AEG 40300 инструкция обслуживания

ÖKO_FAVORIT 40300 Dishwasher User Instructions[...]

2 Dear customer , Please r ead these user instructions carefully . Please observe the safety instructions on the first few pages ofthe se us er i ns tr uc ti on s ! Please keep these u s er i ns tr uc ti on s for later refer ence. P ass them on to any subsequent owner o f th e a pp li an ce . 1 The warning triangle and/or specif ic wor d s ( War n [...]

Contents 3 CONTENTS Operating Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Disposal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Econ[...]

Contents 4 Installation and Connection Instructions . . . . . . . . . . . . . . . . 29 Installing the Dishwasher . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29 Free-Standing Appliances . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29 Connecting the Dishwasher . . . . . . . . . . . . . . [...]

Operating Instructions 5 OPERATING INSTRUCTIONS 1 Safety Instructions The safety aspects of AEG electrical appliances comply with accept ed technical standards and the German Appliance Sa fety Law. Neverthe- less, as a manufacturer we consider it our obligation to make you aware of the following safety information: Installation, Connection and Plac[...]

Operating Instructions 6 • Never place the dishwasher in operation if the mains cable, water inlet or drain hose is damaged; or the control panel, work top or plinth area is damaged such that the inside of the appliance is freely accessible. • If the mains lead is damaged, or is to be replaced for a longer lead, the cable (obtainable from AEG S[...]

Operating Instructions 7 • In the event of a fault, first close the tap, then switch off the appli- ance and unplug it from the mains. If the appliance is permanently wired to the mains: remove the fuse. 2 Disposal Disposing of the Packaging Material Dispose of the dishwasher packaging material correctly. All the packag- ing materials used are ha[...]

Operating Instructions 8 Appliance Features and Control Panel Spray Arms Container for Salt Rating Plate Container for Rinse Aid Container for Detergent Filters Rubber Seal fo r Connecting the Water Feed to the Upper Spray Arm Water Hardness S witch[...]

Operating Instructions 9 Control Panel Set the point at which the wash programme is to start using the pro- gramme switch . The progr amme switch rotates during the wash pro- gramme and indicates the position that has been reached in the programme. Switch on the dishwasher and start a wash programme using the pro- gramme selector . Prior to using f[...]

Operating Instructions 10 Adjust the Water Softener To prevent the build up of scale on dishes and in the dishwasher, the dishes must be washed with soft, i.e. low lime content water. For this reason the dishwasher is fitted with a water softener in which tap water from a hardness of 4 ° d (German degrees) is softened with the aid of special salt.[...]

Operating Instructions 11 Filling with Salt for the Water Softener 1 Use only salt designed for dishwashers. Never fill the salt container with any another type of salt (e.g. culinary salt) or dishwasher deter- gent, as this would irreparably damage the water softener. Prior to filling with salt, please check each time that you really do have a pac[...]

Operating Instructions 12 3 Depending on the size of the salt grains, it can take several hours for the salt to dissolve in the water and the green mark to become visible again. The setting of the water softener and thus the consumption of salt are dependent on the hardness of the local water. Filling with Rinse Aid Rinse aid is automatically added[...]

Operating Instructions 13 4. Fill with rinse aid exactly up to the level marked “ max ” ; this corresponds to a quantity of approx. 140 ml. 5. Close the lid and press until it locks into place. 6. Wipe up any spilt rinse aid with a cloth. Otherwise too much foam will be formed during the wash. Adjusting Rinse Aid Dosing 3 As the dishes are wash[...]

Operating Instructions 14 In Daily Use • Check the salt and rinse aid levels. • Load cutlery and dishes into the dishwasher • Fill with dishwasher detergent • Select a wash programme suitable for the cutlery and dishes • Start the wash programme Loading Cutlery and Dishes 1 Sponges, household cloths and any object that can absorb water sh[...]

Operating Instructions 15 – To avoid damage to glasses, they must not touch – Do not lay small objects (e.g. lids) in the cutlery rack Loading Cutlery 1 Long bladed knives stored in an upright position are a potential haz- ard. 1 Long and/or sharp items of cutlery such as carving knives must be posi- tioned horizontally in the upper bas- ket. 1[...]

Operating Instructions 16 L o a d i n g Pa n s, F r y i n g Pa n s and Lar g e Plates Load lar ge and heavily soiled dishes in the lower r ack. 3 T o ease the loading of large items at so me d ish w a sh er - m o d e ls the two r ows of prongs for the right-hand plate insert can be folded down: 0 1. Slightly lift the right plate insert. 2. Fold the[...]

Operating Instructions 17 Loading Cups , Glasses and Coffee Services Load small, delicate items and long pointed cutlery in the upper rack. • Arr ange items of crockery on the folding cups ra cks so that they ar e offset from each other and water can reach all items. • The cup r acks can be folded up out of the way for tall items. • Lay or ha[...]

Operating Instructions 18 Filling with Detergent 1 Only use dishwasher detergent. Fill with detergent: – Prior to the start of a wash programme (not for the pre wash pro- gramme). The detergent is released into the wash water during the programme. 2 Please observe the manufacturer's dosing and storage recommenda- tions as stated on the deter[...]

Operating Instructions 19 Bio Wash Programmes and Concentrated Detergents Based on their chemical composition, dishwasher detergents can be split into two basic types: – Conventional, alkaline detergents with caustic components – Weak alkaline concentrated detergents with natural enzymes. 2 The use of BIO wash programmes in conj unction with co[...]

Operating Instructions 20 Selecting the Wash Programme (Programme Table) Choose the most suitable wash programme with the aid of this table: 1) The consumption figures were measured unde r standard conditions. They are intende d as a guide only as va riations can occur du ring normal usage. Type of Dishes Dinner Service and Cooking Uten- sils Desse[...]

Operating Instructions 21 Starting the Wash Programme 0 1. Check that when the dishes and cutlery are loaded into the dishwasher the spray arms are free to rotate. 2. Open the tap fully. 3. Close dishwasher door. 4. Turn the programme selector clockwise to A , or B or C (see “ Programme Table “ ). 1 For interference suppression reasons, only op[...]

Operating Instructions 22 Interrupting the wash programme by opening the door of the dish- washer 1 Hot steam may escape when the door is opened. Open the door care- fully. 0 1. Open the door of the dishwasher. The wash programme stops. 2. Shut the door. The wash programme continues. Switching Off the Dishwasher When the wash programme is finished:[...]

Operating Instructions 23 Car e and Cleaning 1 Do not under any cir cumstances use furniture car e products or aggr es- sive cleaners. • If necessary , clean the contr o ls only with a soft cloth and pur e warm water . • The spr ay arms do not need cleaning. • Occasionally check the internal containers, door seal, and water inlet for soiling,[...]

Operating Instructions 24 7. Put the flat filter back in the base of the washing compartment 8. Place the coarse/fine filter in the microfilter and press together. 9. Put the filter combination in place and lock by turning the handle clock- wise to the stop. During this process ensure that the flat filter does not protrude above the base of the was[...]

Operating Instructions 25 ...there are problems with the operation of the dish- washer. ...the wash result is unsatisfactory. The dishes are still dirty. – The wrong wash programme was selected. – The dishes were arranged in such a manner that water has not reached all parts. The dish racks must not be overloaded. – The filter in the base of [...]

Operating Instructions 26 – In the case of scale deposits on the dishes: the special salt container is empty or the water softener is incorrectly adjusted. – The drain hose is incorrectly laid. The dishes are wet and dull. – Rinse aid was not used. – The rinse aid container is empty. There are streaks, milky spots or a bluish coating on gla[...]

Operating Instructions 27 Technical Data ; This appliance conforms with the following EU Directives: – 73/23/EWG dated 19. 02. 1973 – Low Voltage Directive – 89/336/EWG dated 03. 05. 1989 (including Directive Amendment 92/31/EWG) – EMC Directive Capacity: 12 place se ttings in cludin g serving dish es Permitted Wa ter Pressure: 1-10 bar (=1[...]

Operating Instructions 28 Notes for Test Institutes Testing in accordance with EN 60704 must be carried out with the appliance fully loaded and using the test programme (see Programme Table). Tests in accordance with EN 50242 must be carried out when the salt dispenser and rinse aid container have been filled with salt and rinse aid respectively an[...]

Installation and Connectio n Instructions 29 INSTALLATION AND CONNECTION INSTRUCTIONS Installing the Dishwasher • The dishwasher must be installed on a firm floor and adjusted such that it is stable and level. • To compensate for unevenness in the floor and to match the height of the appliance to that of surrounding units extend the threaded fe[...]

Installation and Conn ection Instructio ns 30 • If the dishwasher is installed under- neath a kitchen work surface, the original work surface of the dish- washer is to be removed as follows: – Unscrew the screws (1) from the elbows on the back side. – Slide the work surface approx. 1cm to the rear (3) , lift at the front (4) and remove. – P[...]

Installation and Connectio n Instructions 31 Connecting the Dishwasher Water Connection The dishwasher is fitted with safety devices that prevent the wash water returning into the drinking water system and comply with the applicable plumbing regulations. • The dishwasher can be connected to cold and hot water supplies up to max. 60 ° C. • The [...]

Installation and Conn ection Instructio ns 32 Water drain Drain hose 1 The drain hose must not be kinked, crushed or ent angled. • Connecting th e drain hose: – Maximum permit ted height: 1 metre. – Minimum required height 30 cm above the lower edg e of the machine. Extension hoses • Extension hoses are available from AEG Service Force. The[...]

Installation and Connectio n Instructions 33 Leak Pr evention System For protection from damage due to water leaks, the dishwasher is equipped with a leak pr evention system, the AQUA CONTROL SYSTEM. In the event of a fault, the dr ain pump switches on. By this means water can neither escape nor overflow . The remaining water in the appliance is au[...]

Installation and Conn ection Instructio ns 34 Electrical Connection Any electrical work required to install this appliance should be car- ried out by a qualified electrician or competent person. 1 WARNING - This appliance must be earthed. The manufacturer declines any responsibility should these safety measures not be observed. Before switching on [...]

Installation and Connectio n Instructions 35 Connections The water inlet and drain hoses, as well as the mains cable must be connected beside the dishwasher as there is insufficient space behind the appliance. The plumbing and electrical installation example given below can only be regarded as a recommendation. Two 45 ° or Strai ght Connections, O[...]

Guarantee Conditions 36 GUAR ANTEE CONDITIONS Guarantee Conditions AEG offer the follow ing guarantee to the first purchaser of this appliance. 1. The guarantee is valid for 12 months commencing when the appliance is handed over to the first retail purchaser, which must be verified by purchase invoice or similar doc- umentation. The guarantee does [...]

37[...]

38[...]

Service & Spare parts 39 SERVICE & SPARE PARTS If you wish to purchase spare parts or require an engineer, contact your local AEG Service Force Centre by telephoning: 08705 929 929 Your telephone call will be automatically routed to the Service Centre covering your post code area. When you contact the Service Centre they will need the follo[...]

AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www.aeg.hausgeraete.de © Copyright by AEG 822 945 495 - 00 - 080 1 Subject to change without notice[...]