Lennox Hearth PS40 Bedienungsanleitung

INST ALLA TION AND OPERA TION MANUAL Retain These Instructions For Future Reference Pe ll et S to ve s Mo de l W in sl ow ™ (P S4 0) Fr ee -S ta nd in g Pe ll et S to ve P/N 775 ,228 M, R ev . A, 05/2 007 A Fr ench man ual is a vail able upo n re ques t. O rder P/N 775 ,228 CF . Ce man uel d’i nsta llat ion est dis poni ble en fra ncai s, simp [...]

2 F ea tures a nd s peciFica tions .......................................................................................... 3 L isting i nForma tion ................................................................................................... 3 a ppearance c hoices ............................................................................[...]

3 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Features and Specifications i nst aLLation o ptions • Residential • V ented vertical and horizontal (see venting instruc - tions) • Manufactured home and mobile home • Thermostat or manual operation • Bedrooms h ea ting • Max. feed rate is 4.7 pounds/hour or 39,500 BTU/hour • Mi[...]

4 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Clearances to Combustibles Corner Installations Left Wall Horizontal V enting 8 Side V iew Front V iew 8 Side V iew Front V iew 26-1/4” (667mm) Front View 31” (7 87m m) 23-1/4” (5 91m m) 8-7/8” (2 25m m) Side View 8” (2 03m m) 3” (7 6mm ) 6-3/4” (1 72m m) 7” C/L 3” (7 6mm ) ([...]

5 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Corner Installations Continued Vertical V enting Parallel Installations Vertical V enting Alcove Installations Minimum alcove height is 41” (1041mm), minimum width is 42-1/4” (1073mm), and maximum depth is 48” (1219mm). Note, it is quite difficult to load pellets into the hopper when in[...]

6 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. h earth p rotection The floor protector must be a non-combustible material extending beneath the stove and to the front and sides as shown below . Minimum Size Hearth Protection v ent t ermina tion r equirements 1. Do not term inate the vent in any enclo sed or semi-e nclos ed areas such as a[...]

7 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. V ent Installation v ent t ermina tion L ocations A = Clearance above grade, veranda, por ch, deck, or bal- cony (min. 12”/30cm) B = Cl earan ce to wi ndow or door that may be opened (min . 12”/30cm above - 48”/1.2m below and to the side) C = Clearance to permanently closed window *(min.[...]

8 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. v enting Pellet pipe type PL or L must be used to vent the Winslow™ PS40 stove. Single wall pipe cannot be used with this pellet stove. The stove’ s flue collar is 3” in diameter . An approved wall thimble or approved ceiling firestop must be used when the pellet pipe passes through a [...]

9 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. m asonry c himney When venting into a masonry chimney , the pellet pipe can terminate just inside the chimney . However , it is recom - mended to run the pellet pipe to the top of the chimney . F irepLace When venting into a fireplace chimney , the pellet pipe can ter mina te just above the d[...]

10 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. m obiLe h ome i nst aLLations Th e fol lo wi ng are req uir ed fo r ins ta ll at io n of the Wi ns lo w™ PS 40 s tov e in m ob il e h om es . Se e F ig ur e 20 . 1. Connecting the Winslow PS40 stove to outside combus - tion air is optional, except in mobile home installations and when requi[...]

11 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Door T rim Installation Instructions Parts List (A): Qty (2) T rim Pieces (Gold, Nickel, Brushed Nickel or Black Nickel ) (6) #10 nuts (6) #10 washers T ools Needed: Qty (1) 3/8” nut driver or socket wrench CAUTION: Always ensure that plated surfaces are clean and free of fingerprints befo[...]

12 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. 4. Place one washer on each stud. Using a 3/8” nut driver , snug up the nuts on each piece of trim. Do not finish tightening the nuts yet. See Figure 27. 5. Ther e shoul d be app rox ima tel y a 7/8 ” (22m m) gap betw een the top edge of the upper trim and the top edge of the door and a [...]

13 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Door Grill Installation Instructions Parts Needed: Qty (4) Button Head Screws (already in place in stove) T ools Required: Qty (1) 1/8” allen wrench T o install the Grill: 1. Remove the four button head screws from body of the stove with a 1/8” allen wrench. See Figure 29. 2. Pull the scr[...]

14 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Note: The brick panel comes pre-painted with Metallic Black paint. The brick panel may be painted with any color of Stove Bright® high-temp paint (paint may dis - color with use). 1. Remove the front door of the pellet stove. T o remove the front door , open the two side panels, swing open t[...]

[...]

16 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Log Set installation Instructions Kit Contents (A): Part #H5142 Qty (1) left log (B) (1) right log (C) (1) front log (D) (2) log support brackets (E) A - Kit Contents cut lines B C D B C D E bracket in place correctly E Figure 38 Figure 39 Figure 41 Figure 40 T ools Required: None Caution: Th[...]

17 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Operation c ontroL b oard The control board regulates all functions of the stove. The following is a list of the board’ s components: • Feeding light - lights up when the auger is feeding pellets into the burn pot. • Ready Light - lights up when stove is ready to operate. Igniting Light[...]

18 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. s hut d own Normal - T o turn the stove off, turn the heat selector knob to off. The fans will continue to operate until the control board completes the shut down cycle. Power Outage - If the stove loses electrical power for less than 10 seconds it will continue to operate. If the power loss [...]

19 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Cleaning and Maintenance Unplug and let the Winslow™ PS40 stove cool before per - formi ng any mainten ance or clean ing. Some brands of pelle ts produce more ash and clinkers than others. Therefore the frequency of performing the following cleaning procedures depends to a great degree on t[...]

20 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. c Leaning the h ea t e xchanger Caution: Do not operate the heat exchange scraper when the stove is hot. Located at the center of the grill on the top front of the stove is a bent rod that is attached to a scraper on the heat exchange tubes. T o remove ash build-up and maintain efficient hea[...]

[...]

22 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. F ront d oor r emov aL Caution: Do not open the front door when the stove is hot. T o remove the door , swing the left and right side doors A open. Pull the front door handle B to the front and swing the front door open. Lift the front door up and off the hinges as shown in C in Figure 49. T [...]

23 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. b ack r emov aL and L ower c over p La te T o remove the back: 1. Remove the left and right side panels (see the previous page). 2. If the stove is connected to the vent pipe, loosen the four 5/32” allen head screws (see A in Figure 51) securing the lower cover plate beneath the flue outle[...]

24 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. d raFt a djuster The Winslow™ PS40 stove has a draft adjuster located at the left side of the stove direc tly in front of the combust ion blowe r . Should the stove installation require long runs of vent pipe, a situation may be created where excessive combustion air is flowing through the[...]

25 d iagnostic c odes If the stove operates abnormally , the ready light on the control board will signal the nature of the abnormal operation. The following is a list of possible signals or codes: Ready light is constant red Ignition Failure Ready light flashes red 1 short and 1 long blink Vacuum Switch Open Ready light flashes red 2 short blink[...]

26 e LectricaL g enera tor o peration Y our Winslow™ PS40 stove can be powered with a gas driv en elec trica l gerera tor . Howeve r , the genera tor’ s elec trica l regulator may not be compatible with the stove’ s electron - ics. The higher the quality of the gererator , the greater the chance that it is compatible with the stove. Orange So[...]

27 Y our Stove’ s Model Number __________________________________________ Y our Stove’ s Serial Number ___________________________________________ The Date On Which Y our Stove Was Installed _____________________________ Y our Dealer's Name _________________________________________________ Y our Dealer's Phone Number _________________[...]

Printed in U.S.A. © Lennox Hearth Products 2007 P/N 775,228M REV . A 05/2007 Lennox™ reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local distributor for fireplace code information. 1110 West T aft Avenue • Orange, [...]