Infiniti 9301297-001 инструкция обслуживания

Owner’ s Manual Part # 9301297-001 ® OMEGA[...]

Introduction..............................................................................................................................3 About This Product............................................................................................................. .3 Unpacking .....................................................................[...]

Omega – Owner’ s Manual ◆ 3 I NTRODUCTION Y ou have invested in one of the finest audio/video speakers available. Y our Infinity Omega speaker employs new technology in driver , crossover and cabinet construction, which places it at the forefront of curr ent speaker design. As with any high-quality product, special care must be taken to insta[...]

4 ◆ Omega – Owner’ s Manual A SSOCIA TED C OMPONENTS Y our Infinity Omega speaker is an extraordinary , highly musical system. Like all loudspeakers, it will repr oduce distortion as well as music. For this reason, the choice of associated audio components is critical and should be made with care. If you are r eplacing existing speakers with [...]

Omega – Owner’ s Manual ◆ 5 C ONNECTIONS U SING A S TEREO A MPLIFIER Always turn off the power of your entire system befor e making connections to your speaker . Connect each speaker to your amplifier’ s output terminals using the best wire you can obtain. The choice of speaker connecting wire is extremely important, especially when using s[...]

6 ◆ Omega – Owner’ s Manual Figur e 2. Speaker connection. Using one length of speaker connecting wire, connect the RIGHT speaker to your amplifier’ s (or receiver’ s) RIGHT channel output terminals. Be sure that strands of the wire do not touch the gr ound terminal (and be sure to observe polarity). Even a thin stray wire can cause disto[...]

Omega – Owner’ s Manual ◆ 7 Figur e 3. Connecting the speaker for bi-amp operation. C ONNECTION FOR B I -A MP O PERA TION Y our Infinity Omega speakers permit you to employ two power amplifiers in a bi-amp configuration. One amplifier feeds the woofer (the signal passes through the speaker’ s crossover network to feed the woofer) and the ot[...]

8 ◆ Omega – Owner’ s Manual B I -W IRING Many audiophiles recommend using two connecting wires instead of one because two wires share curr ent through a greater conducting ar ea. If you wish to bi-wire your Omega speaker with a single power amplifier , remove the two shorting straps on the rear of the speaker that separate the woofer and midr[...]

Omega – Owner’ s Manual ◆ 9 P OSITIONING Y OUR S PEAKERS Locating your Omega speakers in the proper position within your listening room is of primary importance if you wish to obtain the best possible perfor- mance from your audio system. Depending on r oom size and acoustics, mov- ing the speakers as little as an inch (2.5cm) forward, rearwa[...]

10 ◆ Omega – Owner’ s Manual Figur e 6. Angling Omega speakers. Figur e 7. Sound is mor e direct when midrange and tweeter r each the listener at ear level. T ilt speaker forwar d to dir ect sound at ear level. P OSITIONING Y OUR S PEAKERS (Continued) The toe-in angle for each speaker should be exactly the same for best sonic results. This ca[...]

Omega – Owner’ s Manual ◆ 11 P OSITIONING Y OUR S PEAKERS (Continued) Room corners are difficult to cope with and you should try to keep the location of the speakers as far away from corners as possible. Corners add low- frequency reinfor cement and can create severe pr oblems in bass frequencies, often accentuating bass response and making i[...]

12 ◆ Omega – Owner’ s Manual R OOM A COUSTICS , S PEAKER P OSITIONING AND T ONAL B ALANCE If you desire a more detailed description of r oom acoustics and speaker place- ment, the following information may prove helpful: • Large ar eas of glass, mirrors and wood paneling will reflect sound waves and may result in harshness and excessive bri[...]

Omega – Owner’ s Manual ◆ 13 R OOM A COUSTICS , S PEAKER P OSITIONING AND T ONAL B ALANCE (Continued) If you are using two separate amplifiers in a bi-amp mode (that are inverting types) to drive your Omega system, the aforementioned modification must be made to the wires connecting both amplifiers to the speakers. If the only inverting compo[...]

14 ◆ Omega – Owner’ s Manual A DJUSTING Y OUR EMIT ™ L EVEL Y our Omega loudspeaker allows the EMIT tweeter to be adjusted to one of three settings (boost, flat, cut). Start with the flat setting and compare to the boost or cut setting. T rust your ears and select the setting that is most pleasur- able for your listening room. A DJUSTING Y [...]

Omega – Owner’ s Manual ◆ 15 A COUSTIC F EEDBACK If, after connecting your system you find the bass response to be boomy (or lacking in tightness and solidity) or if the bass driver cones produce excessive movement, the cause can usually be attributed to acoustic feedback – vibra- tions from the speakers r eaching a tur ntable and tone arm,[...]

Infinity constantly strives to update and improve existing pr oducts, as well as create new ones. Therefore, the specifications and construction details in this and r elated Infinity publications are subject to change without notice. © 1998 Infinity Systems, Inc., 250 Crossways Park Drive, W oodbur y , NY 11797 USA (516) 496-3400 • F AX (516) 68[...]