Baotian BT49QT-12 Tanco инструкция обслуживания

BT49QT -12 T anco – User Manual, Service Schedule & History[...]

Introduction Welco me to you r new BAO TIAN BT 49Q T -12 (T anc o) , wh ich ha s been dev elo ped by BA OTI AN MOTORCYCLE INDUSTRIAL CO. L TD. We hope you enjoy your new Baotian BT49QT -12 (T anco). This owner ’ s handbook contains information necessary: • to enable you to get to know your Baotian BT49QT -12 (T anco) , to use it to the best adv[...]

CONTENTS Guidance............................................................................................................................................................1 Position of parts .................................................................................................................................................3 Controllin[...]

1 1. Pre-riding inspection Please read the details in the relevant chapter for your safety . 2. Helmet Do wear a helmet at all times while riding the motorcycle. 3. Being familiar with motorcycle operation It is of great importance to ensure your safety at all times, especially whilst becoming familiar with your motorcycle . 4. Speed limitation Dri[...]

5. Positions of the numbers When your motorcycle needs to be inspected, repaired or undertake any service, these numbers will assist your Baotian Dealer when servicing your motorcycle. Please note down your numbers here: The frame number: ................................................ The engine number: ...........................................[...]

3 1 Front signal light 2 Left front turning light 3 Head light 4 Rear brake lever 5 Rear-view mirrors 6 Left switches 7 Seat lock 8 Left rear turning light 9 Starting pedal 10 Muffler 1 1 Right rear turning light 12 Rear light 14 Main stand 15 Helmet hook 16 Throttle control lever 17 Meters 18 Light switches 19 Front brake lever 20 Ignition switch [...]

1. Rear brake lever Hold it tight and the rear brake works 2. Switches on the left handle A. Horn button B. T urning signal switch Left turning light right turning light C. Switch for high/low beam lights 3. Meters and indicating lights A. Indicates the speed in Km/h and Mph B. Indicates total distance the motorcycle has run C. Left turning light i[...]

4. Front brake lever Press it tightly and the front brake works. 5. Switches on the right A. Head light switch B. Electric starting button C. Off switch When the ignition switch is at ON position, hold the brake and press the electric starting button and then the engine starts. 6. Ignition switch ON Engine can be started and all the lights can be o[...]

15w/40-15w/50 10w/40 10w/30 -10 0 10 20 30 40 C 20 40 60 80 100 F T 20w/40-20w/50 Fuel tank Usage of the fuel tank lock: 1. T urn the little cap on the fuel cap clockwise. Insert the key and turn the key clockwise and take out the fuel cap. 2. Align the lock tongue on fuel cap with the notch on fuel tank, press the fuel cap and lock it. 6 W arning:[...]

Pre-riding inspection Please check the following parts before you drive. 7 No. Items Inspection content 1 Steering handle bar 1.Flexibility . 2. No gap or loose appearance 2 Brake system 1.T ravel of the front brake and the rear brake. 2. No damage to the cable 2. Flexible function 3 T yres 1. Correct pressure. 2. No splits in rubber 4 Fuel Suffici[...]

Engine starting 1. Please check the volume of engine oil and fuel before starting. The main stand should be stood up while starting the engine. 2. T urn the ignition switch to the “ON” position. 3. Engine Starting Grip the brake lever and press the starter button and then the engine will start. 8 W arning: ◆ Grip the rear brake lever to preve[...]

4. Kick Starting Grip the brake lever , kick the kick start pedal downwards 2 or 3 times in rapid succession. 9 W arning: ◆ After the engine has started, the kick start pedal should be taken back to its original position. Otherwise, it will affect the driver’s safety . ◆ Don’t start the engine in enclosed spaces, as this can create Carbon M[...]

1. Battery • 12V/4Ah battery • When the voltage is less than 1 1.5V , please use kicking start in stead of electric starting. • Place the ignition switch to OFF position before battery replacement. • Electrode identification: “+”-red line, “-“-black line. • Replace the battery every 4 years. 2. Carburetor and idle speed adjustment[...]

4. Spark plug • Clean the carbon deposit on the spark plug with a piece of hard wire or steel needle. • Adjust the gap to 0.6-0.7mm with a feeler gauge. • Use A7RC when replacement is needed. 5. Fuel Always refill with unleaded petrol. T ry to refill before the needle reaches the red zone of the gauge. 6. Engine oil Replace the engine oil wit[...]

7. Brake system Normal free travel of the brake lever is about 2-5mm. 1. The front brake (disk brake) 2. The rear brake (drum brake) T urn the adjusting nut to get a proper travel. Normal free travel of the brake lever is about 10-20mm. _ 12   Disk brake ◆ ◆ Grip the brake lever and check the wear and tear indicator . If the indicator nea[...]

Brake fluid level • It has been filled with the special brake fluid before the motorcycle leaves the factory . Fluid should only ever be replace or filled with DOT4 brake fluid. Never replace or mix other fluids, otherwise it will damage the brake system. • If the brake fluid level is insufficient, it might be possible for air to enter into the[...]

9. Starter motor Check the fastening bolts and the contact brushes, and replace them if necessary . 10. Fuse An inline fuse is located in the live wire from the battery . When a light or circuit fails suddenly , please check the fuse first. 1 1. Gear oil • Please use the recommended gear oil: SAE 5W/90 • T otal capacity: 1 10ml • Replacing ca[...]

T echnical Parameters 15 Size Length 1850mm Width 680mm Height 1 150mm Wheel base 1300mm Weight Unloaded weight 88kg Mass weight 242kg Capacity Max. Speed 45km/h Slope ≥6º Circuit system Spark plug A7RC Battery 12V / 5.7AH Fuse 10A Headlight 12V 35/35W T urning lights 12V 10W Brake light 12V 21W / 5W Indicating lights 12V 5W V olume of the fuel [...]

Engine Model 139QMA T ype 4 stroke Cylinder 1 Bore and stroke 39 x 41.4mm Cylinder volume 49ml Compression ratio 10.5:1 Max. power 2.61 kW / 8000 (r/min) Max. torque 3.56 NM / 5500 (r/min) Carburetor PZ18J Air cleaner Sponge core Ignition type CDI Starting mode Electric / kick start Cooling mode Forced air-cooled Lubrication Pressure spray Suspensi[...]

17[...]

Baotian W arranty In the event of a sudden mechanical or electrical failure please contact your supplying dealer . Y our 24-month warranty covers your scooter/motorcycle in the event of mechanical breakdown or component failure. The first 12 months of cover extends to the entire scooter with the exceptions detailed below . For the second year, warr[...]

19 INITIAL INSPECTION Mileage: Date: Dealer stamp: SER VICE 2 Mileage: Date: Dealer stamp: SER VICE 1 Mileage: Date: Dealer stamp: SER VICE 3 Mileage: Date: Dealer stamp:[...]

20 SER VICE 4 Mileage: Date: Dealer stamp: SER VICE 6 Mileage: Date: Dealer stamp: SER VICE 5 Mileage: Date: Dealer stamp: SER VICE 7 Mileage: Date: Dealer stamp:[...]

21 SER VICE 8 Mileage: Date: Dealer stamp: SER VICE 10 Mileage: Date: Dealer stamp: SER VICE 9 Mileage: Date: Dealer stamp: SER VICE 11 Mileage: Date: Dealer stamp:[...]

22 SER VICE 12 Mileage: Date: Dealer stamp: SER VICE 14 Mileage: Date: Dealer stamp: SER VICE 13 Mileage: Date: Dealer stamp: SER VICE 15 Mileage: Date: Dealer stamp:[...]

23 Maintenance Sc hedule PDI 300 KM 1,000 KM 3,000 KM 6,000 KM 9,000 KM 12,000 KM Every 2 Y ears Engine Oil Replace Replace Replace Replace Replace Replace Gear Oil Replace Replace Replace Oil Strainer Clean Clean Clean Replace Clean Replace Air Filter Clean Clean Replace Clean Replace Battery Charge Inspect Inspect Inspect Inspect Inspect Inspect [...]