Electrolux EHG 770 Bedienungsanleitung

Gas hobs Mod. EHG 770 INSTR UCTION BOOKLET Please read this instruction booklet before using the appliance 35675-7402 GB[...]

2 This appliance complies with the following E.E.C. Directives: * 73/23 - 90/683 (Low V olt ageDirective); * 93/68 (General Directives); * 89/336 (Electromagnetical Compatibility Directive) ; * 90/396 (Gas Appliances) , and subsequent modifications Import ant Safety Information You MUST read these warnings carefully before installing or using the h[...]

3 For the User Content s For the Inst aller 1. Auxiliary Burner 2. Semi-rapid Burners 3. Ultra-rapid Triple-crown Burner 4. Rapid Burner 5. Ignition push-button 6. Control knobs 2 1 3 4 5 2 Description of the Hob Important Safety Information 2 Description of the Hob 3 Operation 4 Maintenance and Cleaning 4 Something Not Working? 5 Service and S p a[...]

4 Maintenance and Cleaning Operation Hob burners T o light a burner: l push the electric ignition push-button which is marked by a little spark symbol ( ); l at the same time turn the relevant control knob anticlockwise to maximum position; l then adjust the flame as required. If the burner does not ignite, turn the control knob to zero, and try ag[...]

5 Pan Supports and Wok St and To keep the pan supports in the correct position, they are hooked into hinges at the back of the hob. The pan supports can be lifted for easier cleaning, as shown in Fig. 1. To remove the pan supports completely, proceed as shown in Fig. 2. The pan supports and the Wok Stand are dishwasher proof. If washing them by han[...]

6 In the event of your appliance requiring service, or if you wish to purchase spare part s, please contact your local Electrolux Service Force Centre by telephoning: 0870 5 929929 Y our telephone call will be automatically routed to the Service Force Centre covering your post code area. For the address of your local Service Force Centre and furthe[...]

7 Electrolux Guarantee conditions W e, Electrolux, undertake that if, within 12 months of the date of the purchase, this Electrolux appliance or any part thereof is proved to be defective by any reason only of faulty workmanship or materials, we will, at our option, repair or replace the same FREE OF ANY CHARGE for labour , materials or carriage on[...]

8 BURNER RAPID SEMI-RAPID AUXILIARY (large) (m edium) ( small) POSITION M A X MI N M A X MIN M A X MI N M A X MI N NOMINAL THERMAL PO WE R kW 3.0 0.65 2.0 0.45 1.0 0.33 4.0 1.2 NOMINAL FLOW RATE m 3 /h 0.286 0.062 0.190 0.043 0.095 0.031 0.381 0.114 NOZZLE REFERENCE 119 Adjust. 96 Adjust. 70 Adjust. 146 Adjust. NOMINAL THERMAL PO WE R kW 2.8 0.65 2[...]

9 FITTING THE GAS HOB WITHOUT A COOKER HOOD ABOVE FITTING THE GAS HOB WITH A COOKER HOOD ABOVE 700 mm 400 mm 400 mm 100 mm 55 mm 50 mm 50 mm 600 mm 700 mm 400 mm 400 mm 100 mm 55 mm 600 mm 50 mm 50 mm FO 2369* FO 2231* Import ant safety requirement s This hob must be installed in accordance with the Gas Safety (Inst all ation and Use) Regulations ([...]

10 ON/OFF SWITCH FLEX OUTLET ON/OFF SWITCH FLEX OUTLET FO 2563 FO 2564 30 20 min 60 a b FO 2044 1 2 3 50 50 FO 2039 Dimensions are given in mm. Building In Building over a cupboard or drawer If the hob is to be installed above a cupboard or drawer it will be necessary to fit a heat resistant board below the base of the hob on the underside of the w[...]

11 Electrical connections Any electrical work required to inst all this hob should be carried out by a qualified electrician or competent person, in accordance with the current regulations. THIS HOB MUST BE EARTHED. The manufacturer declines any liability should these safety measures not be observed. This hob is designed to be connected to a 230-24[...]

12 Fault Finding Preliminary Electrical Systems Check A. EARTH CONTINUITY CHECK - Appliance must be electrically disconnected - meter set on W (Ohms) x 1 scale and adjust zero if necessary . a ) T est leads from any appliance earth point to earth pin on plug. Resistance should be less than 0.1 W (Ohm), check all earth wires for continuity and all c[...]

13 Ignition System / Gas Ignition YES Check plug top fuse and replace if necessary Check polarity and earth continuity of supply point Check earth continuity of appliance Ignitor does not spark Check fitting of burners Check position of the electrode Check by pass simmer adjusted Light burner manually Check gas supply at burner Check continuity fro[...]

14 Commissioning When the hob has been fully installed it will be necessary to check the minimum flame setting. T o do this, follow the procedure below . - T urn the gas t ap to the MAX position and ignite. - Set the gas tap to the MIN flame position then turn the control knob from MIN to MAX several times. If the flame is unstable or is extinguish[...]

15 Conversion from Natural Gas to LPG It is important to note that this model is designed for use with natural gas but can be converted for use with butane or prop ane gas providing the correct injectors are fitted . The gas rate is adjusted to suit. Method  Ensure that the gas tap s are in the 'OFF' position  Isolate the hob from t[...]

Grafiche MDM - Forlì CUST OMER CARE Electrolux 55-77 High S treet Slough Berkshire, SL1 1DZ T el: 08705-950950 © Electrolux plc 2003 02/03 The Electrolux Group. The worlds No.1 choice. The Electrolux Group is the world s largest producer of powered appliances for kitchen, cleaning and outdoor use. More than 55 million Electrolux Group produ[...]