Subaru Robin Power Products EHO25A Bedienungsanleitung

R ISSUE EMD-EU1717 2ZZ9020098 MODEL FOR EMISSION CERTIFIED ENGINE EH025/035取説_米国向 EU1717 02.5.15 11:39 AM ページ01[...]

NOTICE FEDERAL EMISSION COMPONENT DEFECT WARRANTY and CALIFORNIA EMISSION CONTROL WARRANTY are applicable to only those engines complied with EPA (Environmental Protection Agency) and CARB (California Air Resources Board) emission regulations in the U.S.A. AIR INDEX To show compliance with California emission regulations, a hangtag has been provide[...]

FEDERAL EMISSION COMPONENT DEFECT W ARRANTY EMISSION COMPONENT DEFECT WARRANTY COVERAGE This emission warranty is applicable in all States, except the State of California. Fuji Heavy Industries Ltd. and Robin America Inc., Wood Dale Illinois, (herein "ROBIN AMERICA") warrant to the initial retail purchaser and each subsequent owner, that [...]

*Consequential damages such as loss of time, inconvenience, loss of use of the engine of equip- ment, etc. *Diagnosis and inspection charges that do not result in warranty-eligible service being performed. *Any non-authorized replacement part, or malfunction of authorized parts due to use of non-autho- rized parts. OWNER’S WARRANTY RESPONSIBILITI[...]

CALIFORNIA EMISSION CONTROL W ARRANTY ST A TEMENT YOUR W ARRANTY RIGHTS AND OBLIGA TIONS The California Air Resources Board and Fuji Heavy Industries Ltd. are pleased to explain the emission control system warranty on your 2000 and later Small Off-Road engine(herein "engine"). In California, the engines must be designed, built and equippe[...]

LIMITED W ARRANTY on Emission Control Systems - California Only - Fuji Heavy Industries Ltd. warrant to the owner of the 2000 and later engine that the engine (1) has been designed, built and equipped so as to conform at the time of manufacture with the applicable regulations of the California Air Resources Board, and (2) is free from defects in ma[...]

(2) improper installation, adjustment or repair of the engine or of any warranted part unless performed by an authorized dealer . (3) failure to follow recommendations on fuel use contained in the 2000 and later Owner's Manual. (4) repairs performed outside of the authorized warranty service facility . (5) use of parts, which are not authorize[...]

(2) Ignition System (i) Spark plug (ii) Flywheel magneto (iii) Ignition coil (3) Miscellaneous Items Used in Above Systems (i) Hoses and sealing gaskets, bolts, connectors, and assemblies. I. MAINTENANCE ST A TEMENTS It is your responsibility to have all scheduled inspection and maintenance services performed at the times recommended in the 2000 an[...]

FOREWORD Thank you very much for purchasing a ROBIN ENGINE . Y our ROBIN ENGINE can supply the power to operate various sorts of machines and equipment. Please take a moment to familiarize yourself with the proper operation and maintenance procedures in order to maximize the safe and efficient use of this product. Due to constant efforts to improve[...]

CONTENTS 1. SAFETY PRECAUTIONS ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ 1 2. COMPONENTS ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ 4 3. PRE - OPERA TION CHECKS ・ ・ ・ ・ ?[...]

SYMBOLS Read the owner's manual. Stay clear of the hot surface. Exhaust gas is poisonous. Do not operate in an unventilated area. Stop the engine before refueling. Fire, open flame and smoking prohibited. On (Run) Plus ; positive polarity Off (Stop) Battery Engine oil Engine start (Electric start) Add oil EH025/035取説_米国向 EU1717 02.5.[...]

- 1 - EXHAUST PRECAUTIONS NNever inhale exhaust gasses. They contain carbon monoxide, a colorless, odorless and extremely dangerous gas which can cause unconsciousness or death. Never operate the engine indoors or in a poorly ventilated area, such as tunnel, cave, etc. Exercise extreme care when operat- ing the engine near people or animals. Keep t[...]

- 2 - SURROUNDINGS Operate the engine on a stable, level surface free of small rocks, loose gravel, etc. PROTECTIVE COVER Place the protective covers over the rotating parts. If rotating parts such as the drive shaft, pulley , belt, etc. are left exposed, they are potentially hazardous. To prevent injury , equip them with protective covers or shrou[...]

- 3 - PRE-OPERA TION CHECKS . Carefully check fuel hoses and joints for looseness and fuel leakage. Leaked fuel creates a potentially dangerous situation. Check bolts and nuts for looseness. A loose bolt or nut may cause seri- ous engine trouble. Check the engine oil and refill if necessary . Check the fuel level and refill if necessary . T ake car[...]

2. COMPONENTS - 4 - Stop switch Clutch Fuel tank Choke lever Carburetor Primer pump Starter handle Plug cover Air cleaner Fuel tank cap Muffler Oil gauge ( Oil filler ) Recoil starter Engine serial No. EH025 EH025/035取説_米国向 EU1717 02.5.15 11:39 AM ページ4[...]

- 5 - EH035 Plug cover Clutch Air cleaner Fuel tank cap Fuel tank Carburetor Choke lever Primer pump Starter handle Muffler Oil gauge (Oil filler) Recoil starter EH025/035取説_米国向 EU1717 02.5.15 11:39 AM ページ5[...]

3. PRE-OPERA TION CHECKS - 6 - CHECK ENGINE OIL Before checking or refilling engine oil, be sure the engine is located on a stable, level surface and stopped. Do not thread the gauge into oil filler to check oil level. If the oil level is below the lower level line on the dipstick, refill with the proper oil (see table) up to the upper level (up to[...]

4. OPERA TING YOUR ENGINE - 7 - ON ON OFF Pull the starter handle slowly , until resistance is felt. This is the "compression" point. Return the handle to its original position and pull swiftly . Do not pull out the rope all the way . After starting the engine, allow the starter handle to return to its origi- nal position while still hold[...]

- 8 - STOPPING OFF ON OFF 1 Set the throttle lever at the low speed position and allow the engine to run at low speed for 2 or 3 minutes before stopping. If the stop switch is installed on the engine.Set the stop switch to the position "OFF or O ". If the stop switch is installed on a machine side.Set the stop switch to the position "[...]

5. EASY TROUBLESHOOTING - 9 - WHEN ENGINE DOES NOT ST ART : Perform the following checks before you take the engine to your Robin dealer . If you still have trouble after complet- ing the checks, take the engine to your nearest Robin dealer . Is there enough compres- sion? 1. Pull the starter handle slowly and check if resistance is felt. 2. If lit[...]

- 10 - W ARNING W ipe out spilled fuel carefully before checking. Place spark plug as far away from spark plug hole as possible. Do not hold spark plug by hand while checking. 1. Remove the spark plug and connect it to the plug cap. Pull the starter handle while ground- ing spark plug against engine body using an insulated pliers. 2. T ry with a ne[...]

6. MAINTENANCE SCHEDULE - 11 - DAIL Y INSPECTION Before running the engine, check the following service items. PERIODIC MAINTENANCE Periodic maintenance is vital to safe and efficient operation of your engine. Check the table below for periodic maintenance intervals. IT IS ALSO NECESSAR Y FOR THE USER OF THIS ENGINE TO CONDUCT THE MAINTENANCE AND A[...]

- 12 - NOTE : Replace rubber hoses for passage every one year . If and when fuel leakage is found, replace hose at once. Periodic Maintenance Schedule table * Note 1 : Initial oil change should be performed after first twenty (20) hours of operation. Thereafter change oil every fifty (50) hours. Before changing oil, check for a suitable way to disp[...]

7. "HOW -TO" MAINTENANCE - 13 - INSPECTING THE SP ARK PLUG Clean off carbon deposits on the spark plug electrode using a plug cleaner or wire brush. Check electrode gap. Adjust gap 0.7 mm to 0.8 mm (0.03 inches) Use a proper spark plug : NGK CMR6A 0.7 to 0.8 mm (0.03 in.) ENGINE OIL CHANGE Initial oil change After 20 hours of operation Th[...]

- 14 - 3) Remove the oil gauge, then tilt the engine and drain the oil into a pan or other receptacle. 4) Put the engine on a level surface, then fill with the oil up to the point of overflowing the filler neck. Pour the oil in from a squeeze bottle or other appropriate. 5) After filling the engine with oil, rein- sert the oil gauge. Ensure that th[...]

- 15 - CLEANING FUEL FIL TER Remove the hose clamp and pull out the fuel filter from fuel pipe. W ash the fuel filter with kerosene. After washing, reassemble it. If the fuel filter is heavy dirty , replace it with new one. CLEANING AIR CLEANER Dirty air cleaner element will cause starting difficulty , power loss, engine malfunctions, and shorten e[...]

- 16 - FUEL PIPE REPLACEMENT Replace the fuel pipe every 1 year . If the fuel leakage is found on the fuel pipe, replace it immediately . CHECKING BOL TS, NUTS AND SCREWS Retighten loose bolts and nuts. Check for fuel and oil leaks. Replace damaged parts with new ones. Keep safety in your mind. EH025/035取説_米国向 EU1717 02.5.15 11:39 AM ペ?[...]

8. PREP ARA TIONS FOR ST ORAGE - 17 - ENGINE OIL Change the engine oil with fresh oil. Remove the spark plug, pour about 2 cc engine oil into the cylinder , slowly pull the starter handle of the recoil starter 2 or 3 times, and tighten the spark plug. CLEAN AND STORE Slowly pull the recoil starter handle until resistance is felt and leave it in tha[...]

9. SPECIFICA TIONS - 18 - MODEL EH025A Starting System Recoil starter Type Air-Cooled, 4-Stroke, Single Cylinder, Overhead valve, Gasoline Engine Fuel Tank Capacity 0.5 L Bore x Stroke 1.34 in. x 1.06 in. (34 mm x 27 mm) Carburetor Diaphragm type Displacement 1.49 cu. in. (24.5 cm 3 ) Valve Clearance (Intake & Exhaust) 0.0059 in. (0.15 mm) Note[...]

R EH025/035取説_米国向 EU1717 02.5.15 11:39 AM ページ19[...]

May 2002 CE- Y Y 500 PRINTED IN JAPAN EH025/035取説_米国向 EU1717 02.5.15 11:39 AM ページ21[...]