Baumatic BDI681 Bedienungsanleitung

BDI681 60 cm Fully integrated full height electronic dishwasher[...]

USER MANUAL FOR YOUR BAUMATIC BDI681 60 cm Fully integrated full height electronic dishwasher NOTE : This User Instruction Manual contains imp ortant information, including safety & installation p oints, which will enable you to get the most out of your appliance. Please keep it in a safe place so that it is easily available fo r future referen[...]

3 Contents E n v i r o n m e n t a l n o t e 4 Important safety information 5 – 7 S p e c i f i c a t i o n s 8 - 9 Product and aperture di mensions 8 P r o d u c t s p e c i f i c a t i o n s 8 Energy efficiency details 8 E l e c t r i c a l d e t a i l s 9 Description of the appliance 9 - 10 C o n t r o l p a n e l 1 0 U s i n g y o u r d i s h[...]

ENVIRONMENTAL NOTE Note : Before discarding an old appliance, switch off and disconnect it from the power supp ly. Cut off and render any plug useless. Cut the cable off directly behind th e appliance to prevent misuse. This should be undertake n by a competent person. Disable the door lock to make sure that children cannot get stuck inside the app[...]

IMPORTANT SAFETY INFORMATION Y o u r s a f e t y i s o f t h e u t m o st importance to Baumatic. Please make sure that you re ad this instruction booklet before attempting to install or use the appliance. If you are unsure of any of the information contained in this booklet, please contact the Baumatic Advice Line. General Safety o Repairs to your[...]

6 o Care should be taken not to trap the power supply cable underneath the appliance whilst installing it. o No attempt should be made to al ter or modify the specifications of this appliance. In daily use o This appliance is only design ed to wash normal domestic washloads. If you use your dishwa sher in any other way or it is incorrectly used, th[...]

7 Child Safety o Your dishwasher should only be used by adults. You should not allow children in the area of the machine unsupervised. You should not let them touch the cont rols or play with the appliance. o It could be possible for a child or pet to gain access to the dishwasher if the door is left open. Therefore please check the inside of the a[...]

8 Specifications Product dimensions Height: 820 - 850 mm Width: 595 mm Depth: 540 mm Aperture dimensions Height: 820 mm (min) Width: 600 mm Depth: 570 mm (min) Product specifications o 12 Place settings o 9 functions: Normal Intensive Economy Glass Rinse Rapid Soak 3 in 1 Auto-sensor o 5 Wash temperatures: 40°C, 45°C, 50°C, 55°C, 70°C o 5 Rins[...]

Energy efficiency details Energy efficiency class: A Washing performance class: A Drying performance class: A Electrical details Rated voltage: 230 Vac 50 Hz Supply connection: 13 A (double pole switched fused outlet with 3 m m c o n t a c t g a p ) Optional extra o DWD600SS - Stainless steel door with mark resistant coating Description of the appl[...]

Control panel 1) ON/OFF button 2) Power on neon 3) Delay start button 4) LED display 5) Rinse aid and salt indicator neons 6) Program selection button 7) Program indicator neons Using your dishwasher Before first use o Install the appliance as per the installation instructions contained within this booklet. o Fill the water softener with 1 litre of[...]

Filling with dishwasher salt IMPORTANT: You should only use salt that is specially designed for use in a dishwasher. If any other type of salt is used in the appliance (in particul ar table salt), it will damage the water softener. o Ideally you should fill the water so ftener with salt, just before you are about to run a wash program. This will he[...]

o IMPORTANT: You do not need to pour 1 litre of water into the container when you subsequently fill the water softener with salt. Setting the water softener level It is possible to regulate the amount of salt that the water softener will release during a wash cycle. The wa ter softener should be set to a level that is appropriate for the hard ness [...]

Filling with rinse aid The rinse aid is released during the final rinse and it helps to prevent water from forming droplets on your dishes. These droplets will lead to sp ots and streaks being left on items after the wash program has completed. o Your dishwasher is designed to utilise liquid rinse aid. o The rinse aid dispenser is located inside th[...]

o You should continue to adjust the rinse aid level upwards until you get no water spots. o If you get cloudiness or streakin g on your dishes, the rinse aid level is set too high and it is causing foaming during the wash cycle. Turn the arrow clockwise an d lower the setting to the next number. Filling with dishwasher detergent The detergent dispe[...]

Loading the upper basket The upper basket is most suited to washing delicate and light dishware, such as glasses, coffee & tea cups, saucers, plates, bowls and shallow pans (that are not heavily soiled). 1. Cups 2. Small serving bowl 3. Large serving bowl 4. Glasses 5. Saucers 6. Dish 7. Dessert dishes o You should position the dishes and cookw[...]

Position 2 (lower position) o For accommodating additional tumblers, cups and mugs. You can also place small, espresso sized cups on top of the side racks. Care should be taken to make sure that there is enough clearance between the top of the cups placed on top of the side racks and the underneath of the dishwasher interior. o Please note that whe[...]

Loading the lower basket The lower basket is most suited to washing larger and more heavily soiled items, such as saucepans, sa ucepan lids and serving dishes. You can also load bowls and a variety of plates into the lower basket. 7. Dessert dishes 8. Serving plate 9. Dinner plates 10. Side plates 11. Cutlery basket o Saucepans and serving bowls mu[...]

The cutlery basket Cutlery should be placed inside of the cutlery basket. The cutlery basket should then be placed in th e appropriate position in the lower basket. 18 1. Forks 2. Soup spoons 3. Dessert spoons 4. Teaspoons 5. Knives 6. Serving spoon 7. Gravy ladle 8. Serving fork o For the best washing performance, cutlery should be placed through [...]

o Do not allow glasses to touch in side the dishwasher, otherwise damage may occur. o Small objects can be placed inside of the cutlery basket. The following items are NOT suitable for washing inside a dishwasher:- o Cutlery with a handle of mother-o f-pearl, wood, horn or china. o Plastic items that are not resistant to heat. o Cutlery that consis[...]

20 Program table Program Program information Description of cycle Detergent pre/main Water consumption (litres) Program times* Auto For all types of soil leve l, such as pots, pans, casserole dishes and dishes that have been sat with dried food on them for awhile. Pre-wash (40°C) Autowash Rinse Rinse (70°C) Drying 3 in 1 tablets (or 5/25 g) 11 ?[...]

* The wash program times that are quoted are intended as a guide only. Please note that factors ex ternal to the machine, e.g. the temperature of your water supply, yo ur water pressure etc. can affect the time it takes for the wash program to complete. ** Normal is the testing program for EN 50242. Setting a wash program M a k e s u r e t h a t t [...]

Changing the wash program o Open the door slightly and then wait a few seconds. o Press and hold down the progra m selection button for 3 seconds to cancel the wash program. Then use the program selection button to choose the correct wash program. o Select any program options that you want to use (e.g. delay start). o Close the door firmly, so that[...]

o Hang the 3 in 1 tablet container on the underneath of the upper basket, in the position shown on the diagram. o Check that the 3 in 1 tablet cont ainer is not going to foul the upper spray arm, by rotating the spray arm around slowly. If it does hit the 3 in 1 tablet co ntainer, you should move it. o Put a 3 in 1 tablet inside the 3 in 1 tablet c[...]

Setting a delay start It is possible to delay the start of the wash program for up to a maximum of 24 hours. o Check whether the appliance needs ri nse aid or salt adding to it. o Pull out the top and bottom bask ets, then load them in accordance with the loading instructions. o Push the top and bottom baskets fully back into position. o Add deterg[...]

Cleaning and maintenance IMPORTANT: The appliance should be disconnected from your mains supply before commencing any cleaning process. The filter system Your appliance is fitted with three levels of filtering; these are located in the base of the dishwa sher for ease of access. 1) Main filter 2) Coarse filter 3) Fine filter Main filter- Food and s[...]

Cleaning the filters For best performance and results, the entire filter assembly should be thoroughly cleaned regularly (ide ally after each wash cycle). 1. Turn the coarse filter anti-clockwise and then lift it upwards. Rinse out this section under a tap to remove any food debris that remains in it. 2. Pull out the main filter and rinse this unde[...]

Cleaning the spray arms The spray arms should be cleaned regularly, to prevent hard water deposits from clogging the spray arm jets and bearings. o To remove the spray arm, unscr ew the nut and take out the washer that sits on top of the spray arm. o Gently pull upwards to remove the spray arm. o Wash the spray arm in warm, so apy water and use a s[...]

Cleaning the door o To clean the edge around the outs ide of the door, you should use a soft, damp cloth only. o To prevent water from penetratin g the door lock or electrical components, DO NOT use a spray cleaner of any kind. o DO NOT use any abrasive cleaner or scouring pads on the inner or outer surfaces, as they may cause damage to them. E1 o [...]

o Wait for 5 seconds, and then swit ch back on the appliance using the ON/OFF button. o Wait for a further 5 seconds before attempting to set a wash program, using the program selection button. IMPORTANT: If any other fault code appears in the display window, you should not attempt to clear it yourself and contact the Baumatic Customer Care Departm[...]

30 General troubleshooting PROBLEM POSSIBLE CAUSES WHAT TO DO Dishwasher doesn’t run Fuse blown or the circuit breaker has tripped Power supply is not switched on Water pressure is low Replace the fuse or reset the ci rcuit breaker. Remove any other appliances that are sharing the same circuit with the di shwasher. Make sure that the dishwasher i[...]

31 Dishes and pans are not clean Improper progr am Improper loading Select a more intense wash program. Make sure that the spray arms and the detergent dispenser are not being impeded by large dishes. Spots and filmin g on glasses and pans Extremely hard water Low inlet temperature Improper loading Improper detergent Incorrect salt/rinse aid levels[...]

Installation IMPORTANT: THIS INSTALLATION MUST BE COMPLETED BY A SUITAB LY QUALIFIED PERSON. BAUMATIC ONLY SANCTI ON THE INSTALLATION GIVEN IN THIS INSTRUCTION MANUAL. YOU SHOULD DISPOSE OF ALL PACKAGING IN AN ENVIRONMENTALLY FRIENDLY MANNER. Aperture requirements o The aperture that your dishwash er needs to be installed into should resemble the o[...]

Installation stages 1. Preparing and connecting the furniture door. 2. Adjusting the tension of the door spring. 3. Connecting to the mains water supply 4. Connecting to the water outlet 5. Connecting to the power supply 6. Applying the condensation strip 7. Positioning the dishwasher 8. Levelling the dishwasher 9. Securing the dishwasher Preparing[...]

o Attach the upper hooks onto the furniture door. o Attach the lower hooks onto the furniture door. o Lift the furniture door towards the dishwasher door, ensuring that the upper and lower hooks locate into the slots on the outside of the dishwasher door. o Push the furniture door downwards so it locks into place on the dishwasher door. o Open the [...]

o IMPORTANT: You should make sure that the screws supplied are appropriate for the thickness of your furniture door. o Replace the covers. Adjusting the tension of the door spring o The door of the dishwasher is attached to springs. These are set at the factory to ensure that they are at the proper tension, so that the door can open and close smoot[...]

Connecting to the mains water supply IMPORTANT: Do not connect the app liance to your mains water supply using an old or an existing water inlet hose. The inlet hose supplied with th e dishwasher is the ONLY one that should be used. DO NOT CONNECT THE WATER INLET HOSE TO A HOT WATER TAP. o The inlet hose will be located inside the cabinet of the di[...]

Connecting to the water outlet 9 Secure the drain hose, so that it cannot move whilst the dishwasher is in use. 9 Place the end of the drain hose on your drain pipe. Push it a short way down into your drain pipe. 9 IMPORTANT: Do not insert the drain hose too deeply into the pipe, as this may cause siphoning. 9 NEVER EXTEND THE DRAINAGE HOSE FROM IT[...]

9 Consult the rating plate, located on the right hand si de of the drop down door BEFORE making the electrical connections. Ensure that the voltage reaching th e plug is the same as that on the rating plate. 9 DO NOT REMOVE THE RATING PLATE A S THE INFORMATION ON IT IS IMPORTANT. 9 The moulded plug that is supplied with the appliance must be placed[...]

o The condensation strip will be located inside of your dishwasher. o Ensure that the underneath of the worktop is clean before sticking the strip to it. o Separate the backing paper away from the strip. o Stick the condensation strip to the underneath of the worktop. o IMPORTANT: Failure to attach the condensation strip could result in damage to y[...]

Levelling the appliance o IMPORTANT: Y o u r d i s h w a s h e r m u s t b e l e v e l f o r i t t o o p e r a t e properly. o Make sure that the dishwasher is supported whilst it is being levelled, otherwise it may tip over. o The rear feet can be adjusted by using the adjusting screw at the front of the appliance. o The front feet can be adjusted[...]

41 Securing the dishwasher o The dishwasher must be secure d to the worktop, this can be done in one of two ways:- o Standard worktop - Secure the dishwasher to the underside of the worktop by using two wood screws. o You should screw through the ho les in the brackets at the top of the dishwasher cabinet. o These screws should be fully tightened. [...]

United Kingdom Baumatic Ltd., Czech Republic Baumatic Buildings, Baumatic CR spol s.r.o. 6 Bennet Road, Pr ů myslová zóna Sever 696 Reading, Berkshire 460 11 Libe rec 11 RG2 0QX Czech Republic United Kingdom +420 483 577 200 Sales Telephone (0118) 933 6900 www.baumatic.cz Sales Fax (0118) 931 0035 Slovakia Customer Care Telephone Baumatic Slovak[...]

43[...]

44[...]