Majestic Appliances HE32EF инструкция обслуживания

- 1 - INSTALLER: DO NOT DISCARD THIS MANUAL - LEAVE FOR HOMEOWNER 10003395 07/01 Rev.0 Electric Fireplace Model HE32EF WARNING! IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED EXACTLY, AN ELECTRICAL SHOCK OR FIRE MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. Installation Instructions & Homeowner's Manual 410 Admira[...]

- 2 - T ABLE OF CONTENTS Please read the Installation & Operating Instructions before using this appliance. Thank you and congratulations on your purchase of a Vermont Castings Majestic Products Company fireplace. IMPORTANT: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may resul[...]

- 3 - LOCATING YOUR VERMONT CASTINGS MAJESTIC PRODUCTS COMPANY ELECTRIC FIREPLACE INST ALLA TION INSTRUCTIONS 15. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked. 16. This appliance has hot and arcing or sparking parts inside. Do not use it in [...]

- 4 - M I N I M U M O P E N I N G Fig. 1 1= SS or SSD Trim 2= SL or SLD Trim 3= SXL Trim 4= BSL Trim 5= BXL Trim HE32EF T R I M A1 26 5/8" 676 mm B1 38 3/8" 975 mm A2 29" 737 mm B2 41 15/16" 1065 mm A3 33" 838 mm B3 44" 1118 mm A4 28" 712 mm B4 40 7/8" 1041 mm A5 30 1/2" 775 mm B5 46" 1171 mm C 28 3[...]

- 5 - CLEARANCE TO COMBUSTIBLES Non-combustible materials such as brick and tile can be extended over the face of the unit (Do not cover louvres or glass door) . If a Trim Kit is going to be installed, brick and tile will have to be installed flush with the side of this appliance. FINAL FINISHING Cold climate installation recommendation: When insta[...]

- 6 - Fig. 4 Electrical outlet wiring must comply with local building codes and other applicable regulations to reduce the risk of fire, electrical shock and injury to persons. ELECTRICAL CONNECTION A 15 AMP, 120 Volt, 60 Hz circuit with a properly grounded outlet is required. Preferably, the fireplace will be on a dedicated circuit as other applia[...]

- 7 - LOUVRE REMOVAL SER VICE INSTRUCTIONS To remove top louvre pull louvre up and then lift out. See Figure 5. Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electrical shock or personal injury. GLASS INFORMATION 1. Under no circumstances should this product be operated with missing or broken glass. 2. D[...]

- 8 - MAINTENANCE OF MOT ORS The motors used on the fan and the drum assembly are prelubricated for extended bearing life and require no further lubrication. However, periodic cleaning/vacuuming of the fan/heater is recommended. Make sure that the power is turned off before proceeding. CLEANING BRASS TRIM Clean the brass trim using a soft cloth, sl[...]

- 9 - OPERA TING INSTRUCTIONS 1. MAIN ON/OFF SWITCH The On/Off switch supplies power to all of the functions of the fireplace. This is an illuminated switch which normally will light up when in the " On/Off " position. The control compartment is located behind the lower louvre panel. To access the controls, simply flip down the lower louv[...]

- 10 - REPLACEMENT P ARTS - ELECTRIC FIREPLACE #2 COMPLETE LOG SET 2 3 4 / 5 7 6 8 9 17 15 18 19 21 22 20 14 13 305mm [12"] 216mm [8 1/2"] (DISTANCE BETWEEN TWO SOCKETS} 216mm [8 1/2"] (DISTANCE BETWEEN TWO SOCKETS) 23 HE32EF #1 COMPLETE LOG SET[...]

- 11 - REPLACEMENT P ARTS LIST - ELECTRIC FIREPLACE D ESCRIPTION HE32EF 1. Log Set Complete 10003628 1a. Log Top Left N/A 1b. Log Top Right N/A 1c. Log Bottom N/A 2. Fan/Heater Assembly w/Bracket 10001815 3. Motor 12VDC (Flame generator) 10001978 4. Switch Rocker 53606 5. On/Off Switch (Illuminated) 10001393 6. Thermostat - Heater Control 10001971 [...]

- 12 - INSTALLATION WARNING: UNPLUG OR TURN THE POWER TO THE APPLIANCE OFF PRIOR TO BEGIN- NING THE INSTALLATION. IT IS NOT ACCEPTABLE TO USE THE “ON/OFF” SWITCH TO MEET THIS REQUIREMENT. 1. Turn the power to the appliance off, or unplug it from the power supply. 2. Let fireplace cool if it has been operating. 3. Remove access panel radiance by[...]

- 13 - FRAME ASSEMBLY 1. Lay Trim Top Facing and Trim Side Facings, face down on to an even surface such as a table or floor. Be sure not to scratch the painted surfaces. 2. Install the nuts and bolts (Fig. 8). Fig. 8 1) RHESS, RHESL, RHESSD, RHESLD & RHESXL TRIMS RHESS, RHESL, RHESSD, RHESLD and RHESXL TRIM SIDE CHANNEL TRIM SIDE CHANNEL TRIM [...]

- 14 - 1. Fit Decorative Frame to the fireplace and fasten (Fig. 12) Plastic on the trim must be removed before mounting onto the fireplace. Glass must be tightly pressed against the front of the frame in order to prevent screws from damaging glass edges. Fig. 12 AS SHOWN FROM FRONT SCREWS FRAME MOUNTING GENERAL INFORMATION The Decorative Front Fra[...]

- 15 - KEY DESCRIPTION RHESS (2) RHESL (3) RHESSD (3) RHESLD (3) RHESXL (4) 1 Trim Frame Top, Flat Black 57929 57932 57929 57932 57935 2 Trim Frame Left, Flat Black 57927 57930 57927 57930 57933 3 Trim Frame Right, Flat Black 57928 57931 57928 57931 57934 4 Trim Top Deflector (1) 17634 17634 17634 17634 17634 5 Trim Top Channel (1) 50586 50587 1761[...]

- 16 - TRIM ASSEMBLY 1. Install trim channels (left and right sides). Use two screws to assemble each piece. 2. Slide on the trim top channel and fasten it from the back side. 3. Install the trim top deflector and use two screws to fasten it. (Fig. 13) 4. Remove ALL plastic protective covering from brass trim. RHEBSL Side View T rim Frame T op Sect[...]

- 17 - 3) RHEF A and RHEFP TRIMS Glass Frame Louvre Note: Position brass trim top as shown (small end up) to prevent heat discolouration Fig. 14 Fig. 15 1. Remove the front glass (see "Glass Frame Re- moval" section). 2. Install support window trim channel, top and bottom brass trim by using the shortest black screw. (Fig. 14 & 15). T[...]

- 18 - 4) HEBTKP , HESBTKP , HECBTK, HECBTKMB & HEBT A TRIMS HECBTK - Cast bay window and grills in classic black trim kit HECBKMB - Cast bay window and grills in midnight black porcelain enamel trim kit HESBTKP - Steel bay window with polished brass and cast grills in classic black trim kit HEBTKP - Steel bay window and bay louvres with polish[...]

- 19 - HEBTKP Trim Assembly 1) Install the hanging brackets, as per Fig. 20 2) Install bracket on each side of the cabinet as per Fig. 24. 3) Install the two ceramic pieces inside the bay window, as per Fig. 19. 4) Install the bay window by hanging it onto the lower tabs of the hanging brackets, as per Fig. 21. 5) Install top louvre by engaging the[...]

- 20 - KEY DESCRIPTION HECBTK HECBTKMB HESBTKP HEBTKP HEBTA 1 Trim Window Top/Bottom (1) - - 55188-PB 55188-PB 55188-AB 2 Plate Decorative Bottom - - - 52828-PB 52828-AB 3 Top Louvre (Grill) Assembly 1301199 1341199 1301199 57945 - 4 Bottom Louvre (Grill) Assembly - - - 57947 - 5 Control Door 1301200 1341200 1301200 57946 - 6 Bottom Louvre Left 130[...]

- 21 - 5) CAST TRIM OPTIONS CAST SURROUND AND FLAT FACE HECBL Cast Surround Black HECBLUE Cast Surround Blue HECCG Cast Surround Charcoal Grey HECGR Cast Surround Green CSSP Polished Brass Small Trim for Cast Surround CSLP Polished Brass Large Trim for Cast Surround (to be used with CSSP) ACCESSORIES OPTIONS DESCRIPTION • Remote Control • Optio[...]