Tricity Bendix TBUF 100 Bedienungsanleitung

2222 724-72 TBUF 100 FREEZER OPERA TING AND INST ALLA TION INSTRUCTIONS[...]

Prior to Inst allation • Check the appliance for transport damage. Under no circumstance should a damaged appliance be installed. In the event of damage please contact your retailer . Inst allation • This appliance is heavy . Care should be taken when moving it. • It is dangerous to alter the specifications or attempt to modify this product i[...]

Servicing • This product should be serviced by an authorised engineer and only genuine spare part s should be used. • Under no circumstances should you attempt to repair the appliance yourself. Repairs carrier out by inexperienced persons may cause injury or serious malfunctioning. Contact your local Service Force Centre. At the end of the Appl[...]

4 ➀ ➀ Pilot light (green) ➁ ➁ Thermostat control knob ➂ ➂ Fast freeze light (yellow) ➃ ➃ Fast freeze switch ➄ ➄ W arning light (red) Operation Before use Remove all securing tapes. W ash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). Do not use soap or detergent as the smell may li[...]

The quick-freezing function can be ended manually at any time by pressing the b utton ➃ ➃ again. The yellow light goes out. This time can be shortened, depending on the quantity of food to be frozen. After the time has elapsed place the food to be frozen in the appliance's two top compartments; if freezing only a small amount of food, use [...]

Ice making The appliance is provided with one or more tra ys for ice-cubes tra ys. Fill the tra y(s) 3/4 full to give the ice space to e xpand and place them in the freezer compartment. T o release the ice cubes simply give the tra y a slight twist. Do not use sharp or metallic instr uments to remov e the tra ys from the freezer . Health and Safety[...]

7 Defrosting The freezer compartment will become progressively covered with frost. This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds 1/4". During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. However , when the ice becomes very thick on[...]

8 When the appliance is not in use When the appliance is not in use for long periods, disconnect from the electricity supply , empty all foods and clean the appliance, leaving the door ajar to prevent unpleasant smells. Maintenance and Cleaning W arning Before any maintenance or cleaning work is carried out, DISCONNECT the appliance from the ELECTR[...]

9 If after the above checks, there is still a fault, call your local Service Force Centre. In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown. Please note that proof of purchase is required for any in-guarantee service calls. Something[...]

10 Service and Sp are Part s In the event of your appliance requiring service, or if you wish to purchase spare part s, please contact your local Service Force Centre by telephoning:- 08705 929929 Y our telephone call will be automatically routed to the Service Force Centre covering your post code area. For the address of your local Service Force C[...]

St andard guarantee conditions We, EHP , undertake that if within 12 months of the date of purchase this T ricity Bendix a ppliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour , materials or carriage on condition that: ?[...]

12 W arning IF YOU ARE DISCARDING AN OLD APPLIANCE THA T HAS A LOCK OR CA TCH ON THE DOOR, YOU MUST ENSURE THA T IT IS MADE UNUSABLE TO PREVENT YOUNG CHILDREN BEING TRAPPED INSIDE. Depending upon the position which you choose for your appliance, you may wish to reverse the way in which the door opens. T o do this, refer to instructions under “Doo[...]

13 If you fit your own plug, the colours of the wires in the mains lead of your appliance, may not correspond with the markings identifying the terminals in your plug, proceed as follows: Connect the Green and the Y ellow (earth) wire to the terminal in the plug which is marked with the letter «E» or the earth symbol , or coloured green and yello[...]

14 Door reversal T o reverse the opening direction of the door , proceed as shown in the figures: Attention After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitt[...]

15 Building-in instructions Before carrying out any work, remove the plug from the power socket. Grid prep aration Left door opening: Remove the left side (A) of the grid cutting it from the rear (see figure). Right door opening: Remove the right side (B) of the grid cutting it from the rear (see figure). T o position the grid on the appliance proc[...]

16 B 4 1 5. Screw appliance into place and retain the cabinet with screws (I) through the securing brackets into the worktop or adjacent woodwork as necessary . If necessary , pads (E) are supplied for the rear feet to make sliding the appliance in and out of the recess easier . T o fit the pads, press them onto the rear feet. If required, the dime[...]

17 7 ab c C click click 8 b = = 9 I c M ö belt ü r Innenseite a Upper part of kitchen furniture panel I 27,5 cm 27,5 cm 55 cm 10 F 1 2 3 45 ° 11 = = 10 12 1 2[...]

18 Fitting the plinth Important For the efficient operation of the appliance, it is important that the original ventilation grid is used. • For an opening height dimension A=820 mm and a plinth height dimension a=100 mm, the plinth may be fitted without adjustments. The same applies to an opening height dimension B=870 mm and a plinth height dime[...]

[...]

922 822 673 T ricity Bendix, 55-77 High Street, Slough, Berkshire SL1 1DZ Consumer care telephone number……08705 950950 © Electrolux plc 2005[...]