AEG 60800 Bedienungsanleitung

ÖKO_FAVORIT 60800 Dishwasher User Instructions[...]

2 Dear customer, Please read these user instructions carefully. Please observe the safety instructions on the first few pages of the se us er i ns tr uc ti on s! Ple ase keep these us er i ns tr uc ti on s for later reference. Pass them on to any subsequent owner of th e ap pl i an ce . 1 The warning triangle and/or specif ic words ( War n i n g! ,[...]

Contents 3 CONTENTS Operating Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Disposal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Econ[...]

Contents 4 Technical Data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32 Notes for Test Institutes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 33 Installation and Connection Instructions . . . . . . . . . . . . . . . . 34 Installing the Dishwasher . . . . . . . [...]

Operating Instructions 5 OPERATING INSTRUCTIONS 1 Safety Instructions The safety aspects of AEG electrical appliances comply with accepted technical standards and the German Appliance Sa fety Law. Neverthe- less, as a manufacturer we consider it our obligation to make you aware of the following safety information: Installation, Connection an d Plac[...]

Operating Instructions 6 • Never place the dishwasher in ope ration if the mains cable, water inlet or drain hose is damaged; or the control panel, work top or plinth area is damaged such that the inside of the appliance is freely accessible. • If the mains lead is damaged, or is to be replaced for a longer lead, the cable (obtainable from AEG [...]

Operating Instructions 7 • In the event of a fault, first close the tap, then switch off the appli- ance and unplug it from the mains. If the appliance is permanently wired to the mains: remove the fuse. 2 Disposal Disposing of the Pa ckaging Material Dispose of the dishwasher packaging material correctly. All the packag- ing materials used are h[...]

Operating Instructions 8 2 Economical and Ecological Dishwashing • Ensure that the water soften er is correctly adjusted. • Do not pre-rinse dishes under running water. • W hen you wash a small load, the lo ad sensor calculates the amount of water necessary and shortens the programme. It is more economi- cal to always wash with a full load. ?[...]

Operating Instructions 9 Appliance Features and Control Panel Top Spray Arm Inlet for Fan Assisted Drying Container for Salt Rating Plate Container for Rinse Aid Filters Rubber Seal fo r Connecting the Water Feed to the Middle Spray Arm Spray Arms Container for Detergent[...]

Operating Instructions 10 Control Panel The Control Panel comprises the ON/OFF switch and the programme buttons with LED indicators. Softener and Functi on Button: in addition to the wash programme marked, it is also possible to adju st the dishwasher's water soften er using the combination of these buttons. The Mult i-Displa y can display, ?[...]

Operating Instructions 11 Prior to using for the first time Prior to using for the first time, remo ve all the clips with wh ich the dish racks are secured for transport. Then perform the following steps: 0 1. Adjust the water softener 2. Fill with Salt for the Water Softener 3. Fill with Rinse Aid Adjust the Water Softener To avoid the scale depos[...]

Operating Instructions 12 0 1. The dishwasher must be switched off. 2. Press the function and water softener buttons simultaneously and keep them pressed 3. In addition press the ON/OFF switch. The LED indicators for the function and water softener buttons flash. 4. Press the softener button again. The multi-display indicates the hardness setting .[...]

Operating Instructions 13 Filling with Salt fo r the Water Softener 1 Use only special salt for dishwashers. Never fill the salt container with any another type of salt (e.g. culinar y salt) or dishwasher detergent, as this would irreparably damage the water softener. Prior to filling with salt, please chec k each time that you really do have a pac[...]

Operating Instructions 14 Filling with Rinse Aid Rinse aid is automatically added duri ng the last rinse, ensuring thor- ough rinsing, spot and streak free drying. 1 Only use rinse aid specifically designed for domestic dishwashers. Never fill the rinse aid container with any other substance as this would dam- age the appliance. Fill with rinse aid[...]

Operating Instructions 15 Adjusting Rinse Aid Dosing 3 As the dishes are washed rinse aid is released from the dispenser into the wash water. The dose is factory set at 4, and can be adjusted fro m 1 to 6. Only change the setting if streaks, milky spots or dried on water marks are visible on glasse s or crockery. 0 1. Open the door of the dishwashe[...]

Operating Instructions 16 Loading Cutlery and Dishes 1 Sponges, household cloths and any obj ect that can absorb water should not be washed in the dishwasher . • Be fore loading the dishes, you should: – Remove all scraps of food. – Soften remnants of burnt food in pans. • W hen loading the dishes and cutlery, please note: – Dishes and cu[...]

Operating Instructions 17 Loading Cutlery 1 Long bladed knives stored in an up right position are a potential hazard. 1 Long and/or sharp items of cutlery su ch as carving knives must be posi- tioned horizontally in the upper basket. 1 Take care when loading or unload ing sharp items such as knives. Place knives, sma ll spoons and small forks in th[...]

Operating Instructions 18 I f you use the grid insert, it is not possible to open the cutlery basket. 1 To ensure that the cutlery basket cannot open on removal from the appliance, you should al ways hold both parts of the two part handle. 0 1. Place the cutlery basket on a table or work surface 2. Open the two part handle 3. Remove cutlery 4. Clos[...]

Operating Instructions 19 Loading Pans, Frying Pans and Large Plates Load large and heavily soiled dishes in the lower rack. 3 To ease the loading of large items at some dish washer-m odels the two rows of prongs for the right-hand plate insert can be folded down: 0 1. Slightly lift the right plate insert. 2. Fold the plate insert to the left.[...]

Operating Instructions 20 Loading Cups, Glasses and Coffee Services Load small, delicate items and long pointed cutlery in the upper rack. • A rrange items of crockery on the folding cups racks so that they are offset from each other and water can reach all items. • T he cup racks can be folded up out of the way for tall items. • L ay or hang[...]

Operating Instructions 21 Adjusting the Height of the Upper Basket 3 The height of the basket can also be adjusted when it is loaded. Depending on the model, your applia nce is provided with one of the following types of upper basket: Lowering the Upper Basket: Type 1 0 1. Pull the upper basket out completely. 2. Lift the upper basket at the rear r[...]

Operating Instructions 22 Filling with Detergent 1 Only use dishwasher detergent. Fill with detergent: – Prior to the start of a wash programme (not for the pre wash pro- gramme). The detergent is released into the wash water during the programme. 2 Please observe the manufacturer's dosing and storage recommenda- tions as stated on th e dete[...]

Operating Instructions 23 Bio Wash Programmes and Co ncentrated Detergents Based on their chemical compositio n, dishwasher detergents can be split into two basic types: – Co nventional, alkaline detergents with caustic components – W eak alkaline concentrated dete rgents with natu ral enzymes. 2 The use of BIO wash programmes in conj unction w[...]

Operating Instructions 24 Selecting the Wash Progr amme (Programme Table) Choose the most suitable wash program me with the aid of this table: 1) 1) In addition to the wash programme s listed in this table, there is a special programme: PRE WASH . Using this programme you can pre wash used dishes that are being collected in the dishwasher and for w[...]

Operating Instructions 25 Start the Wash Programme 0 1. Check that when the dishes and cutl ery are loaded into the dishwasher the spray arms are free to rotate. 2. Open the tap fully. 3. Shut the door. 4. Press the ON/OFF button. The ON/OFF button indicator illuminates. 5. Press the programme button for the desired programme (see "Pro- gramme[...]

Operating Instructions 26 Interrupting the wash programme by opening the door of the dishwasher 1 Hot steam may escape from the appliance when opening the door. Open the door carefully. 0 1. Open the door of the dishwasher. The wash programme stops. 2. The indicator for the programme that is currently running extinguishes. 3. Close the door. The wa[...]

Operating Instructions 27 Load Sensing – Sensor Logic If a wash programme is started even though there are only a few dishes in the upper and/or lower rack, an in telligent electronic system adjusts the amount of water and the durati on of the wash programme to the number of dishes. By this means it is possible to wash only a few dishes quickly a[...]

Operating Instructions 28 Care and Cleaning 1 Do not under any circumstances use fu rniture care pro ducts or aggres- sive cleaners. • If necessary, clean the controls only with a soft cloth and pure warm water. • T he spray arms do not n eed cleaning. • Occasionally check the internal cont ainers, door seal, and water inlet for soiling, clea[...]

Operating Instructions 29 7. Put the flat filter back in the base of the washing compartment 8. Place the coarse/fine filter in the microfilter and press together. 9. Put the filter combination in place and lock by turning the handle clock- wise to the stop. During this process ensure that the flat filter does not protrude above the base of the was[...]

Operating Instructions 30 ...Error messages • If fault code (2 is displayed on the multi-display or the WATER indi- cator is illuminated, you can pr obably rect ify the fault you rself. After rectifying a (2 fault and a fault related to the WATER indica- tor, press the button for the wash programme that has been started. The wash programme contin[...]

Operating Instructions 31 ...there are problems with th e operation of the dish- washer. ...the wash results are n ot satisfactory. The dishes are still dirty. – T he wrong wash programme was selected. – T he dishes were loaded is such a way that t he wash waster did not reach all items. The racks for the dishes must not be overloaded. – T he[...]

Operating Instructions 32 There are streaks, milky spots or a bluish coating on glasses and dishes. – L ower rinse aid dosing. There are dried water drops on the glasses and dishes. – Increase rinse aid dosing. – T he detergent may be the cause. Contact the detergent manuf ac- turer’s customer advisor. Technical Data ; This appliance confor[...]

Operating Instructions 33 Notes for Test Institutes Testing in accordance with EN 60704 must be carried out with the appliance fully loaded and using the test programme (see Programme Table). Tests in accordance with EN 50242 must be carried out when the salt dispenser and rinse aid container have been filled with salt and rinse aid respectively an[...]

Installation and Conn ection Instructio ns 34 INSTALLATION AND CONNECTION INSTRUCTIONS Installing the Dishwasher • T he dishwasher mu st be installed on a firm floor and adjusted such that it is stable and level. • To compensate for unevenness in the floor and to match the height of the appliance to that of surrounding units extend the threaded[...]

Installation and Connectio n Instructions 35 • If the dishwasher is installed under- neath a kitchen work surface, the original work surf ace of the dish- washer is to be removed as follows: – Unscrew the screws (1) from the elbows on the back side. – Slide the work surface approx. 1cm to the rear (3) , lift at the front (4) and remove. – P[...]

Installation and Conn ection Instructio ns 36 Connecting the Dishwasher Water Connection The dishwasher is fitted with safety devices that prevent the wash water returning into the drinking water system and comply with the applicable plumbing regulations. • T he dishwasher can be connected to cold and hot water supplies up to max. 60 °C. •T h [...]

Installation and Connectio n Instructions 37 Water drain Drain hose 1 The drain hose must not be kinked, crushed or ent angled. • Co nnecting the drain hose: – Maximum permitted height: 1 me tre. – Minimum require d height 30 cm above the lower edge of the machine. Extension hoses • Extensio n hoses are available from AEG Service Force. The[...]

Installation and Conn ection Instructio ns 38 Leak Prevention System For protection from damage due to water leaks, the dishwasher is equipped with a leak prevention system, the AQUA CONTROL SYSTEM. In the ev ent of a fa ult, the drain pump switches on . By this means water can neither escape nor over flow. The remaining water in the appliance is a[...]

Installation and Connectio n Instructions 39 Electrical Connection Any electrical work required to inst all this appliance should be car- ried out by a qualified e lec trician or competent person. 1 WARNING - This appliance must be earthed. The manufacturer declines any resp onsibility should these safety measures not be observed. Before switching [...]

Installation and Conn ection Instructio ns 40 Connections The water inlet and drain hoses, as well as the mains cable must be connected beside the dishwasher as there is insufficient space behind the appliance. The plumbing and electrical installa tion ex ample given below can only be regarded as a recommendation. Two 45° or Straight Connections, [...]

Guarantee Conditions 41 GUARANTEE CONDITIONS Guarantee Conditions AEG offer the follow ing guarantee to the first purcha ser of this appliance. 1. The guara ntee is valid fo r 12 months comme ncing when the applian ce is ha nded over to the first retail purchaser, w hich must be verified by purchase i nvoice or similar doc- umentation. The guarante[...]

42[...]

Service & Spare parts 43 SERVICE & SPARE PARTS If you wish to purchase spar e parts or require an engineer, contact your local AEG Service Force Centre by telephoning: 08705 929 929 Your telephone call will be automatically routed to the Service Centre covering your post code area. When you contact the Service Centre they will need the foll[...]

AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www.aeg.hausgeraete.de © Copyright by AEG 822 945 493 - 00 - 1101 Subject to change without notice[...]