Baumatic BO620SS Bedienungsanleitung

1 BO620SS 60 cm Gas fan-assisted oven[...]

User Manual for your Baumatic BO620SS 60 cm Gas fan-assisted oven NOTE : This User Instruction Manual contains imp ortant information, including safety & installation p oints, which will enable you to get the most out of your appliance. Please keep it in a safe place so that it is easily available fo r future reference; for you or any pers on n[...]

3 Contents E n v i r o n m e n t a l n o t e 4 Important safety informa tion 5 – 8 Specifications 9 - 11 Product specifications 9 Standard accessories 10 O p t i o n a l e x t r a s 1 0 E l e c t r i c a l d e t a i l s 1 0 C o o l i n g f a n 1 0 C o n t r o l p a n e l 1 1 Using your gas oven 1 1 - 1 6 Before first use 11-12 Switching the gas o[...]

Environmental note 4 o The packaging materials that Baum atic uses are environmentally friendly and can be recycled. o Please discard all packaging mate rial with due regard for the environment.[...]

IMPORTANT SAFETY INFORMATION Y o u r s a f e t y i s o f t h e u t m o s t i m p o r t a n c e t o B a u m a t i c . Please make sure that you re ad this instruction booklet before attempting to install or use the appliance. If you are unsure of any of the information contained in t his booklet, please contact the Baumatic Advice Line. General Info[...]

6 Warning and safety instructions o This appliance complies with all current European safety legislation. Baumatic do wish to emphasise that this compliance does not remove the fact that the appliance surfaces will become hot during use and re tain heat after operation. Child Safety o Baumatic strongly recommend th at babies and young children are [...]

7 o Do not place heavy objects on the oven door or lean on the oven door when it is open, as th is can cause damage to the oven door hinges. Nobody should be allowed to sit or stand on any part of the oven. o Do not heat up unopened food containers, as pressure can build up which may cause the container to burst. o Do not place flammable or plastic[...]

Cleaning o Cleaning of the oven should be carried out on a regular basis. o Great care should be taken whilst using this appliance and when following the cleaning procedure. o IMPORTANT: The appliance must be disconnected from the mains before following the cleaning procedure. Installation This appliance must be correctly installed by a suitably qu[...]

Specifications ( IMPORTANT: The above drawing does not show the ventilation requirements that are necessary for installing this appliance, please refer to the installation instru ctions for this information). Product Dimensions Height: 591 mm Width: 597 mm Depth: 547 mm Aperture Dimensions Height: 580 mm– 583 mm Width: 560 mm Depth: 550 mm Produc[...]

10 Standard accessories o Removable side racks o 2 x safety shelves o Enamelled baking tray with handle o Trivet o LPG conversion jets Optional extra o BPS2 Pizza stone Electrical details Rated Voltage: 230 Vac 50 Hz Supply Connection: 13 A (double pole switched fused outlet with 3mm contact gap) Fuse rating: 3 amp Max Rated Inputs: 0.075 kW Mains [...]

Control Panel Using your gas oven Before first use o To remove any residue from the oven that may have been left from the manufacturing process, you should select the gas oven and set it to its maximum temperature setting. o It is perfectly normal for a smell to be produced during this process. o You should make sure that any windows in the room ar[...]

o We would recommend that an appropriate stainless steel cleaner and polish is regularly used on the stainless steel surfaces of this appliance. Switching the gas oven on The oven has automatic ignition, to light it you should do the following:- o Open the door of the appliance. o Push the oven function and te mperature control knob down slightly a[...]

Switching the gas grill on The grill has automatic ignition, to lig ht it you should do the following:- o Open the door of the oven and fit the grill deflector to the front of the appliance. You should then close the oven door until it rests against the grill deflector. o Push the oven function and te mperature control knob down slightly and then t[...]

o IMPORTANT: You should allow th e oven to cool completely before attempting to remove the grill deflector. If you attempt to remove the grill deflector before the oven is cool, it will be extremely hot. Operation of the fan o After igniting the oven and shutti ng the door of the appliance, check to make sure that the fa n on the rear wall of the o[...]

o Try to open the door as little as possible to view the dishes. Warnings o Keep the oven door op en when using the grill function and make sure that the grill deflector is fitted. o Do not use aluminium foil to cover the enamelled baking tray or heat items wrapped in aluminium foil under the grill. o You should also never line the base o f y o ur [...]

o Your oven is a Continental st yle gas oven, which may require some adjustment in your cookin g method, if you are used to a U.K. style gas oven. o We would recommend that you pl ace the enamelled baking tray into the lowest shelf position. o This will deflect some of the fier ce heat generated by the base burner away from the food that you are co[...]

Cleaning and maintenance Cleaning operations must only be carried out when the oven is cool. The appliance should be disconnected from your mains supply before co mmencing any cleaning process. o The oven should be thoroughly cl eaned before it is operated for the first time and after each use. This will avoid residual food stuffs becoming baked on[...]

Replacing the oven bulb IMPORTANT: The oven must be disconnected from your mains supply before you attempt to either remove or replace the oven bulb. o Remove all oven shelves and the enamelled baking tray. o Remove the light cover by turning it anti-clockwise. o Unscrew the bulb clockwise and remove it from its holder. o Replace the bulb with a 25[...]

o IMPORTANT: You should make sure that the door is supported at all times and that you place the door on some padded material whilst cleaning it. o The oven door and door glass sh ould only be cleaned using a damp cloth and a small amount of detergent. The cloth MUST NOT have come into contact with any form of cleaning product or chemical previousl[...]

worktop level. An outlet can then be located at the rear of the appliance for connection. o To connect the oven power cord, loosen and remove the cover on the terminal block, in order to gain access to the contacts inside. Make the connection, securing the cord in place with the cable clamp provided and then immediately close the terminal block cov[...]

Installing the oven into the kitchen cabinet Positioning the appliance o Ensure that the aperture that you will be fitting the oven into is of the size given in the above diagram. o The oven must be fitted into an oven housing with the ventilation cut-outs shown in the “Ventilati on requirements” section on the next page. o Ensure that the rear[...]

Ventilation requirements o You should remove the rear panel of the housing unit before attempting to install the oven. A f ull depth shelf must be incorporated into the housing and positioned 50 mm below the support shelf for the appliance. o A minimum ventilation gap of 50 mm must be allowed between the rear of the support shelf an d the rear of t[...]

Additional built under ventilation requirements o Remove the horizontal strengthen ing support at the upper front housing unit. o If your housing unit incorporates a domestic lower drawer, this must be made non-functioning with a ventilated false front. o A 5 mm ventilation gap must be allowed between the to p of the appliance and the unde rside of[...]

Gas connection This appliance must be installed by a competent person in accordance with the current versions of the following UK (United Kingdom) or ROI (Republic of Ireland) Regulations and Safety Standards or their European Norm Replacements. Important information o This oven is supplied to run on natural gas only and cannot be used on any other[...]

25 o Ensure that the room containing th e oven is well ventilated, keep natural ventilation holes. o Prolonged intensive use of the appliance may call for additional ventilation. o This oven is not fitted with a device for discharging the products of combustion. Ensure that the ventilation rules and regulations are followed. o Your oven must stand [...]

Gas connection ALL INSTALLATION AND SERVICE WORK MUST BE CARRIED OUT BY A GASSAFE REGISTERED ENGINEER. 26 o Prior to installation, ensure that the gas supply conditions (nature of the gas and gas pr essure) and the adjustment conditions are compatible. The ad justment conditions for this appliance are stated on the rati ng plate which can be found [...]

Gas adjustment (Conversion to LPG and gas adjustment) IMPORTANT: Your appliance mu st be disconnected from the electric and gas supply before completing this process. Power inputs Natural Gas LPG Oven 2.74 kW (injector size 115) 2.74 kW (injector size 80) Grill 2.40 kW (injector size 115) 2.40 kW (injector size 80) Gas details Gas Connection Type: [...]

o Unscrew screw (A) which will allow you to remove the oven burner. o Unscrew the injector (B) and replace it with one suitable for LPG (see the power inputs information on page 29). It is recommended that the appropri ate thread sealant is used; always check for gas tightness after assembly. o Re-fit the burner and the base of the oven cavity by f[...]

o Re-fix the grill burner, no further adjustments are necessary. o Remove the control panel cover from the top of the appliance. o Remove the oven control knobs and then undo the two fixing rings that are exposed underneath, by turning them anti- clockwise. o Disconnect the neon lamp at the rear of the fascia and then remove the control panel front[...]

30 o Re-assemble the appliance, reinst all it and then carry out a full function test (this should include a gas tightness test). My appliance isn’t working correctly The gas oven burner or grill burner do not light. * Check that the oven is switch ed on at your mains supply. * Check that the fuse in the spur outlet doesn’t need replacing. * Ch[...]

31 should and then telephone number (0118) 933 6911. DO NOT AT APPLIANCE Y IMPORTANT: If your appliance to be operating correctly, then you disconnect it from your mains supply contact Baumatic Customer Care on appears not TEMPT TO REPAIR THE OURSELF. P l e a s e n o t e t h a t i f a n e n g i n e e r i s asked to attend whilst the product is unde[...]

United Kingdom Baumatic Ltd., Baumatic Buildings, 6 Bennet Road, Reading, Berkshire RG2 0QX United Kingdom Sales Telephone (0118) 933 6900 Sales Fax (0118) 931 0035 Customer Care Telephone (0118) 933 6911 Customer Care Fax (0118) 986 9124 Spares Telephone (01235) 4372 44 Advice Line Telephone (0118) 933 6933 E-mail: sales@baumatic.co.u k customerca[...]

2[...]

3[...]

4[...]

5 5[...]