JVC SP-UXP400 Bedienungsanleitung

MICRO COMPONENT SYSTEM UX-P400 —Consists of CA-UXP400 and SP-UXP400 INSTRUCTIONS GVT0128-003A [B] Cover[B].fm Page 1 Sunday, January 18, 2004 6:58 PM[...]

G-1 Warnings, Cautions and Others CAUTION—STANDBY/ON button! Disconnect the mains plug to shut the power off completely (all lamps and indications go off). The STANDBY/ON button in any position does not disconnect the mains line. • When the unit is on standby, the STANDBY/ON lamp lights in red. • When the unit is turned on, the STANDBY/ON lam[...]

1 Contents Introduction ........................................................ 2 Precautions .......................................................................... 2 How to Read This Manual .................................................. 2 Getting Started ................................................... 3 Step 1: Unpack ................[...]

2 Introduction Precautions Installation • Install in a place which is level, dry and neither too hot nor too cold—between 5°C and 35°C. • Install the System in a location with adequate ventilation to prevent internal heat buildup inside the System. • Leave sufficient distance between the System and the TV. • Keep the speakers away from [...]

3 Getting Started Step 1 : Unpack After unpacking, check to be sure that you have all the following items. The number in parentheses indicates the quantity of each piece supplied. • FM antenna (1) • AM loop antenna (1) • Remote control (1) • Batteries (2) If any item is missing, consult your dealer immediately. Step 2 : Prepare the Remote C[...]

4 Step 3 : Hook Up If you need more detailed information, see page 6. AUX LEFT RIGHT AUDIO OUT Illustrations of the input/output terminals below are typical examples. When you connect other components, refer also to their manuals since the terminal names actually printed on the rear may vary. Turn the power off to all components before connections.[...]

5 PUSH OPEN AU TO R EV ER S E FM antenna (supplied) Extend it so that you can obtain the best reception. AM loop antenna (supplied) Turn it until the best reception is obtained. Red White Connection.fm Page 5 Sunday, January 18, 2004 6:57 PM[...]

6 To assemble and connect the AM loop antenna To assemble the AM loop antenna To connect the AM loop antenna • If the AM loop antenna wire or speaker cords are covered with vinyl, remove the vinyl to expose the tip of the antenna by twisting the vinyl. • Make sure the antenna conductors do not touch any other terminals, connecting cords and pow[...]

7 Before Operating the System The indications on the display teach you a lot of things while you are operating the System. Before operating the System, be familiar with when and how the indicator illuminates on the display. 1 Rhythm Ax indicator • Lights when Rhythm Ax is activated. 2 Timer indicators • : lights when Daily Timer or Recording Ti[...]

8 Daily Operations —Playback 1 Turn on the power. The STANDBY/ON lamp on the main unit lights in green. • Without pressing STANDBY/ON , the System turns on by pressing one of the source selecting buttons in the next step. 2 Select the source. Playback automatically starts if the selected source is ready to start. • If you press AUX, start pla[...]

9 To tune in to a station While FM or AM is selected... Frequency starts changing on the display. When a station (frequency) with sufficient signal strength is tuned in, the frequency stops changing. • When you repeatedly press the button, the frequency changes step by step. To stop searching manually, press either button. If the received FM stat[...]

10 To select a track To select a group (MP3 only) Before starting playback... Group number and group name appear. To locate a particular portion While playing a disc, press and hold until the portion you want is reached. To locate a track directly and start play Playing Back a Tape To insert a tape You can play back tapes of types I, II, and IV. To[...]

11 Daily Operations —Sound&Other Adjustments Adjusting the Volume You can adjust the volume level from level 0 (VOL MIN) to level 40 (VOL MAX). To drop the volume in a moment Adjusting the Sound To emphasize rhythm feeling—RHYTHM AX This function emphasizes bass attack feeling, and also changes the subwoofer level. To adjust the tone You ca[...]

12 Changing the Display Brightness You can dim the display window. Setting the Clock Without setting the built-in clock, you cannot use Daily/ Recording Timers (see page 21) and Sleep Timer. • To exit from the clock setting, press CLOCK/TIMER as required. • To go back to the previous step, press CANCEL. 1 Activate the clock setting mode. • If[...]

13 Advanced Radio Operations Receiving FM Stations with RDS Radio Data System (RDS) allows FM stations to send an additional signal along with their regular program signals. • When tuned to an FM station which provides the RDS service, the RDS indicator lights on the display. This System can receive the following types of RDS signals. To show the[...]

14 3 Start searching. The receiver searches 30 preset FM stations, stops when it finds the one you have selected, and tunes in to that station. • If no program is found, “NOTFOUND” appears on the display. • To stop searching any time during search, press PTY SEARCH. To continue searching after it stops on an unwanted station While the indic[...]

15 Description of the PTY codes NEWS News. AFFAIRS Topical program expanding or enlarging upon the news—debate, or analysis. INFO Programs the purpose of which is to impart advice in the widest sense. SPORT Programs concerned with any aspect of sports. EDUCATE Educational programs. DRAMA All radio plays and serials. CULTURE Programs concerning an[...]

16 Advanced Disc Operations Programming the Playing Order— Program Play You can arrange the playing order of the tracks (up to 50) before you start playback. 1 Before starting playback, activate Program Play. 2 Select tracks you want for Program Play. 3 Start playback. 4 , 7 , ¢ CD 6 CD 0 CANCEL REPEAT CD 6 PLAY MODE 4 , 7 , ¢ Remote control Ma[...]

17 To check the programmed contents Before or after playback... To modify the program Before or after playback... To exit from Program Play Before or after playback... • Exiting from Program Play erases the stored program. Playing at Random—Random Play You can play all tracks at random. 1 Before starting playback, activate Random Play. 2 Start [...]

18 Playing Repeatedly—Repeat Play You can repeat playback. Before starting playback... While playing... To repeat a particular portion—A-B Repeat You can repeat a particular portion while playing back a CD. 1 During playback, activate A-B Repeat. 2 Select the start point (A). 3 Select the end point (B). A-B Repeat starts. The selected portion p[...]

19 Advanced Tape Operations Recording on a Tape You can use type I tapes for recording. • To play a tape, see page 10. 1 Insert a recordable cassette. 2 Check the tape running direction and Reverse Mode settings on the display. To change the direction To change the Reverse mode if necessary REV. MODE TAPE 2 3 7 CD 6 AUX FM/AM REC 7 CD 6 PUSH OPEN[...]

20 3 Select and start playing the source—“FM,” “AM,” “CD,” or “AUX.” • When recording a disc, you can also use “Synchronized Disc Recording” (see below). 4 Start recording. Synchronized Disc Recording You can start and stop both disc play and tape recording at the same time. To record the entire disc 1 Load a disc and insert[...]

21 Timer Operations Setting the Timer Using Daily Timer, you can wake up with your favorite song. On the other hand, with Recording Timer, you can make a tape of a radio broadcast automatically. • You can store three Daily Timer settings and one Recording Timer setting; however, you can activate only one of Daily Timers and Recording Timer at the[...]

22 3 Select the volume level. • You can select the volume level ( “ VOLUME 0 ” to “ VOLUME 40 ” and “ VOLUME – –” ). If you select “ VOLUME – – , ” the volume is set to the last level when the unit has been turned off. For Recording Timer: 1 Set the hour then the minute for on-time. 2 Set the hour then the minute for off-t[...]

23 To turn off the Timer after its setting is done Since Daily Timer is activated at the same time everyday, you may need to cancel it on some particular days. • Recording Timer can also be canceled temporarily. 1 Select the Timer you want to cancel. 2 Turn off the selected Timer. To turn on the Timer again, repeat the above steps and press in st[...]

24 Additional Information Learning More about This System Daily Operations—Playback (see pages 8 to 10) Listening to the Radio: • If you store a new station into an occupied preset number, the previously stored station in that number will be erased. • When you unplug the AC power cord or if a power failure occurs, the preset stations will be [...]

25 Troubleshooting If you are having a problem with your System, check this list for a possible solution before calling for service. General: Adjustments or settings are suddenly canceled before you finish. ] There is a time limit. Repeat the procedure again. Operations are disabled. ] The built-in microprocessor may malfunction due to external ele[...]

26 Specifications Amplifier section Output Power: 40 W (20 W + 20 W) at 4 Ω (10% THD) Speakers/Impedance: 4 Ω – 16 Ω Audio Input AUX: 400 mV/50 k Ω Tuner section FM tuning range: 87.50 MHz – 108.00 MHz AM (MW) tuning range: 522 kHz – 1 629 kHz CD player section Dynamic range: 88 dB Signal-to-noise ratio: 93 dB Wow and flutter: Immeasu[...]

SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been designed and manufactured to meet international safety standards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. Do read the operating instructions before you attempt to use t[...]

MEMO ME MO . f m Pag e 1 W e d n e sd ay , J an u ar y 21, 2004 6: 03 PM[...]

MEMO ME MO . f m Pag e 2 W e d n e sd ay , J an u ar y 21, 2004 6: 03 PM[...]

VICTOR COMPANY OF JAPAN, LIMITED 0104AIMMDWJEM EN © 2004 VICTOR COMPANY OF JAPAN, LIMITED UX-P400 MICRO COMPONENT SYSTEM Cover[B].fm Page 2 Sunday, January 18, 2004 6:58 PM[...]