Radio Shack 43-3549 Bedienungsanleitung

OWNER’S MANU AL — Please read before using this equipment. © 2004 RadioShack Corporation. All Rights Reserved. RadioShack and RadioShack.com are trademarks used by RadioShack Corporation. www.radioshack.com SM Ten-Number Memory Dialing — lets you store up to ten numbers in memory for easy dialing. (See “Memory Dialing” on page 18.) Ample[...]

Introduction 2 INTRODUCTION Thank you for purchasing a RadioShack 5.8 GHz Cordless Telephone. Your phone uses advanced technology to give you superior audio quality and extended range. The phone’s Caller ID unit records each caller’s telephone number (and name, if available in your area) and the date and time of the call, as provided by your lo[...]

Important Information 3 IMPORTANT INFORMATION This telephone has been tested and found to comply with all applicable UL and FCC standards. FCC S TATEMENT Your telephone compiles with Part 68 of the FCC Rules.Upon request, you must provide the phone’s FCC registration number and REN to your phone company. These numbers are on the base unit. Your p[...]

Important Information 4 ringer operation is impaired, remove a device from the line. In the unlikely event that your phone causes problems on the phone line, the phone company can temporarily discontinue your service. If this happens, the phone company attempts to notify you in advance. If advance notice is not practical, the phone company notifies[...]

Important Safety Instructions 5 IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Do not use this product near water , f or example , near a bathtub, w ash bo wl, kitchen sink, or laundr y[...]

Important Caller ID Information 6 IMPORTANT CALLER ID INFORMATION To use Caller ID and Call Waiting, you must be in an area where those services are available and you must subscribe to those services through your local phone company. Where Caller ID is offered, one or more options are generally available: • caller’ s number only • caller’ s[...]

Installation 7 INSTALLATION Before using your phone, carefully peel the protective film off the display. The film protects the handset window during shipment and is not necessary for use. S ELECTING A L OCATION You can place the phone’s base on a desk or table, or mount it on a standard wall plate or directly on a wall. Select a location that is:[...]

Installation 8 O N A D ESK T OP 1. Plug one end of the supplied long modular cord into the TEL LINE jack on the bottom of the base. 2. Inser t the supplied AC adapter’ s barrel plug into the DC IN 9V jack on the bottom of the base and route the adapter’ s cord through the strain relief slot on the base. " " " " 3. Plug the o[...]

Installation 9 4. Plug the adapter into a standard A C outlet. And plug the modular cord’ s other end into a modular phone line jack. 5. F or a wall plate, align the base’ s ke yhole slots with the wall plate studs and slide the base downw ard to secure it. F or direct wall mounting, align the base’ s ke yhole slots with the mounting screws a[...]

Installation 10 4. Replace the cov er . To charge the battery pack, place the handset on the base face forward. The CHARGE/IN USE indicator on the base lights. ! Ô Recharge the battery pack when L L L L o o o o w w w w B B B B a a a a t t t t t t t t e e e e r r r r y y y y flashes on the display. Ô When you first use the phone after charging or [...]

Installation 11 The supplied battery pack should last about a year. If the battery pack does not hold a charge for more than two hours after an overnight charge, replace it with a new 3.6V, 600 mAh battery pack with a connector that fits the socket in the battery compartment. You can order a replacement battery pack through your local RadioShack st[...]

Operation 12 OPERATION M AKING AND R ECEIVING C ALLS Action Handset On Base Handset Off Base To answ er a call Pick up the handset (Auto T alk: On) Ô or pick up the handset and press TALK/FLASH (Auto T alk: Off). Press TALK/ FLASH , an y number , /TONE/< or #/> (Auto T alk: On) or press TALK/ FLASH (A uto T alk: Off). To make a call 1)Pick u[...]

Operation 13 A DJUSTING THE H ANDSET R INGER AND E ARPIECE V OLUME Handset Ringer Tone and Volume Press the volume up key or volume down key (labeled as, VOL/RING or VOL/ RING keys) in standby mode to select one of five ringer tones and volume combinations. R R R R i i i i n n n n g g g g T T T T y y y y p p p p e e e e A A A A H H H H i i i i g g [...]

Operation 14 T ONE D IALING S WITCH - OVER Some telephone companies use equipment that requires pulse dialing (sometimes referred to as rotary dialing). If you need to enter tone dialing digits, you can switch-over to tone dialing during the call. For example, entering your bank account number after you have called your bank. Ô Initially make your[...]

Operation 15 P AGE To locate the handset (while it’s off the base), press PAGE on the base. The handset beeps for 60 seconds. Paging is canceled when pressing PAGE on the base, any handset key or the handset is returned to the base. Ô F LASH AND C ALL W AITING If you have “Call Waiting” service and a call waiting tone sounds while you are on[...]

Operation 16 S ETTING M ENU O PTIONS There are five setup options available. They are Auto Talk, CIDCW (Caller ID on Call Waiting), Area Code, Dial and Language. Auto Talk allows you to answer the phone without pressing TALK/FLASH . If the phone rings when Auto Talk is On, simply remove the handset from the base and the phone automatically answers [...]

Operation 17 1. When the phone is in the standby mode, press and hold CID/MENU . The Caller ID setting screen appears. 2. Press VOL/RING key twice to select ¨ A A A A r r r r e e e e a a a a C C C C o o o o d d d d e e e e ¨. 3. Press SELECT . Ô 4. Use the number k eys ( 0 - 9 ), or DELETE/CH to enter the three-digit area code. 5. Press SELECT .[...]

Memory Dialing 18 • If you are not sure of y our dialing system, set f or tone dialing. Make a trial call. If the call connects, lea ve the setting as is, otherwise set f or pulse dialing. • If your phone system requires pulse dialing and you need to send the DTMF tones f or cer tain situations during a call, you ma y “s witch-over” to tone[...]

Memory Dialing 19 3. Press MEM or SELECT . 4. Press MEM or SELECT . The ¨ S S S S t t t t o o o o r r r r e e e e N N N N a a a a m m m m e e e e ¨ screen appears and a cursor flashes indicating that the displa y is ready f or the name to be entered. If “ E E E E d d d d i i i i t t t t M M M M e e e e m m m m o o o o r r r r y y y y X X X X X[...]

Memory Dialing 20 • Use REDIAL/PAUSE to enter a pause in the dialing sequence. The display shows a ¨ P P P P ¨. Each pause counts as one digit and represents a two second dela y of time between the digits. Ô • Use DELETE/CH to delete digits as needed. 8. Press MEM or SELECT . Y ou will hear a confirmation tone. Memor y stor age is complete.[...]

Memory Dialing 21 For example, to enter Movies. 1. Pick up the handset. Press MEM . 2. Enter a number or press VOL/RING or VOL/RING ke ys to select a memor y location. 3. Press MEM or SELECT . 4. Press MEM or SELECT . (When there is inf or mation already stored in the selected memor y location, ¨ E E E E d d d d i i i i t t t t M M M M e e e e m m[...]

Memory Dialing 22 M AKING C ALLS WITH M EMORY D IALING Memory Dialing from Standby Mode 1. Press MEM . The handset displays y our programmed memory locations. 2. Press VOL/RING or VOL/RING key s, or enter the n umber ( 1 - 0 ) to select the memor y location y ou would like to dial. Ô 3. Press TALK/FLASH . ¨ T T T T a a a a l l l l k k k k ¨ and [...]

Memory Dialing 23 An example of this is a bank account number. Once you have called your bank, and are prompted to enter the account number, press MEM and select the location number where the special number has been stored. Then press SELECT . Store your special number with an identifying name. (Refer to “Storing Phone Numbers and Names” on pag[...]

Memory Dialing 24 6. Press MEM or SELECT . The cursor flashes indicating that the displa y is ready f or the number to be edited. 7. Use the number k ey , /TONE/< , #/> , REDIAL/PAUSE or DELETE/CH to edit the phone number . The phone number cannot e xceed 20 digits. (See “Storing Phone Numbers and Names” on page 18.) If you don’t w ant[...]

Memory Dialing 25 The screen appears with the memor y location number that y ou have selected in the displa y . 4. Press MEM or SELECT . 5. Press VOL/RING key to mo ve the pointer down to ¨ D D D D e e e e l l l l e e e e t t t t e e e e M M M M e e e e m m m m o o o o r r r r y y y y X X X X X X X X ¨. 6. Press MEM or SELECT . The ¨ D D D D e e[...]

Memory Dialing 26 need to press TALK/FLASH . The phone will automatically dial the number stored.) If you subscribe to voice mail service, you can store your access number in this location. S TORING AND E DITING THE S PEED D IAL 1. When the phone is in the standby mode, press and hold SPEED DIAL . Ô If “ E E E E d d d d i i i i t t t t N N N N u[...]

Caller ID 27 4. Press VOL/RING key to mo ve the pointer to ¨ Y Y Y Y e e e e s s s s ¨. 5. Press SELECT or DELETE/CH . Y ou hear a confir mation tone . After about two seconds, the handset returns to the standby mode . CALLER ID You must subscribe to Caller ID service to use this feature. When the telephone rings, the Caller ID feature allows yo[...]

Caller ID 28 Y ou may receiv e any one of the f ollowing messages: 2. When you pic k up the phone, the displa y changes to ¨ T T T T a a a a l l l l k k k k ¨. (Auto T alk f eature is set to on.) V IEWING THE C ALLER ID M ESSAGE L IST The Caller ID list stores information for up to 30 incoming calls - even unanswered calls. Ô 1. Press CID/MENU .[...]

Caller ID 29 D ELETING I NFORMATION FROM THE C ALLER ID L IST The cordless phone stores up to 30 messages. If the phone receives the 31st message, the oldest one in the list is automatically deleted and the new est is stored. Caller ID message can also be deleted manually. Ô Deleting a Caller ID Message 1. Press CID/MENU . Display the message to b[...]

Caller ID 30 A tone sounds and all stored Caller ID messages are deleted. When the pointer is at ¨ N N N N o o o o ¨: The displa y retur ns to the summary screen. U SING THE C ALLER ID L IST Calling a Party from the Caller ID List You can place a call from the Caller ID list. The cordless phone stores up to 30 messages. Ô 1. Press CID/MENU . Sel[...]

Caller ID 31 Select the phone number to be stored from the Caller ID list by pressing VOL/RING or VOL/RING key s. 2. Press MEM . 3. Press VOL/RING or VOL/RING ke ys or enter a number ( 0 - 9 ) to select the memor y location to be stored. 4. Press SELECT . Ô Y ou hear a confir mation tone , and the number is stored in memory . The displa y retur n[...]

Additional Information 32 ADDITIONAL INFORMATION I NSTALLING THE B ELTCLIP To attach the beltclip Insert the beltclip into the holes on each side of the handset. Press down until it clicks. To remove the beltclip Pull both sides of the beltclip to release the tabs from the holes. H EADSET I NSTALLATION You can connect an optional headset with a 3 /[...]

Troubleshooting 33 TROUBLESHOOTING If your phone is not performing to your expectations, please try these simple steps first Problem Solution The CHARGE/IN USE indicator won’t illuminate when the handset is placed on the base. • Make sure the A C adapter is plugged into the base and wall outlet. • Make sure the handset is properly seated on t[...]

34 If you still have problems, disconnect the phone. If other phones on the same line work properly, the fault is in this phone or its installation. If you cannot find the problem, take the phone to your local RadioShack store for assistance. CARE Keep the phone dry; if it gets wet, wipe it dry immediately. Use and store the phone only in normal te[...]

35 NOTE 43-3549.fm Page 35 Tuesday, May 25, 2004 2:15 PM[...]

RadioShack Corporation Fort Worth, Texas 76102 43-3549 UCZZ01007BZ 05A04 Printed in China Limited One-Year Warranty This product is warranted b y RadioShack against manufacturing defects in material and wo rk manship under normal use for one (1) year from the date of purchase from RadioShac k company-owned stores and authorized RadioShac k franchis[...]