Ariens 911152 BR21SP Bedienungsanleitung

Owner/Operator Man ual Models 91 1 150 – BR21P 91 1 151 – BR21P CARB 91 1 152 – BR21SP 91 1 153 – BR21SP CARB 91 1 154 – BR21SPE W alk Behind Lawn Mower 01282100 11/07 Printed in USA ENGLIS H[...]

GB - 2 Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Assembly . . . . . . . . . . . . . . . . . . . . . . . . 9 Controls a nd Fe a t ure s . . . . . . . . . . . . 1 1 Operati on . . . . . . . . . . . . . . . . . . . . . . . 12 Mainten ance. . . . . . . . . . . . . . . . . . . . . 17 Service a nd Adju stment s . . . . . . . . . . 19[...]

GB - 3 • Record Unit Model and Serial numbers here: • Record Engine Model & Serial numbers here: PRODUCT REGISTRA TION The Ariens d ealer must register the product at the time of purchase. Registering the product will help the company process warranty claims or contact you with the latest service information. All c laims meeting requirement[...]

GB - 4 SAFETY ALERTS Look for these symbols to point out important safety precautions. They mean: Attention! Personal Safety Is Invo lved! Become Al ert! Obey T he Mes sage! The safety alert symbols above an d signal words below are used on decals and in this manual. Read and understand all safety messages. NOT A TIONS NOTE: General reference infor[...]

GB - 5 SAFETY DECALS AND LOCA TIONS AL WA YS replace missing or damage d safety decals. Refer to Figure 2 for safety decal locations. 1. DANGER! TO A VOID SE RIOUS INJU RY OR DEA TH 2. DANGER! KEEP HANDS AND FEET A W A Y Do not opera te mower unless guard s are in operating position or bagger is att ac hed. 3. CAUTION! • Bag is subject to wear an[...]

GB - 6 Read, understand and f ollow all safety practices in Ow ner/Operator Manual b efore beginning assembly . Failure to f ollow instructions could result in personal injury and/or damage to unit. If the operator or the mechanic cannot read the manual, it is the owner ’s responsibility to explain it to them. Only the user can prev ent and is re[...]

GB - 7 If you strike an object, or if equipment vibrates abnormally , stop engine at once, wait for moving parts to stop and disc onnect wire from spark plug. Rep air any damage before restarting unit. Keep rear door cl osed when engine is running unless the grass bag is in place. S top engine before removing and em ptying grass bag. When mulching [...]

GB - 8 AL WA YS drain fuel outdoors away from ignition sources. AL WA YS shut off engine , and remove key , and close fuel shutoff valve when transporting unit on a t ruck or trailer . Avoid Electric Shock. DO NOT disconnect wire from spark plug while e ngine is running. Do NOT put battery in fire or mutilate. Explosive Gas es! NO flames, NO sparks[...]

GB - 9 CARTON CONTE NTS ASSEMBL Y 1. Remove m ower and handlebar from carton. 2. Install the handlebars on the pivot pins attached to the handlebar upright s . NOTE: Make sur e the cables (connected to the handlebar) are on the l eft side of t he unit. 3. Remove the handlebar mounting hardware from the handlebar uprights. 4. Rotate the handlebar up[...]

GB - 10 7. F ill engine crankcase with oil. See engine manual. 8. Set -up mowe r for bagging, side discharge or m ulching. See MOWE R SET - UP on page 14. NOTE: Bagging is not standard on push models. See ACCESSORIES on page 2 4 for kit part numb ers. 9. Fill fuel tank. See FILLING T H E FU EL TA N K on page 14. 10. Connect the battery . See BA TTE[...]

GB - 1 1 1. Engine/Blade Control 2. Wheel Drive Control (91 1 152, 153, 154) 3. Handlebars 4. Grass Bag 5. Rear Door 6. Fuel T ank and Cap 7. Oil Fill/Dip stick 8. Muffler and Muffler Guard 9. Cutting Height Levers (2 R ear Wheel Adjusters, 2 Front Wheel Adjusters) 10. Lift Handle 1 1. P rimer Bulb (91 1 15 0, 151, 152, 153) 12. Air Filter 13. Mulc[...]

GB - 12 CONTROLS AND FEA TURES See Figure 6 for locations. Engine/Blade Control The engine/blade control must be held against the handlebar to start the engine and blade. Engine/blade control feature on mower stops engine and blade within 3 secon ds whenever operator releases handlebar . Check this feature frequently . If feature fails to operate, [...]

GB - 13 OPTIONAL CONTROLS Primer Bulb (91 1 150, 151 , 152, 153) Push the primer bulb in to add fuel f or easier engine start. Wheel Drive Contr ol (self-pro pelled models) NOTE: Engine must be running for wheel drive to propel unit. 91 1 152, 153, 154 T o drive forward: Slowly squeeze the wheel drive control toward the handlebar unt il you reach a[...]

GB - 14 Ignition Sw itch (91 1 154) A removable key operates the ignition switch. T urn the key to the s t art position (2) to start the unit. The key will spring bac k to the “RUN” position. RUN Position (1): All controls are operable. ST ART Po sit ion (2): S tarter t urns over the engine. FILLING THE FUEL T ANK T o add fuel to fuel tank: 1. [...]

GB - 15 T o Side Discharge See Figure 1 1 on page 15. 1. Shut of f unit. 2. Remove gras s bag. 3. Lift rear door and i n stall m ulch plug (see below). 4. Remove the kn ob from and then hold open the m ulch cover . 5. Install the side discharge chute on stud on the m ower . Make sure chute covers discharge opening. 6. Secure the chute with the knob[...]

GB - 16 EMERG ENCY STOPPIN G T o stop the m ower in an emerge ncy: 1. Release the engine/blade control. 2. Release the wheel drive control (self- propelled models). 3. Allow all moving part s to stop before leaving operator ’s position. ST ARTING AND SHUT OFF See Figure 6 for all Controls and Features. NOTE: S tart engine on a level surface that [...]

GB - 17 Ariens Dealers will provide any service, parts or adjustments which may be required to keep your unit operating at peak ef ficiency . Should engine require se rvice, contact an Ariens Dealer or an authorized engine manufacturer's service center . MAINTENANCE SCHE DULE NOTE: Some work ing conditions (heavy loads, high ambient t e mperat[...]

GB - 18 Sharpen the Mowe r Blades 1. Remove m ower blade from unit. Discard mower blade if: • More than 1/2 in. (1.27 cm) of metal is removed. • Air lift s become eroded. • Blade is bent or bro ken. 2. Sharpen mower blade by removing an equal amount of mat erial from each end of mower blade. DO NOT change angle of cutting edge or round the co[...]

GB - 19 CHECK SP ARK PLUG S park plug should be replaced every 100 hours of operation or each year . NOTE: Loose spark plug wire terminals can cause sparking. Replace terminal if damaged. CHECK ENGINE COOLING T o prevent overheat ing, air must circulate freely around the c ooling fins, cylinder head and block. Every 100 hours of operat ion or yearl[...]

GB - 20 DRIVE BEL T REPLACEMENT (self-pro pelled mode ls) T o remove drive belt: 1. Disconnect spark plug w ire from spark plug. 2. Remove t ransmission cover . 3. Disconnect idler ret urn spring from idler arm. See F igure 16. 4. Disconnect the wheel drive cable from transmission mount, and then disconnect drive c able spring from idler arm. 5. Re[...]

GB - 21 2. Connect the wheel drive cable spring to the idler arm as shown in Figure 19, and then connect t he wheel drive cable to the transmission mount. See Figure 16. 3. Connect the idler return spring to the idler arm. 4. Install the blade adapter and blade on the crankshaft. Make sure the blade hardware is t ightened to the proper torque. See [...]

GB - 22 WHEEL DRIVE CONTROL ADJUSTMENT (self-propelled models) See Figure 22. NOTE: The unit should stop immediately when the wheel drive control is released, and the unit should not creep forward when the wheel drive control is dis engaged with the engine running. The unit’ s forw ard speed should increase as the wheel drive control gets cl oser[...]

GB - 23 IMPORT ANT : NEVER spray unit with high- pressure wa ter or store unit outdoors. S tore mower in a coo l, dry , protected location. Cleaning Allow unit to cool. Clean unit thoroughly with mild soap and low pressure water. Brush off dirt and debris from all surfaces. T ouch up all scratched su rfaces to prevent ru st. Matching touch-up paint[...]

GB - 24 Gras s does not disperse evenly 1. T oo much grass is being removed per c utting. 2. G rass is too wet. 3. Mowing speed is too fast. 1. Raise cutting height. 2. Allow grass to dry . 3. Mow slower . Mower does not bag clippings 1. Grass bag is overfilled. 2. Mulching plug is installed. 1. Em pty grass bag an d do not allow it to overfill. 2.[...]

GB - 25 SPECIFICA T IONS Model Number 91 1 150 91 1152 91 1154 Description BR21P BR21SP BR21SPE Length - in. (c m) 70 (177.8) Height - in. (cm) 47 (1 19.4) Width - in. (cm) 21.5 (54.6) Actual Weight - lbs (kg) 69 (31.3) 83 (37.6) 102 (46.2) Cutting Width- in. (cm) 21 (53.3) 21 (53.3) 21 (53.3) Cutting Height - in. (cm) 1 – 4 (2.5 – 10.4) 1 – [...]

GB - 26 SPECIFICA T IONS Model Number 91 1 151 91 1153 Description BR21P – CARB BR21S P – CARB Length - in. (cm) 70 (177.8) Height - in. (cm) 47 (1 19.4) Width - in. (cm) 21.5 (54.6) Actual Weight - l bs (kg) 69 (31.3) 83 (37.6) Cutting Width- in. (cm) 21 (53.3) 21 (53.3) Cutting Height - in. (cm) 1 – 4 (2.5 – 10.4) 1 – 4 (2.5 – 10.4) E[...]

Ariens C ompany • 655 W. Ryan St. • Brillion, WI 541 10-1072• (920 ) 756-2141 • www .a riens.com AL W2-62905 Ariens Limited Warranti es 2-Year L imited Law n and Garden Consumer Wa rranty Ariens Compa n y (Ariens ) warran ts to the origi nal pu rchase r that Arie ns and Gravely brand con sumer produc ts manu factur ed by Ariens Compa ny wil[...]

Ariens C ompany • 655 W. Ryan St. • Brillion, WI 541 10-1072• (920 ) 756-2141 • www .a riens.com AL W2- 62905 Exceptions, L imitation s, Exclusion s These warran tie s are subject to t he fo llowing conditions, limit ations, and ex c lusions: T o obtain warranty servic e, the following conditions must be met: • The p urchaser must perform[...]

Ariens Company 655 West Ryan St reet Brillion, W I 541 10-1 072 920-756-2141 Fax 920-756-2407 www .ariens.com[...]