-FUEL ST OVE. F AILURE T O FOL - LOW THESE INSTRUCTIONS MA Y RESUL T IN PROPERTY[...]

2 USSC Heat Input, Maixmum 52,200 BTU/HR Heat Output, Maximum , , , , , 48,280 BTU/HR Heating Capacity 1,200 Sq. Ft 0 Fuel Storage Capacity 60 Lbs. Width 29 in./737mm Height 31 in./787mm Depth 28 in./711mm SPECIFICATIONS United States Stove Company ( manufacturer of the Hearth Focus Multifuel Pellet Stove ) reserves the right to alter products, spe[...]

USSC 3 6039HF ASSEMBLY Assembly 1. Unpack unit and make sure all components are included; (4) Legs and all hardware for installation. 2. Inside the unit are two(2) Ash Dump Covers located to the left and right of the burnpot. Remove these for leg and guiderail assembly . (See pg. 15 for ash dump cover desciption) 3. Fold the corner padding from the[...]

4 USSC Ashes will have to be R emoved from the stov e periodical ly . See cleaning procedure. Y our Hearth Focus sto v e, due to the natur e of sol id f uels, wi l l r equir e brief periodic at tention. Please do not expect to l ight your stove and walk away from it. A few moments of adjustment and cleaning from time to time is an important part of[...]

USSC 5 FLOOR PROTECTION The Hearth Focus Multifuel Stove may be installed on a combustible floor , with proper floor protection, or on a masonry hearth. The hearth or noncombustible floor protector must extend a minimum of (6) inches (152mm)in front and (6) inches (152mm) from each side of the ash remov al door . INSTALLATION REQUIREMENTS SHELLED C[...]

6 USSC CLEARANCES TO COMBUSTIBLES The stove must be installed with the following minimum clearances to side and back wall combustible materials. NOTE: These are minimum clearances to combustible walls established by the testing lab. The amount of room needed on the left side of the unit to access the electrical panel is (6) six inches (152mm). PARA[...]

USSC 7 GUIDELINES FOR EXHAUST VENTING SYSTEMS DESIGN • • • • • • • • A UL listed 3” or 4” type “PL ” pellet vent exhaust system must be used f or installation and attached to the pipe connector provided on the back of the sto ve. Use a 3” to 4” adapter for 4” pipe. A cap must be used at the termination of type “L ”[...]

8 USSC For installations with horizontal through-the-wall exhaust, it is strongly recommended that the stove combustion air be connected to the outside. If the home is newer or has been tightly insulated it is required to install outside combustion air . Connection to outside the house is REQUIRED for mobile home installations. W e strongly urge us[...]

USSC 9 Locate proper position f or the type “PL ” wall thimble (F). Use a saber saw or keyhole saw to cut a 7 1/4-inch diameter hole through the wall (E) for a 3-inch pipe. For a 4-inch pipe, cut an 8 1/4-inch hole. Install the wall thimble (F)in the hole. The size of hole opening will vary with brand of wall thimble. P osition stove approximat[...]

10 USSC Note: Always check dimensions on unit before cutting hole in wall Dimensional tolerance ±0.25” 10 1/16 11 5/8 12 E XHAUST OUTLET 3' DIA COMBUSTION AIR INTAKE 1 7/8" DIA 6039HF 3’ Minimum V ertical Pipe[...]

USSC 11 THROUGH THE WALL, VERTICAL PIPE INSTALLATION WITH TERMINATION CAP The Hearth Pad is not required under the unit if the floor is noncombustible but is required 6 inches (152mm) beyond the front of the unit and 6 inches (152mm) beyond each side of the door if the floor is a combustble floor . wood flooring, carpet, linoleum, etc.[...]

12 USSC Y our Hearth Focus Corn/Pellet Stove comes to you with the glass door installed in place, ready for use. The glass is surrounded on the edges with a gasket and seated in a glass channel. It is held in place with four (2) clips. REMOVAL OF BROKEN OR DAMAGED CERAMIC GLASS Open the door and lift off of hinges. If the door is tight, tap gently [...]

USSC 13 UNDERSTANDING THE CONTROL BOARD CONTROL PANEL T urning the heater OFF/ON, as well as adjustments for the fuel feed rate and room fan speed are performed by pressing the appropriate button(s) on the control panel which is located on the lower left-hand side of your Hearth Focus heater. This unit can be changed between an automatic operation [...]

14 USSC CAUTION: DO N OT USE CHEMICALS OR FLUIDS TO ST ART THE FIRE HOT WHILE IN OPERA TION. KEEP CHILDREN, CLO THING AND FURNITURE AW AY . CONT ACT MA Y CAUSE SKIN BURNS. LIGHTING INSTRUCTIONS Before lighting y our Hearth Focus for the first time, make sur e that al l items are out of the hopper , ash pan and firebox area. Press the “On” butto[...]

USSC 15 SPECIAL CLEANING/OPERATIONAL INSTRUCTIONS: After cleaning or when operating the stove, you need to make sure that “both” clean-outs are in their proper position. If left out or placed incor- rectly , the combustion air is eff ected greatly and the stove will not burn properly . MAINTENANCE INSTRUCTIONS • • • • Surfaces on the fr[...]

16 USSC FUEL ADDITIVE Chicken Scratch for my Corn Burner? Y es - Cr azy as it may sound, ground Oyster Shells, (calcium carbonate) same as fed to chickens, is the ideal additiv e to promote clean burning, especially when the Corn Fuel is extra high in starch. And it’s available at your local Feed and Seed. The “aver age” mixture is 1/2 pound [...]

USSC 17 Exhaust Blower Agitator Auger Room Fan Automatic Shutdown Normal Operation COMPONENT OPERA TION ST ART OPERA TION END CIRCUIT BOARD FUNCTIONS ST ART -UP SEQUENCE OF EVENTS Once the control panel is turned to on, a timer begins that will start, stop and continue operation of the Hearth Focus as a preset temperature is achieved. S tarts Immed[...]

18 USSC ERROR CODES and DISPLAY INDICATORS CAUTION: When performing any internal electrical maintenance • Moving parts inside of the cabinet may cause injury . Do not oper ate unit with panels remov ed or open. • HOT parts. Do not operate the unit with panel open. • Risk of electric shock. Disconnect power before servicing unit. • In the ev[...]

USSC 19 TROUBLE SHOOTING Unplug stove before performing any maintenance PROBLEM CAUSE: T oo rich air/fuel mixture ? Fire burns with a lazy , orange flame and/or fuel builds up in the firepot. Glass may become dirty . ? Fire goes out or stove shuts down. Fuel may stop feeding. ? Fire goes out or stove shuts down. Fuel may stop feeding. Make sure gla[...]

20 USSC WIRING DIAGRAM[...]

USSC 21 REPAIR PARTS DIAGRAM-6039HF[...]

22 USSC K EY PAR T # DESCRIPTION QTY. 1 69516 Feed Door Assembly 1 2 25080MB Latch, Door 1 3 25523 Leg, Cast Iron 4 4 69478MB Ash Pan Weldment (6039) 1 5 69486MB Left Side Weldment 1 6 25412MB Cabinet Side, Right 1 7 25413MB Cabinet Back 1 8 25448 Support Frame (Back/Left) 1 9 25447 Support Frame (Back/Right) 1 10 69477MB T op W eldment 1 11 69503M[...]

USSC 23 1 3 2 4 5 6 7 9 10 8 11 2 3 1 6 4 5 K e y Part No. Descritption Qty. 7 83278 #10 Flat Washer 4 8 25465 R etainer , Bottom Glass 1 9 25464 R etainer , T op Glass 1 10 83202 Machine Screw 4 11 891135 Handle, Spring (Parts Bag) 1 K e y Part No. Descritption Qty. 1 25491 Feed Door 1 2 25492 Handle, Door 1 3 83506 Roll Pin, 3/8 x 1-1/4 1 4 88112[...]

24 USSC THIS MANUAL WILL HELP YOU OBTAIN EFFICIENT, DEPEND- ABLE SERVICE FROM YOUR HEARTH FOCUS, AND ENABLE YOU TO ORDER REPAIR PARTS CORRECTLY. KEEP THIS MANUAL IN A SAFE PLACE FOR FUTURE REFER- ENCE. WHEN WRITING, ALWAYS GIVE THE FULL MODEL NUMBER WHICH IS ON THE NAMEPLATE ATTACHED TO THE HEATER. WHEN ORDERING REPAIR PARTS, ALWAYS GIVE THE FOLLOW[...]