Partner Tech EM-220 Bedienungsanleitung

EM-220 User Manual[...]

[...]

i Copyright This publication, including all photographs, illustrations and software, is protected under international copyright laws, with all rights reserved. Neither this manual, nor any of the material contained herein, may be reproduced without written consent of the author . Disclaimer The information in this document is subject to change with[...]

ii About this manual This manual is intended for system administrators who are familiar with setting up a new system and installing an operating system. The manual consists of the following sections: Chapter 1 Getting Started: This section covers unpacking and checking the package contents, identifying components, installing the battery pack, charg[...]

iii T ABLE OF CONTENTS CHAPTER 1 GETTING ST ARTED ................................................ 1 Unpacking the machine..................................................................................1 Checking the package contents ....................................................................2 Identifying components .....................[...]

iv T ips for T roubleshooting ...............................................................................37 General Problems ....................................................................................... 38 Having the EM-220 Serviced ......................................................................39 Specication ...............[...]

1 CHAPTER 1 GETTING ST AR TED This chapter describes the procedures from unpacking the EM-220, to powering it on. The following topics are described. • Unpacking the machine on page 1 • Checking the package contents on page 2 • Identifying components on page 3 • Installing the battery pack on page 8 • Charging the battery p[...]

2 C H A P T E R 1 G E T T I N G S T A R T E D Checking the package contents After you unpack the device, check that the following items are included. If any item is missing or appears damaged, contact your dealer immediately . AC adapter Driver CD with drivers and the user manual PDF le. EM-220 Metal Stylus Battery Power cord Protection pack Qui[...]

3 Identifying components This section describes the parts and connectors on the machine. Front view 1 2 3 4 5 6 7 9 8 Figure 1.2 Front view Component Description 1 Power indicator 2 Battery charging indicator 3 HDD status indicator 4 W iFi On/ Off indicator 5 Bluetooth On/ Off indicator 6 3.5G LAN On/Off indicator (optional) 7 Built-in Microphone 8[...]

4 C H A P T E R 1 G E T T I N G S T A R T E D Left view 1 Figure 1.3 Left view Component Description 1 5-in-1 media card slot 2 Express card slot 3 USB port 4 Power button 5 RJ45 LAN jack 6 DC IN 3 2 4 5 6[...]

5 Right view Figure 1.4 Right view 1 3 2 4 5 Component Description 1 VGA port 2 V entilation hole 3 USB port 4 Headphone jack 5 Microphone jack[...]

6 C H A P T E R 1 G E T T I N G S T A R T E D Rear view Figure 1.5 Rear view 1 3 3 2 1 Component Description 1 Speaker 2 Battery pack 3 Charger pin: connect to a cradle for char ging the battery . Do not short-circuit these 2 charger pins. A short-circuit may cause damage to the machine and present risks for electric shock or re. IMPORT ANT[...]

7 Bottom view Figure 1.6 Bottom view 1 2 1 3 4 5 6 7 Component Description 1 Mounting hole 2 Camera (optional) 3 Battery lock switch 4 Memory , W iFi module and 3.5G LAN module (optional) slots 5 Battery pack 6 HDD compartment 7 Battery release latch[...]

8 C H A P T E R 1 G E T T I N G S T A R T E D Installing the battery pack 1. Overturn the EM-220 so that the bottom is facing up toward you, as shown in the right. Slide the battery release latch to the unlock position. 2. Align EM-220 battery compartment pins to the battery connector . Slightly slide and press the battery pack into the compartment[...]

9 Charging the battery pack Plug the AC adapter power cord into an electrical outlet, then connect the DC plug of the adapter cable to the EM-220.Ittakesapproximately2–4hourstofullychargethebatteryforthersttime.Subsequentchar ges might take longer . IMPORT ANT T o protect and prolong the life [...]

10 C H A P T E R 1 G E T T I N G S T A R T E D Powering on The power button located on the left side of the EM-220, press the power button the turn it on. T o force power off , long press the power button for 4~5 seconds. NOTE[...]

1 1 CHAPTER 2 BIOS SETUP The primary function of the BIOS (Basic Input and Output System) is to identify and initiate component hardware. The BIOS parameters are stored in non-volatile BIOS memory (CMOS). CMOS contents don’ t get erased when the computer is turned off. The following topics are described in this chapter . • About the Setup Ut[...]

12 C H A P T E R 2 B I O S S E T U P Entering the Setup Utility When you power on the system, BIOS enters the Power-On Self T est (POST) routines. POST is a series of built-in diagnostics performed by the BIOS. After the POST routines are completed, the following message appears: Press DEL to run Setup Press the delete key <Delete> to access [...]

13 Using BIOS When you start the Setup Utility , the main screen appears. The main screen of the Setup Utility displays a list of the options that are available. A highlight indicates which option is currently selected. Use the cursor arrow keys to move the highlight to other options. When an option is highlighted, execute the option by pressing &l[...]

14 C H A P T E R 2 B I O S S E T U P Main Screen This screen includes System BIOS Information, Processor , System memory and displays the System T ime and System Date. System Overview This screen displays System BIOS Information, Processor , System memory , System T ime and System Date. System Time/ System Date The System T ime and System Date item[...]

15 Advanced Settings Thissetupscreenincludessub-menusforIDEConguration,USBConguration, ACPICongurations,MPS Congurations,SuperIOCongurationsandHardwareHealthConguration. ALL ON/ALL OFF/Customize This item allows users to on/off expansion modules. [All On] Enable BT , WLAN[...]

16 C H A P T E R 2 B I O S S E T U P IDE Conguration A T A/IDE Conguration ThisitemallowsuserstospecictheintegratedIDEcontroller . [Disabled] disables the integrated IDE controller . [Compatible] enables up to two IDE channels for operating systems requiring legacy IDE operation. [Enhanced] enables all SA T A and[...]

17 General ACPI Conguration Suspend mode Usethisitemtodenehowthesystemsuspends.Inthedefault,S1(POS),thesuspendmodeisequivalenttoa software power down. If you select S3(STR), the suspend mode is a suspend to RAM - the system shuts down with the exception of a refresh current to the sy[...]

18 C H A P T E R 2 B I O S S E T U P USB Conguration USB 2.0 Controller Mode ThisitemallowsyoutospecictheUSB2.0controllerinHiSpeed(480Mbps)orFullSpeed(12Mbps). Figure 2.6 USB Conguration sub-menu[...]

19 Boot Settings Thisscreenallowyoutocongurethebootoptions. Figure 2.7 Boot Settings screen[...]

20 C H A P T E R 2 B I O S S E T U P Boot Settings Conguration Figure 2.8 Boot Settings Conguration sub-menu Quick Boot Enabling this setting will cause the BIOS power-on self test routine to skip some of its tests during booting for faster system boot. Quiet Boot When enabled, system will boot without message. In contrast, when disabled, sys[...]

21 Boot Device Priority Use this screen to specify the order in which the system checks for the device to boot from. Figure 2.9 Boot Device Priority sub-menu 1st Boot Device 2nd Boot Device Set the boot device options to determine the sequence in which the computer checks which device to boot from.[...]

22 C H A P T E R 2 B I O S S E T U P Hard Disk Drives Use this screen to specify the boot sequence from hard disk drives. Figure 2.10 Hard Disk Drives sub-menu 1st Drive Use this item to view the hard disk drives in the system.[...]

23 Network Drives Use this screen to specify the boot sequence from network drives. Figure 2.1 1 Network Drives sub-menu 1st Drive Use this item to view the network drives in the system.[...]

24 C H A P T E R 2 B I O S S E T U P Security Settings Thisscreenallowsyoutocongurethesystemsecuritysettings. Figure 2.12 Security Settings screen Supervisor/ User Password Indicates whether a password has been set. If the password has been installed, Installed displays. If not, Not Installed displays. Set Supervisor P[...]

25 Chipset Settings ThisscreenallowyoutoconguretheNorthBridgeandSouthBridgechipsetoptions. Figure 2.13 Chipset Settings screen[...]

26 C H A P T E R 2 B I O S S E T U P North Bridge Chipset Conguration Figure 2.14 North Bridge Chipset Conguration sub-menu Internal Graphics Mode Select This feature controls the amount of system memory that is allocated to the integrated graphic process when the system boot up. Boot Display Device If you connect an external display to this [...]

27 Exit Saving Changes Highlight this item and press <Enter> to save the changes that you have made in the Setup Utility and exit the Setup Utility . When the dialog box appears, press <OK> to save and exit, or press <Cancel> to return to the menu. Exit Discarding Changes Highlight this item and press <Enter> to discard any [...]

28 C H A P T E R 2 B I O S S E T U P Discard Changes Highlight this item and press <Enter> to discard any changes that you have made in the Setup Utility . When the dialog box appears, press <OK> to discard changes and exit, or press <Cancel> to return to the menu.[...]

29 CHAPTER 3 UPGRADING COMPONENTS This chapter describes how to upgrade components for the EM-220. The following topics are described. • Safety and precautions on page 29 • Before you begin on page 30 • Upgrading the hard drive on page 31 • Upgrading the memory module on page 33 • Upgrading the Mini-PCIE card on page 34 Saf[...]

30 C H A P T E R 3 U P G R A D I N G C O M P O N E N T S Before you begin Make sure you have a stable, clean working environment. Dust and dirt can get into components and may cause malfunction. Adequate lighting and proper tools can prevent you from accidentally damaging the internal components. Mostoftheelectricalandmechanicalco[...]

31 Upgrading the hard drive Refer to the following to remove and replace the hard drive. 1. T urn off the EM-220. 2. Disconnect the AC adapter cable. 3. Overturn the EM-220. 4. Remove the two screws as shown in the right. 5. Open and remove the hard drive compartment cover . 6. Slide the hard drive to disconnect.[...]

32 C H A P T E R 3 U P G R A D I N G C O M P O N E N T S 7. Remove the hard drive. 8. Remove the four screws, then remove the hard drive out from the tray . T o replace the hard drive, reverse the above procedure.[...]

33 Upgrading the memory module Refer to the following to remove and replace the memory . 1. T urn off the EM-220. 2. Disconnect the AC adapter cable. 3. Overturn the EM-220. 4. Remove the two screws as shown in the right. 5. Open and remove the memory module compartment cover . 6. Locate the memory module, as shown in the right.[...]

34 C H A P T E R 3 U P G R A D I N G C O M P O N E N T S 7. Pop out the two silver latches holding the memory module into place. The module pops up. Grasp the outer edges of the memory module with thumb andforenger ,andthengently remove it. T o replace the memory module, reverse the above procedure. Upgrading the Mini-PCIE card Re[...]

35 6. Locate the Mini-PCIE card, as shown in the right. 7. Remove the screw on the Mini- PCIE card, Mini-PCIE will pop up 45 degree. 8. When it pops up, gently remove it. T o replace the Mini-PCIE card, reverse the above procedure.[...]

36 C H A P T E R 3 U P G R A D I N G C O M P O N E N T S[...]

37 APPENDIX This appendix describes locating and solving problems that you may encounter while using the EM-220. T roubleshooting Often after time spent troubleshooting, the problem is traced to something as simple as a loose connection. Checkthefollowingbeforeproceedingtotheproblem-specicsolutions. Tips for T roublesh[...]

38 A P P E N D I X General Problems Refer to the following general problems you may encounter . PROBLEM SOLUTION The display screen is dark. Make sure that the EM-220 is not in suspend mode. An incorrect date and time are displayed. Set the date and time in BIOS or Operation System. Cannot be turned off after crash. Long press the power button for [...]

39 Having the EM-220 Serviced If you are unable to solve the problem, you should have the terminal serviced. Pack the terminal in the original carton. (See “Unpacking the EM-220” on page 1.) Include a description of the problem and a checklistofthestepsyoutookwhentryingtoxtheproblem.Theinformationmay[...]

40 A P P E N D I X Specication Processor Intel ® A TOM N455 1.66GHz LCD 10.1” Active TFT color LCD, resolution 1024 x 600, or 1366 x768(option) T ouch 4-wire Resistive touch Memory DDR3 1GB Standard, Maximum 2 GB (1 x DDR3 SO-DIMM Slots) Ethernet On board LAN chip 10/100/1000 BASE-T Gigabit Ethernet Storage 2.5” type SA T A HDD I/O Interfac[...]