Pacific Digital Upright Vacuum Cleaner инструкция обслуживания

My V ac ™ Commer cial Upright V acuum Cleaner Review this manual befor e operating cleaner Operating Instructions ENGLISH ➜ pp.1-13 ESP AÑOL ➜ pág 14-20 FRANÇAIS ➜ p. 21-27 Index Assembling Cleaner ..........................2-5 Cleaner Descriptions ............................6 How T o Use Cleaning T ools ................................[...]

Place upper (B) and lower (C) handle sections on a flat sur- face with cord hooks (A) on top. With hands on sides of han - dle sections, push handle sections together firmly until they “click” into place. *Do not press against the rod (D) extending from the lower handle. If the rod breaks or bends, the cleaner will not work properly . Do not pu[...]

UP 3 D Step 2 Attach cor d Note: The small red tab (E) above the ON/OFF switch (F) is for shipping purposes only and may fall off during assembly . If it does not fall off, the tab will be removed during the final steps of assembly . T urn handle over . Inser t large rectangular end of cor d into pocket in bottom of handle, with side marked “UP?[...]

Break off red tab (E) above ON/OFF switch (F) by pushing down on tab. Discard tab. Note: If tab has come off during assembly , make sure switch is in the OFF position (down) before plugging cord into an electrical outlet. Hold filter bag collar (U) as shown. Align opening in filter bag with dirt tube (V) inside the outer bag. Push bag collar firmly[...]

Place furniture nozzle (BB) on lip on lower part of rack and snap into place. Position dusting brush (AA) into rack as shown. With smaller end toward bottom, snap wand (Z) into clips on rack. 5 Slide rack down handle until upper hooks (X) snap into slots (Y) on han- dle. Place round end of hose over r ound extension on bottom of rack. Press hose fi[...]

The assembled cleaner will look like the drawing. 1. Handle 2. Cord hooks: wrap cord around hooks for storage. The top hook can be rotated right or left for easy cord release. 3. Bag Cap 4. ON/OFF switch: located on side of handle 5. Outer bag 6. Stair cleaning handle: located on lower edge of bag. 7. Handle release lever: step on lever to lower ha[...]

For maximum cleaning perfor- mance, the following carpet height settings are r ecommended. Cleaners with T wo Settings: • Setting 1 (A): for bare floors and all carpet types. • Setting 2 (B): if easier pushing effort is desired while maintaining good cleaning perfor mance. Cleaners with Four Settings: • Lowest setting (1): for bare floors and[...]

8 T ool set includes a hose, wand, crevice tool, furniture nozzle and dusting brush. Attach hose to cleaner T urn cleaner off before attaching or removing hose. With cleaner handle in upright posi- tion, open hose door and insert hose connector until locked in posi- tion. Suction will automatically be diverted to the hose when cleaner is turned on.[...]

9 How to replace Disconnect cleaner from electrical outlet. T o change filter bag, unzip outer bag, grasp sides of filter bag collar (A) and pull collar from tube. Note: Do not clean out old filter bag and reuse. Discar d used filter bag. Clearing blockages T o check for obstructions, first turn cleaner off and disconnect from electrical outlet; th[...]

10 Place the three tabs on bottom plate into slots in front of cleaner body . Snap bottom plate into place over agitator . Slip agitator through new belt (with lettering toward outside of clean- er) and position belt in belt guide (D). Push end of belt into opening in cleaner body . Reposition agitator making sure to align flat sides of projection [...]

Replace hood and nozzle control knob. Stretch new belt onto motor pulley (G). Extra effort may be required to stretch belt onto pulley . T urn agitator , making sure belt is not pinched between agitator and cleaner body . The belt must r otate freely inside the belt guide. If the agitator does not turn, remove bot- tom plate and reposition belt in [...]

Ser vicing of double- insulated appliances This vacuum cleaner is double insulat- ed. In a double insulated appliance, two systems of insulation are pr ovided instead of grounding. No gr ounding means is provided on a double-insulat- ed appliance, nor should a means for grounding be added. Servicing a dou- ble-insulated appliance requir es extreme [...]

13[...]