Baumatic B14.2SS Bedienungsanleitung

1 B14.2SS 60cm touch control ceramic hob[...]

User Manual for your Baumatic B14.2SS 60 cm Side touch control 4 hyperspeed zone ceramic hob. NOTE : This User Instruction Manual contains imp ortant information, including safety & installation p oints, which will enable you to get the most out of your appliance. Please keep it in a safe place so that it is easily available fo r future referen[...]

3 Contents Environmental note 4 Important safety information 5 – 8 S p e c i f i c a t i o n s 8 – 9 C e r a m i c h o b l a y o u t 9 Control panel lay out 9 U s i n g t h e c e r a m i c h o b 10 Before first use 10 T o u c h c o n t r o l s 1 0 T u r n i n g t h e h o b o n 1 0 Turning on a zone and setting a power level 11 Turning off a zon[...]

Environmental note 4 o The packaging materials that Baum atic uses are environmentally friendly and can be recycled. o Please discard all packaging mate rial with due regard for the environment.[...]

Important safety information Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before attempting to install or use the appliance. If you are unsure of any of the info rmation contained in this booklet, please contact the Baumatic Technical Department. General Information o This appliance is[...]

6 Child Safety o Baumatic strongly recommend that babies and young children are prevented from being near to the appliance and not allowed to touch the appliance at any time. During and after use, all surfaces will become hot. o If it is necessary for younger family members to be in the kitchen, please ensure that they are kept under close supervis[...]

Cleaning o Cleaning of the hob should be carried out on a regular basis. o IMPORTANT: Before attempting to clean the appliance, it should be disconnected from the mains and cool. o Great care should be taken whils t using this appliance and when following the cleaning procedure. o You should not use a steam jet or any other high pressure cleaning e[...]

o Pans should be lifted on an d off the hob surface and not dragged. o Cooking zones should not be sw itched on without cookware placed on it. Also the cookware should not be empty. Specifications Product dimensions: Aperture dimensions: Height: 510 mm Height: 490 mm Width: 580 mm Width: 560 mm Depth: 40 mm Product specifications: o 2 x 1.80 kW hyp[...]

For future reference please record the following information which can be found on the rating plate and the date of purchase which can be found on your sales invoice. The rati ng plate of your hob is located on the underneath of the appliance. Theref ore it is a good idea to record this information before yo u install your appliance. Model Number ?[...]

Using the ceramic hob Before first use IMPORTANT: You should clean the ceramic hob surface (see “Cleaning and maintenance” section). o You should switch on one cookin g zone at a time, for 5 minutes at the maximum setting. This will help to eliminate any new smell that exists and evaporate any humidity that has formed on the heating elements du[...]

Turning on a zone and setting a power level IMPORTANT: A burner must be selected within 10 seconds of turning the hob on (see previous page). o Press the cooking zone selection button (2) for the zone that you require. o A “0” will appear on the relevant cooking zone indicator (1) . o A decimal point symbol (3) will appear to show that the zo n[...]

Turning the hob off Once you have switched off all of the cooking zones, you should turn off the hob. o Press the ON/OFF button (6) . It is possible to turn the hob off at any time by pressing the ON/OFF button (6) . Residual heat indicator o After a zone is switched off, the corresponding cooking zone indicator (1) will show the letter “H”. Th[...]

o IMPORTANT: If the appliance is swit ched off whilst the safety lock feature is activated, then it will still be activated the next time that you turn the applianc e on. Therefore before you can turn on a zone and set it to a power level, you will need to deactivate the safety lock by pressing the safety lock button (5) . Safety cut-off o If one o[...]

14 o Finally you should select the ac tual power level that you want the hob to cook on, after the automatic heat up period has completed, by using the minus button (7) . o The cooking zone indicator (1) will alternate between showing the actual power level and the symbol A. o Once the automatic pre-heating ti me period is over, only the actual pow[...]

15 Switching off automatic pre-heating o To switch off the automatic pre-heating mode, you firstly need to make sure that the zone you wish to take out of this mode is selected. You do this by pressing the corresponding cooking zone selection button (2 ). o A decimal point symbol (3) will appear to show that the zo ne is active. o Press the minus b[...]

16 o Preferably cover pans with a lid to permit cooking at a lower heat. o Always cook vegetables and potato es, etc. in as little water to reduce cooking times. o Food or liquid that has high sugar content may damage the hob top if it comes into contact with the ceramic hob surface. Any spillages should be wiped up immediately, however this may no[...]

Cleaning and maintenance Cleaning operations must only be carried ou t when the oven is cool. The appliance should be disconnected from your mains supply before commencing any cleaning process. Cleaning the ceramic hob top Any residues that are left on th e hob top surface from cleaning agents will damage it. You should remove any residues with wat[...]

Using a ceramic hob scraper Your appliance will be provided wi th your appliance. The following guidelines should also be followed when using th e ceramic hob scraper:- o The scraper should be placed on the ceramic surface at an angle. o Residues should be removed by sliding the blade carefully over the ceramic surface. o The ceramic surface should[...]

Installation The installation must be carried out by a suitably qualified person, in acco rdance with the current version of the following. o UK Regulations and Safety Standards or their European Norm Replacements. o Building Regulations (issued by the Department of the Environment). o Building Standards (issued by the Scottish Development Departme[...]

Installing the appliance o Cut a hole in the worktop that corresponds with the drawings shown above. o IMPORTANT: You must have a gap of at least 25 mm between the underneath of the appliance an d any surface that is below it. o Carefully turn the hob upside do wn and place it on a cushioned mat. o Apply the sealing strip provided around the edge o[...]

(A) Clip (B) Fixing bracket (C) Screw o You should insert a clip (A) into the holes which are located in each corner of the hob. o Place the fixing brackets (B) over each hole and clip, and then place a screw (C) through the hole and fixing bracket (B) . Tighten the screws a little way, so that they stay in place. IMPORTANT: Do not tighten the scre[...]

Electrical connection This appliance must be installed by a qualified person in accordance with the latest edition of the I.E.E. Regulations and in compliance with Baumatic’s instructions. Before connecting the appliance, ma ke sure that the supply voltage marked on the rating plate corresponds with your mains supply voltage. WARNING: THIS APPLIA[...]

o The brass links must be positioned as marked in the appropriate diagram and once established ALL terminal screws must be tightened down firmly. o IMPORTANT: The appliance must NOT be connected to the mains supply by means of a 13A plug and socket. o The cable can be looped if necessary, but make sure that is not kinked or trapped when the hob is [...]

24 My appliance isn’t working correctly o The cooking zones are not functio ning or will not switch on. * It has been more than 10 seconds since the appliance was switched on. You should switch the appliance on again, using the ON/OFF button. * The safety lock has been switch ed on (see the “Locking the hob top” section for information on ho [...]

IMPORTANT: If your appliance appears not to be operating correctly, then yo u should disconnect it from your mains supply and then contact the Baumatic Service Department on telephone number (0118) 933 6911. DO NOT ATTEMPT TO REPAIR THE APPLIANCE YOURSELF. Please note that if an engineer is asked to attend whilst the product is under guarantee and [...]

26 Baumatic Ltd. Conditions of guarantee Dear Customer, Your new Ba umatic appliance com es complete with a free 12 month guarantee cove ring bot h parts an d labour costs resulting from defective materials or workmanship. Baumatic also gives you the opportun ity to automatically ex tend the guarantee period for a further 12 months at no extra cost[...]

Headquarters Baumatic Ltd. Baumatic Buildings, 6 Bennet Road, Reading, Berkshire RG2 0QX, United Kingdom Sales Telephone +44 118 933 6900 Sales Fax +44 118 931 0035 Service Telephone +44 118 933 6911 Service Fax +44 118 986 9124 Spares Telephone +44 118 933 6922 Technical / Advice Telephone +44 118 933 6933 E-mail : sales@baumatic.co.uk technical@b[...]

28[...]