Zanussi ZFU20200WA инструкция обслуживания

EN User manual Freezer ZFU20200WA[...]

Contents Safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Product des cription _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ 7 Care and cleaning _ _ _ _ _ _ _ _ _ _ _[...]

During transportation and installation of the appliance, be certain that none of the com- ponents of the refr igerant circuit become damaged. If the refrigerant cir cuit should become dam- aged: – avoid open flames and sources of ignition – thoroughly ventilate the room in which the appliance is situated • It is dangerous to alter the specifi[...]

• It is advisable to wait at least four hours be- fore connecting the appliance to allow the oil to flow back in the compressor. • Adequate air circulation should be around the appliance, lacking this leads to overheat- ing. To achieve sufficient ventilation follow the instructions relevant to installation. • Wherever possible the back of the[...]

3 Freezer baskets 4 Rating plate 5 Maxibox baskets Control panel 1 2 3 4 5 1 Alarm Light 2 Fast Freeze Indicator 3 Fast Freeze Switch 4 Pilot Light 5 Temperature Regulator Switching on Insert the plug into the wall socket. Turn the Temperature regulator clockw ise to a medium setting. The Pilot light and the Alarm light will light up. Switching off[...]

Storage of frozen food When first starting-up or after a period out of use, before putting the products in the com- partment let the appliance run at least 2 hours. The freezer drawers ensure that it is quick and easy to find the food package you want. If large quantities of food are to be stored, remove all drawers except for the bottom dr awer wh[...]

Helpful hints and tips Normal Operating Sounds • You may hear a faint gurgling and a bubbling sound when the r efrigerant is pumped through the coils or tubi ng. This is correct. • When the compressor is on, the refrigerant is being pumped around and you will hear a whirring sound and a pulsating noise from the compressor. This is correct. • [...]

• clean the inside and accessories with luke- warm water and some neutral soap. • regularly check the door seals and wipe clean to ensure they are clean and free from debris. • rinse and dry thoroughly. Important! Do not pull, move or damage any pipes and/or cables ins ide the cabinet. Never use detergents, abrasive powders, highly perfumed c[...]

Problem Possible cause Solution The product temperat ure is too high. Let the produc t temperature de- crease to room temperat ure before storage. The room temp erature is too hi gh. Decrease the room temperature. The temperature i n the freezer is too low. The temperature regula tor is not set correctly. Set a higher temperat ure. The Fast Freeze [...]

Positioning Install this appliance at a location where the ambient temperature corresponds to the cli- mate class indicated on the rating plate of the appliance: Climate class Ambient tem perature SN +10°C to + 32°C N +16°C to + 32°C ST +16°C to + 38°C T +16°C to + 43°C Location The appliance should be installed well away from sources of he[...]

3. Connect the wire coloured brow n to the terminal either marked with the “L“ or col- oured red. 4. Check that no cut, or stray strands of wire is present and the cor d clamp E is secure over the outer sheath. 5. Make sure the electricity supply voltage is the same as that indicated on the appli- ance rating plate. 6. Switch on the appliance. [...]

2 1 • Stand the appliance upright. • Unscrew the handle (1) and fix it on the op- posite side (2). • Re-insert the cover pins (3) on the opposite side. 3 1 2 Do a final check to make sure that: • All screws are tightened. • The edges of the doors run parallel to the side edge of the appliance. • The magnetic seal adheres to the cabinet.[...]

13 www.zanussi.com[...]

14 www.zanussi.com[...]

15 www.zanussi.com[...]

www.zanussi.com/shop 280151036-A-492012[...]