Electrolux 134700400 Bedienungsanleitung

137064300 A (080 1) In stallation In struction s Electr olux Front-Load Was her In strucciones de In stalacion Lav adora de car ga frontal Electr olux In struction s d’in stallation Lav euse à char gement frontal Electr olux[...]

2 Finding Information Please r ead and save this guide Thank you for choosing Electrolux , the new pr emium brand in home appliances. These Installation Instructions are part of our commitment to customer satisfaction and pr oduct quality throughout the life of your new appliance. W e view your pur chase as the beginning of a relationship. T o ensu[...]

3 Safety Important Safety Instructions Recognize safety symbols, words and labels Safety items throughout this manual ar e labeled withaWARNINGorCAUTIONbasedontherisk type as described below: T ools and materials needed for installation: WHA T TO DO IF YOU SMELL GAS: Donottrytolightanyappliance. • D[...]

4 Electrical system r equirements W ater supply requir ements Gr ounding requir ements Drain system r equirements CIRCUIT - Individual, properly polarized and grounded 15 amp. branch cir cuit fused with 15 amp. time delay fuse or circuit br eaker . POWERSUPPL Y-2wire,withgr ound,120volt single phase, 60 Hz, Alternating Cu[...]

5 MINIMUMINST ALLA TIONCLEARANCES-Inches(cm) SIDES REAR TOP FRONT Alcove 0” (0 cm) 0” (0 cm)* 0” (0 cm) n/a Under - Counter 0” (0 cm) 0” (0 cm)* 0” (0 cm) n/a Closet 0” (0 cm) 0” (0 cm)* 0” (0 cm) 1” (2.54 cm) Installation Requir ements Clearance r equirements 0” (0cm) 0” (0cm) 1” (2.54cm) 0” (0cm) IMPOR T[...]

6 Installation Requir ements 38.00” (96.52cm) 53.00” (134.62cm) 50.6” (128.53cm)* to clear open door 31.50” (80.01cm)* to front of closed door water supply connection on rear of unit ¹ drain hose on rear of unit ² power cord on rear of unit ³ freestand washer on floor floor line floor line washer mounted on optional pedestal 27.00” (68[...]

7 Unpacking W asher Removing foam packaging T emporarily remove door tape. 1. Open washer door and remove everything fr om 2. the drum. Close door and reapply door tape. 3. Using a rug, blanket or piece of cardboar d to 4. protect the floor , carefully lay the washer on it’ s back. Remove styrofoam base and shipping plug and 5. set them aside. C[...]

8 Unpacking W asher Removing shipping har dware Installing hole plugs NOTE Ru bber ex pans ion mat eri al on spacers may need time to relax befor e they can be easily pulled through shipping hole. IMPOR T ANT Save all shipping bolts and spacers for future use. If the washer is to be transported at a later date, the shipping hardwar e must be reinst[...]

9 Installation Instructions raise lower Leveling your washer Excessive noise and vibration can be prevented by properly leveling the washer . For free standing installation and with the 1. washer within 4 feet (1 m) of its final location, place a level on top of the washer . Use the universal wrench to adjust the level- 2. ing legs so the washer i[...]

10 Run some water from the hot and cold faucets 1. to flush the water lines and remove particles tha t mi ght c log the w ater valv e sc ree ns an d to determine which faucet is hot and which is cold supply . Lookintheendofeachwatersupplyinlethose 2. and verify that the rubber washers are in place. Connect the HOT inl[...]

11 Snap one end of the drain hose hanger 1. (shipped in washer drum) onto the drain hose. Continue wrapping it around the hanger and snap it in place. Place the hook end of the drain hose in the drain 2. opening. Secure the drain hose with the cable tie (provided in the enclosur e package) to the stand - pipe, inlet hose, laundry tub, etc. so the h[...]

12 If your washer has this console: If your washer has this console: Empty washer’ s drum and close door . 1. After you plug in the washer the first time: wake up the washer by pressing any button, r otate cycle 2. knob to hand wash cycle, press the start button and then the cancel button. W ake up the washer again by pressing any button, then i[...]

13 W ARNING ELECTRICALSHOCKHAZARD Failure to disconnect power sour ce before servicing could result in personal injury or even death. B)RemovingDoorfromHinge 1 Reopen door to 90 degree angle. 2 Remove 4 long, course-thread, counter -sunk hinge screws fr om door . A) Removing T rim Ring 1 Open the door to a 90 degree angle. 2 Remov[...]

14 Reversing Door W ARNING ELECTRICALSHOCKHAZARD Failure to disconnect power sour ce before servicing could result in personal injury or even death. C) Removing Hinge from Fr ont Panel 1 With the hinge in open position, remove 2 short, course-thread, panhead scr ews on hinge plate. D)RemovingDoorLockfromFr ontPanel 1 Remove [...]

15 Reversing Door E)ReattachingDoorLocktoFrontPanel 1 Rotate the door lock and move it to the opposite opening. 2 Connect the harness to the door lock by inserting it in the terminal and firmly pushing it in place. 4 Secure the lock with 2 short, course-thr ead, panhead screws. 3 Insert the harness connection through the front pa[...]

16 Reversing Door H)RemovingLatchIndicator 1 Insert flat blade screwdriver into open slot of latch indicator .  2 Gentlypryupwardtor eleasetab. 3 Pull the indicator out and set it aside. 3 Pull the hole plug out and set it aside. G)RemovingStrikerPlate 1 Remove 2 long, course-thread, counter -sunk screws a[...]

17 insert tab insert tab insert tab insert tab press down and snap press down and snap K)ReattachingStrikerPlate 1 Rotate the striker plate and move it to the opposite side of door above the indicator . 2 Reattach with 2 long, course-thread, counter -sunk screws. Reversing Door J)ReinsertingLatchIndicator 1 Rotate the latch indica[...]

18 M)ReattachingDoorAssembly 1 Open the hinge to a 90 degree angle. 2 Install the door onto the hinge locating pins. N) Reversing T rim Ring 1 T rim ring orientation is marked on the back. 2 Remove the trim ring cover plate. T o remove the cover plate from the right, pivot point is up. T o remove the cover plate fr om the left, pivot point[...]

19 If replacements parts ar e needed for your washer , contact the source wher e you purchased your washer ,call1-877-4ELECTROLUX(1-877-435- 3287), or visit our website, www .electroluxappliances.com, for the Electrolux AuthorizedPartsDistributornearestyou. Options W ARNING ELECTRICALHAZARD Labelallwirespriorto?[...]

20 Notes[...]