Crimestopper Security Products CS-2002DC Bedienungsanleitung

CS-2002DC Series IV REMOTE CONTROL ALARM SYSTEM INSTALLATION & OPERATING INSTRUCTIONS INTRODUCTION CONGRATULATIONS on your choice of an “On-Guard” Remote Al arm System by Crimestopper Security Products Inc. This booklet contains the information nec essary for installing, using, and maintaining your alarm system. If any questions arise, cont[...]

TABLE OF CONTENTS Installation Cautions & Warnings…….……………………………….……………………………………………2 Control Module & Component M ounting……………...……………………..……………………….…………..3 Wiring……..…………………………………………………[...]

CONTROL MODULE & COMPONENT MOUNTING DO NOT Mount the control unit in the engine comp artment or where the control unit or wiring harness where they can become entangled with moving par ts such as brake/gas/clutch pedals, or the steering column! The alarm control module s hould be mounted in a concealed location. The Placement of the module will[...]

WIRING BLACK WIRE: SYSTEM CHASSIS GROUND The Black wire MUST be connected t he CHASSIS METAL of the vehicle. Scrape away any paint or debris from the connection point and use a star washer to ensure a good connection. Keep the ground wire short. YELLOW WIRE: IGNITION SWITCHED “ON” AND “START” +12 VOLTS Connect to an IGNITION wire (or fuse i[...]

WIRING BLUE/WHITE WIRE: (-) PASSENGER(S) DOOR UNL OCK OUTPUT (Optional, requires relay ) Connects to unlock circuit for passenger door(s) when using separate driver’s door unlock option. See SEPARATE DRIVER’S DOOR UNLOCK WIRING on Page 8 for some configuration options. BROWN WIRE: (+) SIREN OUTPUT (3 Amp Max.) Connect to RED siren wire from the[...]

WIRING RED WIRE: +12V POWER INPUT (15 amp fuse) Connect to +12 Volt source with supplied fuse & holder. Recommended location for this connection is at the vehicle battery positive terminal. 14 GA. BROWN WIRE: (On-board Starter Disable Relay) Cut the 14GA. Brown wire in half. Connect the 2 female terminals to the Male terminals on the control mo[...]

NEGA TIVE TRIGGER DOORLOCK WIRING POS ITIVE TRIG GER DOO RLOCK WIRIN G GREEN GREEN FU SED RED +12V RED BLUE + BLUE 86 85 86 85 87 87 30 87A 30 87A FAC TO RY FAC TO RY L L POWER POWER LOCKING LOCKING UL UL RELA YS RELA YS REVE RSE P OLARITY DOOR LOCK WIRING GREEN GREEN FUSED FUSED RED RED +12V +12V BLUE BLUE + + 86 85 86 85 86 85 86 85 87 87 87 87 3[...]

SEPARATE DRIVER’S DOOR UNLOCK WIRING NEGA TIVE T RIGGER DOOR LOCKS BLUE/W HIT E GREEN RED BLUE DRIVER'S DOOR MOTOR 86 85 L L 87 UL UL 87A 30 F ACTOR Y LOCK RELA YS +12V + FUSED UNLOCK W IRE CUT WIRING FOR REVERSE POLA RITY DOOR LOCKS BLUE/W HITE GREEN FU SED RED +12V BLUE + MASTER 86 85 86 85 SW ITC H 86 85 87 87 87 30 87A 30 87A 30 87A + L [...]

TRANSMITTER PROGRAMMING NOTE: All transmitters must be learned at the time of programming. This system can learn up to 4 remotes. 1. Turn key to the ON position and press program button 4 times. 2. After a short delay, the unit will flash the parking lights 4 times. 3. Press the Button #1 (Lock) on the remote you wish to program. 4. You should get [...]

OPTION PROGRAMMING 1. Turn the Ignition ON and press the Override/Program button 5 times. 2. After a short delay, the parking lights will flash 5 times and status LED will be on solid. 3. Within the next few seconds, press the Override/ Program button [again] the number of times that corresponds to the options chart below. Parking lights and/or opt[...]

OPTION PROGRAMMING 1. HORN CHIRPS / PULSES This option controls the system’s Factory Vehicle H orn output. There are 3 selections: Button 1 (Lock) = Horn Pulse only when alarm is tripped. Button 2 (Unlock) = Horn Chirps for Arm / Disarm and Pulse when tripped. Button 3 (Trunk) = Horn Chirps for Arm, Disarm, and Pre-warning protection. All setting[...]

OPTION PROGRAMMING 7. DOUBLE UNLOCK PULSE With this feature enabled, the unit will send 2 unlock pul ses when the #2 Unlock button is pressed. 2 pulses are required for interfacing into some existing Factory Keyless Entry or Alarm systems on vehicles such as Nissan, VW, Toyota, and Lexus vehicles. 8. SILENT ARMING /DISARMING (CHIRP DEFEAT) With thi[...]

PROGRAMMABLE OPTION RESET Follow the steps below to reset ALL OPTION VAL UES ON PAGE 10 TO FACTORY DEFAULT SETTINGS. 1. Turn the Ignition ON and press the Override/Program button 5 times. You should hear a long chirp. 2. Immediately press Button #3 (Trunk) on the remote. 3. The siren will chirp 4 times and lights will flash 4 times. 4. Turn off ign[...]

OPERATING INSTRUCTIONS 6 BUTTON REMOTE TRANSMITTER: #3 #1 #2 #4 LOCK TR U N K PA N I C UNLOCK BA N K #2 FLA SH LIGHT (A U X.) PAN I C BANK #1 (Directly Press Buttons) Button 1: Arm Button 2: Disarm Button 3: Aux #1 (Trunk) Button 4: Panic Button 5: (Change to BANK #2) BANK #2* (Press Bank #2 button FIRST, then within 3 seconds Buttons 1-4) Button 1[...]

OPERATING INSTRUCTIONS TRUNK/HATCH POP (REMOTE AUX. OUTPUT 1, OPTIONAL) To pop the trunk (if optional feature is installed), press Button #3 (Trunk Symbol) on the transmitter for at least 1½ seconds. If the system is armed, pressing Button #3 may or may not trip the alarm system when opening the trunk depending on programming option (10). See page[...]

OPERATING INSTRUCTIONS VALET MODE To disable the Alarm system for vehicle serv ice or otherwise, turn the ignition on and press the override/program button 4-5 seconds until the dash LED t urns on solid and you hear (1) siren chirp. Repeat the process to exit VALET mode and the system will ch irp (2) times and the LED will turn off. Lock/Unlock and[...]

OPERATING INSTRUCTIONS ACTIVE RE-ARMING (FAIL-SAFE PROTECTION) Active Re-arming means that the system will re-arm itself 30 seconds after disarmed with the transmitter if a door has not yet been opened. This is handy if the vehicle is accidenta lly disarmed (via the transmi tter in your pocket) without you knowing it. This feature can also be turne[...]

CARJACK PROTECTION FEATURES FULL-TIME CARJACK ONLY USE THIS MODE WHEN THERE IS AN EXTREME TREAT OF A CARJACK WITH YOUR VEHICLE. Full-time Carjack protection must be enabled before use through Alarm programming options (13) & (14). See page 10. EVERY TIME the Ignition is turned ON or a door is opened and closed with the Ignition ON, a Carjack co[...]

+ - + BLACK(GROUND ) W H ITE( W ARN ING) RED (+) BLUE (TRIGGER) RED WHIT E BROWN BLUE/WHITE WHIT E/R ED ORANGE BLACK/WHITE BLUE GRA Y YELLOW BLACK VIOLET GREEN LED OVERRIDE/ PROGRA M BUTTO N BA TTERY (-) LOCK OUTPUT +12 VOL T FOR RELA YS (-) UNLOCK OUTPUT GREEN BLUE RED (-) NEG . DOO R PIN SWITCH (+) POSITIVE DOOR PIN SW ITCH FUSE BOX IGN. SW (-) R[...]

ONLINE TECHNICAL SUPPORT www.crimestopper.com/techweb03.html www.crimestopper.com email@crimestopper.com Phone (800) 998-6880 FAX (805) 581-9500 © 2003 Crimestopper Security Products[...]