Wharfedale Pro EZ-M 10X2 инструкция обслуживания

EZ-m mini-mixer 1 0 x2 OWNER’S MANUAL[...]

Table of Contents Page 1 Introduction / Features / Back Panel diagram 2 Important Safety & Warranty Information 3 Detailed Features of the EZ-m 10x2 – Mic/Line Input Channel 4 Mono Mic/Line Channel - Low Impedance (Low Z) MIC Input - LINE IN - GAIN Control - CLIP LED 5 - Mono Channel EQ Section - Mono Channel PAN and LEVEL 6 Stereo Channel In[...]

I n t rodu c t i on T han k y ou f o r pu rc ha s i ng a W ha r f ed a l e Pr o E Z - m m i n i - m i xer . T he W ha r f ed a l e Pr o E Z -m S e r i e s m i x e r s a r e de s i gned f o r ea s e o f u s e and qua li t y aud i o pe r f o r m an c e . P l ea s e r ead t h i s m anua l c o m p l e t e l y t o en s u r e p r ope r unde r s t and i n[...]

Important Safety & Warranty Information 1. Power Supply This EZ-m Series mini-mix er is supplie d with an external power supply unit. Use only the power supply provided with your mixer. Use of any ot her power sup ply co uld cause damage to the mixer and other equipment. Connect the po wer su pply to the mixer BEFORE connecting it to the power [...]

DETAILED FEATURES OF THE EZ-m 10x2 Mono Mic / Line Input Channel 3[...]

Low Impedance (Low Z) MIC Input The low noise, high headroom “Low Z” MIC input is for use with balanced, low impedan ce dynamic micropho nes. NOTE: Condenser microphones will not work on this mixer. LINE IN This ¼” Tip, Ring, Sleeve (TRS) jack is desi gned to be connected with (-1 0 to +4d Bu) balanced or unbalan ced line level sources. GAIN[...]

EQ Section Channel 1 on the EZ-m 10x2 mixer features a two band Equalization (” EQ ”) section. Each band is chosen from the prim e frequencies for most musical applications, and allows up to 15 decibels of boost (in crease) or cut (decrea se ) of the signal in the tone range for which it controls. The HIGH EQ control is centered at 12kHz and th[...]

Stereo Channel Inputs Each of the stereo channel s on the EZ-m 10x2 ( 2/3 and 4/5 ) feature two line level inputs with ¼” Tip/Ring/Sleeve (TRS) jacks for both balanced and unbalanced left and right input signal s. These inputs can accomm odate both stereo and mono inputs. When using a mono so urce, connect the cable to the LEFT (MONO) input only[...]

Master Section The master section on the right side of the mixer controls the final gain stage of the mixed signals from the input channels. The MAIN MIX control allows for the adjustment of the overall output level of the EZ-m mixer. POWER LED & Signal Metering POWER LED This amber LED lights indicating p ower is on for the mixer. Level Meters[...]

2TK IN This section consists of two sets of three input jacks. The top rows of jacks are the “ 2TK IN ” input, which includes a 1/8” stereo ja ck and left and right RCA jacks. These inputs a llow for an external stereo signal into the mixer. This signal is controlled by the 2TK IN volume control and the 2TK TO PHONES switch as well as the 2TK[...]

16 16 POWER Switch – On/Off This slide switch turns the unit on and off. Always power down the EZ-m when it is not in use. Be sure to turn off all syst em amplifiers or powered speakers before turning off the mixer. 17 AC Power Cable Conn ector The included power adapto r con ne cts here. Use only the power adaptor supplied with the mixer. 17 CON[...]

SPECIFICATIONS EZ-m mini-mixer 10X2 Specifications Maximum Output Level (1%T.H.D. @ 1kHz) +22dBu over 130mw (h ead phone) @ 32 ohms THD+N% <0.01% @ +15dBu Frequency Response 20Hz-20kHz +0/-1dB Hum and Noise -127dB Mic Pre Equivalent Input Noise '-90dBu Residual Noise Maximum Input Levels Mic In: '+10dBu Line In: '+20dBu 2TK In: &a[...]

B L O CK D I A G R A M 1 1[...]

Wharfedale International LTD. IAG HOUSE Sovereign Court, Ermine Business Park, Huntingdon, Cambs, PE29 6XU, England www.wharfe alepro.com IAG Professional reserves the right to a improve specifications wi thout notice. All rights reserved © harfedale Pro Wharfedale Pro is a member o onal Audio Group d lte r or 2007 W f the Internati[...]