Magnadyne MARKSMAN X11 инструкция обслуживания

Owner’ s Manual Model: X11 For T echnical Assistance, please call (800) 638-3600, or visit www .magnadyne.com[...]

T able of Contents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Remote Control T ransmitters . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Battery Replacement . . . . . . . . . . . . . . . . . . . . . . . .[...]

3 2-Way LCD Remote 1-Way Backup Remote HOOD TRUNK ARM IGN 2-Way LCD Remote LCD Display Icons Congratulations on your pur chase of a quality Marksman automotive security and remote start system. Marksman security products have been designed to provide the consumer with a technologically superior product with years of trouble free operation. The info[...]

T ransmitter Button System Function Remark Locks Doors & Arms System Arm and Bypass the 2 Stage Shock Sensor (Zone 4) Press Twice within 3 Seconds Silent Arming/Disarming Ignition in “OFF” Position Active Anti-Car Jacking Mode Ignition in “ON” Position, Press and Hold for 2 Seconds - + + - Arm and Bypass the 2nd Sensor (Zone 6) Press wi[...]

5 Flash Function 1 Flash System is Armed 2 Flashes System is Disarmed 3 Flashes Disarmed / T riggered 2 - 3 - 6 Flashes Car Locator Constant On Engine Running Under Remote Start (Default Setting) Chirp Function 1 Chirp System is Armed 2 Chirps System is Disarmed 3 Chirps Defective Sensor of Open Door Reminder 4 Chirps Disarm / Previously T riggered[...]

Siren/Horn Parking Light LED Doors Starter Dome Light 1. Arming 1 or 3 Chirps 1 Flash Slow Flash Locking Disabled 2. Disarming 2 to 4 Chirps 2 or 3 Flashes Unlocking T urns on for 30 Seconds 3. T rigger Alarming Flashing Pause Flash Disabled Flashes 4. Panic Alarming Flashing Flashes 5. Car Jacking Alarming Flashing Disabled Flashes LED Function OF[...]

If the siren sounds 3 times, there is a Door , T runk, or Hood left open. Pressing the transmitter and button at the same time will arm or disarm your security system, No chirp sound will be heard, arm/disarm confirmation will be through the vehicles parking lights only . Press the button on the transmitter two times within 3 seconds. This will arm[...]

System Disarmed Door T riggered T runk/Hood T riggered HOOD TRUNK IGN Shock Sensor T riggered Ignition T riggered (Additional programming required) The vehicle doors will automatically lock after the automatic arming cycle has been completed. While the system is in disarmed mode, press the button twice. The horn/siren will respond with one chirp an[...]

(Additional Wiring Required) This feature will independently unlock the drivers door only when disarming the security system. Pushing the button a second time within 3 seconds will unlock the other doors. (Must be Programmed On) If this feature is selected, the security system will automatically rearm itself within 60 seconds after disarming with t[...]

Note: The remote vehicle location system is active 30 seconds after the alarm is armed. 1. Press the button to active the vehicle locator system. The horn/siren will beep 2 times and the parking lights will flash 3 times. This operation will repeat a second time. 2. Press the button again within 30 seconds. The horn/siren will beep 3 times and the [...]

When the Security System is triggered, it will alert the user with flashing icons on the LCD Display and audible melody sound. T o stop the melody sound, press any button on the LCD transmitter . When the Security System is triggered, the LCD screen will alert the user through melody sound and flashing icons. By pressing the “SET” button 3 time[...]

Three Timer cir cuits will function as follows: First Timer Circuit 1. 50 seconds after the car jacking mode has been activated, the siren will begin to sound for 15 seconds. 2. During the 15 second activation period, you will be alerted to push the valet switch once to turn off the car jacking feature. 3. If by now the valet switch has not been pu[...]

It is useful in the event that someone wants to page the driver of the parked vehicle. (Optional) With the ignition switch in the "OFF" position, press the valet switch for 2 seconds to page the driver . One chirp will sound from the vehicle and the LCD transmitter will begin to sound with a melody . The icon will then appear on the LCD t[...]

Press and hold the and button at the same time to activate the Channel 5 output. Press and hold the and button at the same time to activate the Channel 6 output. Press and hold the and button at the same time to activate the Channel 7 output. No te: If Channel 7 has been programmed for defrost operation it will not function from the transmitter . C[...]

1. Press the button twice on the remote transmitter . 2. The parking lights will turn “ON” to indicate the remote start command has been received. 3. The engine will start in approximately 5 seconds. 4. Once the engine is running, the parking lights will turn back on to indicate climate controls are activated to your presettings (While the vehi[...]

16 This feature allows the vehicle to remain running after the key has been removed from the ignition. This feature is useful for occasions when you wish to exit and lock/arm the vehicle for short periods of time. This will keep the engine running for climate controls to stay on. 1. Before turning the engine off with the ignition key , press the bu[...]

Note: The transmission range may become shorter if the system is inter fered by a stronger radio frequency from sources of high voltage electric power or obstacles like tall buildings. The transmitter uses low output powered frequency . T urbo Timer Mode keeps the engine running after arriving at you destination for a programmable time period of 3,[...]

18 Remote LCD Icons Armed Mode Vehicle is in armed mode Car Jack Mode Car jacking mode is activated Hood T rigger Hood is illegally opened (Zone 1) T runk T rigger T runk is illegally opened (Zone 2) System T rigger Time Monitor Melody Mode Remote control alert user through melody sound Channel #6 is Activated Channel #7 is Activated Channel #5 is [...]

Button Description Operation SET LCD Screen Lamp T urns ON for Press and Hold for 1 Second Five Seconds 1 Melody Sounds to Confirm SET Timer Programming Mode Press and Hold for 3 Seconds 2 Melody Sounds to Confirm SET Power Save Mode Press and Hold for 5 Seconds 1 Melody Sounds to Confirm SET (3X) Clear the Flash Icon and Melody Sound Press within [...]

20 While triggering the alarm, the LCD screen will alert the user through melody sound and flashing trigger icon. Press any button on the transmitter to stop melody sound only . Use this mode to disable the transmission function of the remote control temporarily to prevent any inadvertent pressing of buttons. 1. Press the “SET” button first, wi[...]

Step Button Description Operation 1 Press and Hold SET Button for 3 Seconds Time Setting (Hour) Flash Digit for Adjusting for (-) and (+) 2 Press the SET Button Once Time Setting (Min.) Flash Digit for Adjusting for (-) and (+) 3 Press the SET Button Once Alert Alarm Time Setting (Hour) Flash Digit for Adjusting for (-) and (+) 4 Press the SET Butt[...]

Replacement Parts 4-Button Transmitter for X11 Security System X1 1 RF 59.95 ea. 5-Button Transmitter for X11 Security System X1 1R F- LC D $139.95 ea. TRANSMITTERS DESCRIPTION MODEL # PRICE BATTERIES **1.5 Volt AAA Lithium Battery Highly Recommended *1.5 Volt AAA High Capacity Digital Camera Battery Suggested 1.5 Volt AAA Alkaline Battery Minimum [...]

Parts Order Form Credit Card or Money Order Only (Sorry No Cash, C.O.D. or personal checks accepted) SHIP TO: (No P .O. Boxes) LAST NAME FIRST NAME INITIAL STREET ADDRESS ADDITIONAL ADDRESS ADDITIONAL ADDRESS CITY ST A TE ZIP CODE DA Y TIME PHONE NUMBER PA R T # DESCRIPTION QTY . PRICE EACH TOT AL Sales Subtotal = ________ . ______ California Resid[...]

X11-UM 3-5-08 Rev. A © Copyright 2008 Magnadyne Corporation Limited Lifetime W arranty Magnadyne Corporation or its authorized agents will, for the life of the vehicle and to the original pur chaser , repair , replace or refund the retail sales price of said product or any part thereof, at the option of the Magnadyne Corporation or its authorized [...]