Directed Electronics 3000 Bedienungsanleitung

3000 O O w w n n e e r r ’ ’ s s G G u u i i d d e e ®[...]

i © 2005 directed electr onics, all rights reserved limited lifetime consumer warranty For a period of one calendar year from the date of pur chase of this auto-security device, Directed Electr onics pr omises to the ORIGINAL PURCHASER to repair or r eplace (with a com- parable reconditioned model), fr ee of cost, any electr onic control module wh[...]

ii © 2005 directed electr onics, all rights reserved OF TIME, LOSS OF EARNINGS, COMMERCIAL LOSS, LOSS OF ECONOMIC OPPORTUNITY AND THE LIKE. NOTWITHST ANDING THE ABOVE, MANUF ACTURER DOES OFFER A LIMITED W AR- RANTY TO REPLACE OR REP AIR THE CONTROL MODULE AS DESCRIBED ABOVE. Some states do not allow limitations on how long an implied warranty will[...]

1 © 2005 directed electr onics, all rights reserved limited lifetime consumer warranty . . . . . . . . . . . . . . . . . . . . .i trademarks and copyrights . . . . .ii table of contents . . . . . . . . . . . . .1 what is included . . . . . . . . . . . . . .2 important information . . . . . . . . .2 your warranty . . . . . . . . . . . . .3 remote c[...]

2 © 2005 directed electr onics, all rights reserved what is included z One contr ol module/siren with built-in Tilt sensor and 24 pin main wiring har ness (attached) z One Mini-Blue status LED z One 2-button V alet switch z One in-key 2-button r emote z One 3-button r emote z T wo Merlin decal’ s z This Owner’ s Guide z W arranty Card importan[...]

3 © 2005 directed electr onics, all rights reserved system maintenance The system r equires no specific maintenance. The batteries in your r emotes will last approximately one year under normal use. Y our 3-but- ton r emote is powered by a miniatur e 3V lithium battery (CR2032). Y our in-key 2-button r emote is powered by a 12V miniatur e battery [...]

4 © 2005 directed electr onics, all rights reserved r emote configurations The 3000 system has an in-key 2-button r emote control and a 3-button r emote control. T wo additional Merlin remote contr ols can be added. 3-BUTTON REMOTE CONTROL A RM/DISARM/P ANIC LED SILENT ARM/DISARM ACCESSORY FRONT REAR LED A RM/DISARM/P ANIC ACCESSORY IN-KEY 2-BUTTO[...]

5 © 2005 directed electr onics, all rights reserved r emote functions This system uses computer -based code lear ning to lear n the remote buttons. This makes it possible to assign any r emote button to any sys- tem function. The r emotes initially come programmed with standar d configuration. The buttons in all of the instructions in this manual [...]

6 © 2005 directed electr onics, all rights reserved Button An optional accessory convenience or expansion function that you have added to your system can be activated by pr essing this button. Button Silent arm and disarm is contr olled by this button. and Buttons When pr essed together , these buttons disable the on-board contr ol module tilt sen[...]

7 © 2005 directed electr onics, all rights reserved While the system is armed, the LED status indicator will flash appr oxi- mately once per second showing that the system is actively pr otecting your vehicle. If you hear mor e than one chirp when arming, refer to the Diagnostics section of this guide. These extra chirps confirm a malfunc- tion au[...]

8 © 2005 directed electr onics, all rights reserved disarming T o disarm the system, press . Y ou will hear two chirps and the parking lights will flash twice. If the sir en chirps four times when disarm- ing, r efer to the Diagnostics section of this guide. This is called T amper Alert. If the sir en is active (sounding) when the system is disarm[...]

9 © 2005 directed electr onics, all rights reserved 8. Then once. 9. Then once. This enters the final digit 1. auto-immobilisation Immobiliser cir cuits automatically activate after 30-seconds. Auto-immobilisation sequence: 1. T ur n ignition off or disarm alarm. 2. After 30-seconds the systems Immobilisation cir cuits activate and engage the star[...]

10 © 2005 directed electr onics, all rights reserved When you r emote siren silence, the sir en will either chirp 1 or 3 times. 1-chirp indicates that the system is still armed, and that all zones ar e inactive and being monitored. 3-chirps indicate that the system is still armed, and that at least one zone is still active and being bypassed. N N [...]

11 © 2005 directed electr onics, all rights reserved r emote sensor disable This can be performed anytime the system is armed. Follow the pr oce- dur e listed below . 1. Arm the system. 2. Using the r emote press and simultaneously . 3. The indicators will flash four times; all W ar n Away ® zones of optionally installed sensors ar e now bypassed[...]

12 © 2005 directed electr onics, all rights reserved auxiliary channel bypass All alarm sensor inputs will be bypassed while a pulsed or timed auxil- iary output is active. panic mode If you ar e threatened near your vehicle, you can attract attention by triggering the system with your r emote! Just press for two sec- onds to enter Panic Mode. The[...]

13 © 2005 directed electr onics, all rights reserved r emain on if V alet Mode has been enter ed. The LED status indicator will light steadily if you ar e entering V alet Mode. T o exit V alet Mode: 1. T ur n the ignition On. 2. Enter your PIN code as described pr eviously 3. When you enter the last digit the LED will light up, contin- ue to hold [...]

14 © 2005 directed electr onics, all rights reserved instant auto-arming bypass This will bypass the auto arm featur e once only . 1. W ith the key , tur n the ignition on, then off within two seconds. 2. The sir en will chirp once to confirm auto arming bypass. 3. The system will not auto arm. During auto arming bypass the system will not auto-ac[...]

15 © 2005 directed electr onics, all rights reserved NPC ® is On/Of f programmable. See your dealer and the Pr ogramming section of this guide for mor e information. multiple event total r ecall This will r eport the last eight system triggers in reverse chr onological or der . 1. Pr ess and hold of the V alet switch. 2. While still holding , arm[...]

16 © 2005 directed electr onics, all rights reserved diagnostics The micr oprocessor at the heart of your security system is constantly monitoring all of the switches and sensors that ar e connected to it. It detects any faulty switches and sensors and pr events them from dis- abling the entir e system. The micropr ocessor will also r ecor d and r[...]

17 © 2005 directed electr onics, all rights reserved disarming diagnostics Extra disarm chirps ar e the T amper Alert. If four chirps are hear d when disarming, the system was trigger ed in your absence. If four chirps are hear d, the LED status indicator will indicate which zone was triggered when the ignition is tur ned on and will r epeat 5-tim[...]

18 © 2005 directed electr onics, all rights reserved table of zones The zone number is the number of LED flashes used by the system to identify a specific input. The standar d input assignments are listed below , along with spaces to write in any optional sensors or switches you have had installed. If a W ar ning Zone response is trigger ed, the L[...]

19 © 2005 directed electr onics, all rights reserved high fr equency Y our system transmits and receives at 433 MHz. This pr ovides a cleaner spectrum with less interfer ence and a more stable signal. rapid r esume logic This security system will stor e its current state to non-volatile memory . If power is lost and then r econnected the system wi[...]

20 © 2005 directed electr onics, all rights reserved power saver mode z When in V alet mode, the LED will tur n off 1-hour after enter- ing V alet mode. z After 24 hours in the armed state, the LED will decr ease the flash rate to 1 / 2 the normal rate; after 48 hours it will decrease to 1 / 4 the normal rate. z After 96 hours of no activity (arm,[...]

21 © 2005 directed electr onics, all rights reserved pr ogramming options Pr ogramming options control what your system does during normal operation, and r equire few or no additional parts. However , some may r equire additional installation labor . Following is a list of the pr ogram settings, with the factory settings in bold: z Autoarming on o[...]

22 © 2005 directed electr onics, all rights reserved manual pr ogramming instructions It is a good idea to document changes by taking note of all featur e changes made in pr ogramming mode. T o enter the User Selectable Features pr ogramming: 1. Ignition on - T ur n the ignition to the on/run position or start the engine. 2. Enter PIN - Y our PIN [...]

23 © 2005 directed electr onics, all rights reserved 6. Featur e change - Press the button on the r emote. If the system chirps once, the featur e has just tur ned off or switched to the first setting in the grid slot for this featur e; if the system chirps twice, the featur e has just tur ned on or switched to the second setting in the grid slot.[...]

24 © 2005 directed electr onics, all rights reserved user selectable featur es user selectable featur es descriptions - column one add new r emote (for 2-button in-key and 3-button remotes only) z Auto-lear n new r emote controls to the system (one at a time) in the standar d button configuration. For more infor- mation, r efer to Note #1 in Progr[...]

25 © 2005 directed electr onics, all rights reserved auto (passive) arm - on/of f z On: When the system sees the ignition tur n of f, it will begin a 30-second countdown befor e arming itself. The count- down is indicated by the system LED rapid flashing. After the first five seconds, you will hear one chirp and the indicators will flash. The syst[...]

26 © 2005 directed electr onics, all rights reserved user selectable featur es descriptions - column two set pin code z This featur e allows you to change your personal PIN code. For mor e information, please refer to the PIN Programming section of this guide. Factory default PIN number is 2. select sir en sounds This featur e allows you to select[...]

27 © 2005 directed electr onics, all rights reserved system r esets the one hour timer . If one hour passes and the zone has not trigger ed again, the zone is activated and can trigger the system again. NPC ® monitors sensor inputs and the door trigger . If NPC ® is tur ned of f, the system will respond to r epeated triggers on the sensor inputs[...]

28 © 2005 directed electr onics, all rights reserved accessory (-) output z The r emote channel programmed into this featur e will acti- vate the accessory output. silent mode TM z The r emote channel programmed into this featur e will arm/disarm the system, but the sir en will not chirp. r emote valet on/off z The r emote channel programmed into [...]

29 © 2005 directed electr onics, all rights reserved pin pr ogramming A PIN code can have one to four digits; each digit can be from 0-9. Pr ogramming Procedur e 1. Enter the featur e location (column 2, row 1) in the user - selectable pr ogramming grid. 2. Immediately pr ess and release of the V alet switch. 3. Select each digit by pr essing 1-9 [...]

30 © 2005 directed electr onics, all rights reserved PIN Code Confirmation Pr ocedure Begin this pr ocedure within 15 seconds of finishing the pr ogramming sequence or the new code will not be set. 1. T ur n on the ignition. 2. Enter the new PIN code. 3. Pr ess and hold for three seconds. z LED tur ns on: New PIN code is lear ned and pr ogram- min[...]

31 © 2005 directed electr onics, all rights reserved glossary of terms Contr ol Unit: The "brain" of your system hidden somewher e on the motor cycle where it is dif ficult for a thief to access. It houses the micr o- pr ocessor which monitors your vehicle and controls all of the system's functions. The Merlin 3000 contr ol unit hou[...]

32 © 2005 directed electr onics, all rights reserved security & convenience expansions Her e we have listed only some of the many expansion options avail- able. Please contact your dealer for a complete list of all the options available to you. Field Disturbance Sensor: An invisible dome of coverage is established by installing the 508D "[...]

C C u u t t a a l l o o n n g g d d o o t t t t e e d d l l i i n n e e a a n n d d f f o o l l d d f f o o r r a a q q u u i i c c k k a a n n d d e e a a s s y y r r e e f f e e r r e e n n c c e e t t o o k k e e e e p p i i n n y y o o u u r r p p u u r r s s e e o o r r w w a a l l l l e e t t . . ✂ ✂ ✂ ✂ QUICK REFERENCE GUIDE r emote [...]

C C u u t t a a l l o o n n g g d d o o t t t t e e d d l l i i n n e e a a n n d d f f o o l l d d f f o o r r a a q q u u i i c c k k a a n n d d e e a a s s y y r r e e f f e e r r e e n n c c e e t t o o k k e e e e p p i i n n y y o o u u r r p p u u r r s s e e o o r r w w a a l l l l e e t t . . ✂ ✂ ✂ ✂ system disarm T o disarm the s[...]

Vista, CA 92081 www .directed .com © 2005 Directed Electr oni cs - All righ ts reserved G225T 10-05 The company behind this system is Dir ected Electr onics. Since its inception, D irected E lectronics has had one purpose, to pro vide consumers with the finest vehicle security and car stereo pr oducts and accessories available. The r ecipient of n[...]