Vermont Castings 2490 Bedienungsanleitung

Homeowner ’ s Installation and Operating Manual For use in the United States and Canada SAFETY NOTICE: IF THIS APPLIANCE IS NOT PROPERL Y INST ALLED, OPERA TED AND MAINT AINED, A HOUSE FIRE MA Y RESUL T . TO REDUCE THE RISK OF FIRE, FOLLOW THE INST ALLA TION INSTRUCTIONS. FAILURE TO FOLLOW INSTRUCTIONS MA Y RESUL T IN PROPERTY DAMAGE, BODIL Y INJ[...]

2 Vermont Castings Resolute Acclaim 2000893 Introduction Thank you for choosing a Vermont Castings Resolute Acclaim. Y our stove is one of the finest available. It features high efficiency , non-catalytic performance, using space-age refractory material and the precisely calibrated delivery of air to a concentrated charcoal bed to promote secondary[...]

3 Vermont Castings Resolute Acclaim 2000893 Range of heat output .............. 9,500-33,900 Btu's/hr.* EPA Emissions Rating .............. gph, noncatalytic 3.3* Maximum heat output ...................... 40,000 Btu's/hr.** Area heated*** ............ Up to 1600 sq. ft. (148 sq. m.) Fuel size/type ..................... 16" (410 mm) [...]

4 Vermont Castings Resolute Acclaim 2000893 Installation SAFETY NOTICE: IF YOUR RESOLUTE ACCLAIM IS NOT PROPERLY INSTALLED, OPERATED AND MAINTAINED, A HOUSE FIRE MAY RESULT. FOR SAFETY, FOLLOW ALL INSTALLATION, OPERATION AND MAINTENANCE DIRECTIONS. CONTACT LOCAL BUILDING OFFICIALS ABOUT RESTRICTIONS AND INSTALLATION INSPECTION REQUIREMENTS IN YOUR [...]

5 Vermont Castings Resolute Acclaim 2000893 Unused openings in an existing masonry chimney must be sealed with masonry to the thickness of the chim- ney wall, and the chimney liner should be repaired. Openings sealed with pie plates or wallpaper are a hazard and should be sealed with mortar or refractory cement. In the event of a chimney fire, flam[...]

6 Vermont Castings Resolute Acclaim 2000893 Single-wall Chimney Connectors • Beginning at the flue collar of the stove, assemble the chimney connector. Insert the first crimped end into the stove’s flue collar, and keep each crimped end pointing toward the stove. Using the holes in the flue collar as guides, drill 1/8" (3 mm) holes in the [...]

7 Vermont Castings Resolute Acclaim 2000893 A special piece called the “thimble sleeve,” slightly smaller in diameter than standard connector and most thimbles, will facilitate the removal of the chimney connector system for inspection and cleaning. Thimble sleeves should be available from your local dealer . To install a thimble sleeve, slide [...]

8 Vermont Castings Resolute Acclaim 2000893 Accessories are available for use as wall pass- throughs. If using one of these, make sure it has been tested and listed for use as a wall pass-through. U.S.: In the United States, the National Fire Protection Association (NFPA) has established guidelines for passing chimney connectors through combustible[...]

9 Vermont Castings Resolute Acclaim 2000893 Floor Protection A tremendous amount of heat radiates from the bottom plate of your Resolute Acclaim. The floor area directly under and around the stove will require protection from radiant heat as well as from stray sparks or embers that may escape the firebox. Heat protection is provided through the use[...]

10 Vermont Castings Resolute Acclaim 2000893 Keep the Stove a Safe Distance From Surrounding Materials Both a stove and its chimney connector radiate heat in all directions when operating. A safe installation requires that adequate clearance be maintained between the stove and nearby combustible materials to ensure that such materials do not overhe[...]

11 Vermont Castings Resolute Acclaim 2000893 5. Secure the extension plate and flue collar with the fasteners removed in the first step. Run the bolts in only finger-tight. Adjust the fit of the extension plate and/or flue collar if necessary . T ighten all four fasteners, but do not overtighten them. T est the action of the griddle; make any neede[...]

12 Vermont Castings Resolute Acclaim 2000893 (A) 15” (B) 24” (C) 15” (D) 8” (E) 13” (F) 8” (380mm) (610mm) (380mm) (200mm) (330mm) (200mm) (G) 15” (H) 24” (I) 15” (J) 8” (K) 13” (L) 8” (380mm) (610mm) (380mm) (200mm) (330mm) (200mm) (M) 15” (N) 10” N/A (O) 8” (P) 7” N/A (380mm) (250mm) (200mm) (180mm) (Q) 15” (R) 1[...]

13 Vermont Castings Resolute Acclaim 2000893 Stove Installed Parallel to Wall Stove Installed Parallel to Wall Stove in Corner Stove in Corner Unprotected Surfaces Protected Surfaces D E F F C C A B J K L L I I G H P Q M N N/A N/A T U V V S S Q R T op Exit, No Heat Shields T op Exit, Rear Heat Shield Only Rear Exit, Rear Heat Shield Only T op Exit,[...]

14 Vermont Castings Resolute Acclaim 2000893 Minimum W all Shield Requirements for Common Installations A B A = 48” (1220mm) B = 36” (910mm) ST602 Fig. 16 A rear-exit stove with reduced rear wall clearance only . A B C D E A E F A = 26” (660mm) B = 49” (1230mm) C = 44” (1 120mm) D = 36” (910mm) E = 1” (25mm) F = 23” (580mm) ST604 Fi[...]

15 Vermont Castings Resolute Acclaim 2000893 Distance from the Center of the Flue Collar to the W all in T op-Exit Installations The information on this page is helpful in planning stove placement for top-exiting installations, particularly those installations with chimneys that pass through the ceiling. However, this is not a clearance chart. Fina[...]

16 Vermont Castings Resolute Acclaim 2000893 Because of their restricted air flow and heat retention characteristics, specific construction requirements and special clearances apply to installations into alcoves. No stove or chimney connector heat shields are used in alcove installa- tions. Bottom heat shield requirements remain the same as for oth[...]

17 Vermont Castings Resolute Acclaim 2000893 Stove Controls Two Controls Operate the Stove The primary air control lever , located beneath the ashlip, regulates how much heat the stove produces by controlling the amount of air received by the fire. The more air supplied, the hotter the fire. (Fig. 27) With a travel range of about 6", the air c[...]

18 Vermont Castings Resolute Acclaim 2000893 Removable Andirons For Greater Front-Loading Convenience The andirons slip into pockets cast into the front of the bottom grate and can be removed when loading through the front door. (Most Acclaim owners, how- ever, prefer the convenience of “smokeless” top loading.) IMPORTANT: The andirons must be [...]

19 Vermont Castings Resolute Acclaim 2000893 firing rate of your heater by altering the air control adjustment range outlined in these directions. Use the following air control settings as a starting point to determine the best settings for your needs. Primary Air Settings Air Setting Air Control Position CLOSED Fully Left LOW Approximately 1"[...]

20 Vermont Castings Resolute Acclaim 2000893 5. Once the ember bed is formed, prepare the stove for high-efficiency operation. Load it with fuel, first with smaller splits of wood and then larger ones. Close the damper and set the primary air control lever to the "HIGH" position. Operate the stove for 15 - 20 minutes at this maximum air s[...]

21 Vermont Castings Resolute Acclaim 2000893 Rules for Open Fire Viewing WARNING: FOR SAFETY AND GREATEST EFFICIENCY, OPERATE YOUR STOVE ONLY WITH ALL DOORS/GRIDDLES FULLY CLOSED. THE TEST STANDARD FOR YOUR STOVE WHEN IT IS OPERATED IN THIS MODE IS UL 1482. YOUR STOVE MAY BE USED AS A FIREPLACE WITH THE FRONT DOOR OPEN OR REMOVED ONLY WHEN THE SPAR[...]

22 Vermont Castings Resolute Acclaim 2000893 Draft Management A stove is part of a system, which includes the chim- ney, the operator, the fuel, and the home. The other parts of the system will affect how well the stove works. When there is a good match between all the parts, the system works well. Wood stove operation depends on natural (unforced)[...]

23 Vermont Castings Resolute Acclaim 2000893 Creosote Creosote is a by-product of slow wood-burning. It’s an organic tar that can condense in the flue if it’s dense in the smoke, and slow-moving, and cools off to less than 290 ° F. Condensed creosote is volatile, and can generate chimney fires if it gets hot enough. All the features that affec[...]

24 Vermont Castings Resolute Acclaim 2000893 Maintenance Keep Y our Stove Looking New and W orking Its Best Care of the Cast Iron Surface An occasional dusting with a dry rag will keep the painted cast iron of your Resolute Acclaim looking new. A damp cloth may be used as well, but only when the stove is cool. Make sure no water remains on the stov[...]

25 Vermont Castings Resolute Acclaim 2000893 Repair Air Leaks to Prevent Overheating and Excessive Fuel Consumption Adjust the Door Latch The door gasket will compress after use. To restore a tight seal, adjust the tension on the latch: • Remove the Allen head button screw that attaches the door latch tab to the stove front. (Fig. 34) • Remove [...]

26 Vermont Castings Resolute Acclaim 2000893 Replace Broken Glass Immediately Do not operate the Resolute Acclaim if the glass is damaged. Use the following procedure for glass replacement. NOTE: Replace glass with Vermont Castings’ replacement glass only, available from your local dealer. • Open the door and carefully remove the glass by remov[...]

27 Vermont Castings Resolute Acclaim 2000893 Gaskets on Resolute Acclaim Stationary Parts 5/16" Between the flue collar and flue collar extension and the stove’s top and back: 5/16" The seal between the upper fireback corners and the lower fireback: 5/16" The seal between the underside of the top plate and the upper edge of the upp[...]

28 Vermont Castings Resolute Acclaim 2000893 When ignited, this creosote makes an extremely hot fire within the flue system which can damage the chimney and overheat adjacent combustible material. To reduce the amount of creosote that may form, remember to provide adequate air for combustion and to strive for small, intense fires rather than large,[...]

29 Vermont Castings Resolute Acclaim 2000893 V ermont Castings, Majestic Products reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice. 1 2 3 6 7 8 4 5 9 11 10 12 14 13 15 16 17 18 25 24 19 20 21 22 23 26 27 53 54 55 52 51 32 35 37 36 33 32 31 29 30 34 38 56 [...]

30 Vermont Castings Resolute Acclaim 2000893 Resolute Acclaim W oodburning Stove Model 2490 (continued) Item Description Part Number Item Description Part Number 19. Combustion Package 1602497 20. Sealing Plates (2) 1301859 21. Arch Brick Retainer 1600154 22. Left Arch Brick 1600151 23. Right Arch Brick 1600152 24. Rear Grate 1301851 25. Front Grat[...]

31 Vermont Castings Resolute Acclaim 2000893 4. This warranty does not cover a stove repaired by someone other than a Vermont Castings, Majestic Products Authorized Dealer. 5. Damage to the unit while in transit is not covered by this warranty but is subject to claim against the common carrier. Contact the Authorized Dealer from whom you purchased [...]

© V ermont Castings, Majestic Products 410 Admiral Blvd. • Mississauga, Ontario, Canada L5T 2N6 • 905-670-7885 www .majesticproducts.com • www.vermontcastings.com Ve r mont Castings, Majestic Products[...]