Renesas BP-272 Bedienungsanleitung

2004.3.1 SH7058 Group BP-272 User System Interface Board HS7058ECB61H User’s Manual Renesas Microcom puter Development Envi ronment System SuperH TM Fami ly/SH7050 Seri es Rev.3.00[...]

Cautions Keep safety firs t in your circuit des igns! 1. Renesas Technology Corp. puts the maximum effort into making s emiconductor products better and more reliable, but there is always the poss ibility that trouble may occur with them. Trouble with se miconductors may lead to pers onal injury, fire or property damage. Remember to give due cons i[...]

I IMPORTANT INFORMATION READ FIRST • READ this user's manual before using this user system interface board. • KEEP the user's manual handy for future reference. Do not atte mpt to use the user syste m interface boar d unt il y ou fully understa nd its mec h an is m. User Syst em Interf ace Bo ard: Thro ugho ut this d oc u ment, the t [...]

II LIMITED WARRANTY Renesas warrants its user s y stem interfa ce boar ds to be manufactured in accordance with published specifications and free from d efects in mater ial and/or workmanship. Renesas will re pair or replace a n y user sy stem interface boards dete rmined to be defective in mate rial and/or workmanship. User s ystem interface bo ar[...]

III State Law : Some states do not allo w the exclusion or li mitation of imp lied warranties or liability for incidental or consequential da mages, so the above limitatio n or exclusion may not apply to you. Thi s warr an t y give s yo u spec i fic le gal ri ght s, and you ma y ha ve ot her rig hts wh ic h ma y var y fro m state to state. The Warr[...]

IV SAFETY PAGE READ FIRST • READ this user's manual before using this user system interface board. • KEEP the user's manual handy for future reference. Do not atte mpt to use the user syste m interface boar d unt il y ou fully understa nd its mec h an is m. DEFINITION OF SI GNAL WORDS This is the safety alert sy mbol. It is u sed to a[...]

V W ARNING Observe the pr ecautions listed b elow. Failure to do so will result in a FIRE H AZARD and will damage the user system and the emul ator product or will r esult in PERSONAL INJURY. The USER PROGRA M will be LOST. 1. Do not repair or remodel the emul ator product by yourself for elect ric shock pre vention and quality assurance. 2. Always[...]

i Preface The HS7058ECB61H is a user s yst em in terface board that conn ects a user s yst em f or the SH7058 BP-272 packag e to the S H7058 E6000H em ulator (HS 7058EPH60H).[...]

ii Contents Section 1 Configuration ..................................................................................... 1 Section 2 Connection Procedures ...................................................................... 3 2.1 Connecting User Sy stem In terface Board to User Sy stem ................................................ 3 2.1.1 Ins[...]

1 Section 1 Configuration Figure 1 and table 1 s how the conf iguration an d compon ents of th e user sy stem interf ace board for the BP- 272 package. Please m ak e sure y ou hav e all of th ese com ponents w hen un packing . EV-chip board Spacer Screws (M2 x 8 mm) Board Pin 1 IC socket User system Figure 1 User S ystem Interface Board for the S H[...]

2 CAUTION Use a TQPACK256RD socket and CSPACK256Z202H01 (manufactured by Tokyo Eletech C orporation) for th e BP-272 package IC socket and IC socket connector on the user system. Table 1 HS7058ECB 61H Componen ts No. Component Quantity Remar ks 1 Board 1 2 IC socket 1 For the BP-272 package (installed on the user system): CSPACK256Z2021H01 3 Spacer[...]

3 Section 2 Connection Procedures 2.1 Connecting User System Interface Board to User System W ARNING Always switch OFF the user syst em and the emulator product before the USER SYSTEM INTERFACE CABLE is connected to or removed from any part . Before connecting, make sure that pin 1 on bot h sides are correctly aligned. Failure to do so will result [...]

4 (4) Notes on soldering the IC s ocket a) The IC socket is larger than the actual IC package; therefore, refer to figure 4 for the install ation of other components . b) Do not instal l components that occupy la rge volume close to the IC socket. Such components will prevent the convective flow of heat during reflow. c) Since the IC socket has a g[...]

5 CAUTION 1. Never dip the IC socket in flux or use wash to clean the IC socket. This is because flux may remain inside the IC socket due to th e IC socket’s structure. W hen using the IC socket with other DIP products, never clean the other DIP products with flux because the flux may enter the connector through the guide pins of the IC socket. 2[...]

6 2.1.2 Fastening I C Socket Connector CAUTION 1. Check the location of pin 1 before inserting. 2. Use a provided screwdriver. 3. Stop tightening when th e force required to turn th e screw becomes significantly greater th an that needed when first tightening. If a screw is tight ened too much, the screw head may break or an IC socket contact error[...]

7 2.2 Exchanging th e Spacer of th e EV-Chip Board While the user system interface board is connected to the user system, force mus t not applied to the user system. Exchange the spacer (2.6MP x 10 mm) of the EV-chip board with another spacer (2.6MP x 25 mm) provided for the user system interface board. EV-chip board Spacer (2.6MP x 25 mm) Figure 3[...]

8 2.3 Connecting User System Interface Board to EV-Chip Board W ARNING Observe the precautions listed below. Failure to do so will result in a FIRE HAZARD and will damage the user system and the emulator product or will result in PERSONAL INJURY. The USER PROGRAM will be LOST. 1. Always switch OFF the user syst em and the emulator product before th[...]

9 Connector No. UCN1 UCN1 UCN2 UCN2 Board EV-Chip Board Connector No. Board Connector No. EV-chip board Figure 4 Connecting User System Interface Board to EV-Chip Board[...]

10 2.4 Recomm ended Dimensions for User System Mount Pad (Footprint) Figure 5 sh ow s the recom men ded dimen sions f or the mou nt pad (footprin t) for the us er sys tem w ith an IC socket f or an BP-272 pack age (CSPA CK256Z 2021H01: m anuf actured by Tokyo Eletech Corporation). Note th at the dimen sions in figu re 6 are somew hat dif ferent f r[...]

11 2.5 Dimensions for EV-Chip Board and User System Interface Board The dimen sions f or the EV-chip board an d the us er sys tem in terface board are show n in fig ure 6. 120.0 5.0 8.0 100.0 84.0 Top view 16.0 100.0 84.5 69.0 34.5 50.0 65.0 70.0 Unit: mm Tolerance: ±0.5 mm EV-chip board Spacer 5.0 8.0 5.0 Figure 6 Dimensions for EV-Chip Bo ard an[...]

12 2.6 Resulting Dimensions after Connecting User System Interface Board The resulting dim ens ions, after con necting th e user sy stem interface board to th e user sy stem , are shown in figure 7 . IC socket (Tokyo Eletech Corporation CSPACK256Z2021H01) User system EV-chip board Spacer ( φ 6.0) 65.0 45.0 45.0 65.0 28.4 8.7 53.7 Unit: mm Toleranc[...]

13 Section 3 Verifying Oper ation 1. Turn on the em ul ator according to the procedu res described in th e SH7058 E6000H Em ulator User' s Manu al (HS7058EPH60HE). 2. Verify the user sy stem interf ace cable connections by check ing the pin states w ith the ex tended mon itor and checkin g the bus states w ith the FIL L com man d (emu lator co[...]

14  To use the crys tal oscillator mounted on th e EV-chip board Install a cry stal oscillator into the crys tal oscillator terminals on the EV- chip board. EV-chip board Crystal oscillator terminals Crystal oscillator Enlarged view X1 X2 Figure 9 Installing the Clock Oscillator[...]

15 Section 4 Notice 1. The MCU cannot be installed directly into the IC socket provided for connecting this user sy stem interface board. 2. Before connectin g any parts or cables, m ake su re that pin 1 on the both sides are correctly aligne d. 3. Do not apply excessiv e force to the user s ystem interf ace board wh ile it is connected to th e use[...]

SH7058 Group BP-272 User System Interface board HS7058ECB61H User's Manual Publication Date: Rev.2.00, November 20, 2003 Rev.3.00, March 1, 2004 Published by: Sales Strategic Planning Div. Renesas Technology Corp. Edited by: Technical Documentation & Information Department Renesas Kodaira Semiconductor Co., Ltd.  2003, 2004 Renesas Tech[...]

SH7058 Group BP -272 User System Interf ace Board HS7058E C B 61H U ser’ s Manual REJ10B0088-0300H[...]