VIORE LCD22VH65 Bedienungsanleitung

%/! 22" HD LCD Television with Built-in DVD Ployer LCD22VH65 AIR (TV)/CABLE MODE SELECTION The Air/CABLE menu option is set to the "CABLE" (Cable Television) mode at the factory. If you want to use an antenna for the built-in TV tuner, this menu option must be set to the "Air" mode. Please refer to "6. Channel MENU&quo[...]

Contents Contents 2 Caution 3 Safety Information 4 Unit and Accessories 4 Product Feature 4 Introduction 5-7 1. Front View 5 2. Rear View 6 3. Remote Control 7 Connection 8-10 Basic Ope-ration 11 OSD Menu 1. Picture menu 2. Audio menu 3. Time menu 4. Setup menu 5. P.G menu 6. Channel menu Caution and DVD SIDE PANEL Features General Steps of setup m[...]

Caution The lightening flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of un-insulated "dangerous voltage" within the products enclosure that may be of sufficient magnitude to constitute a risk of electric shock to the persons. The exclamation point within an equilateral triangle i[...]

Sa et In brmadon Safety Information To ensure reliable and safe operation of this equipment, please read carefully all the instructions in this user guide, especially the safety information below. Electrical safety -The TVset should only be connected to a mains supply which matches that stated on the label on the mains adaptor -To prevent overload,[...]

Unit and Accessories and Product Feature unit anO Accessories TV set UserU$ Mahua| User's manual m_ii iJ @ 0 _i ii Remote control Batteries: 2xAA Product Feature - Inputs: RF, VIDEO, VGA, YPbPr, HDMI - DVD slot -Audio Input:AVAudio R/L, PC Audio - Support TV mode: NTSC-M,ATSC - Search TV: Auto/Manual - Auto-shutting down - Program exchange and[...]

Introduction introduction , Front View _J j-.. f= '_ SOURCE sou_cEi k _ MENU J MENU i F_ ' _ CH+ CH_ Fm IL _ CH i c. j ½_ voL, 1: Remote control sensor. 2: Indicator LED: GREEN POWER ON. RED ® STANDBY. The effective receiving range for the signal is 5-8 metres from the front of the remote control window, and 300 to the left or right[...]

Introduction 2 Rear View QTf" 1.AC POWER INPUT 2. HDMI INPUT 3, VGAINPUT 4. PC AUDIO INPUT 5. AV/S-VlDEO AUDIO INPUT 6. REARAUDIO INPUT 7. YPbPr INPUT 8.ANT Note: 1.AV, S-VlDEO and YPbPr share the Rear Audio input channel. 2. When HDMI port get DVl signal,the PC Audio channel will change to receive the audio from HDMI port. Wall Mounting The T[...]

REMOTE CONTROL ii @ @ @ @ @ @-- @ @@@@ 000e } @@@@ @ @ i@ Insert Batteries Into the Remote Control 1. Remove the battery cover. 2. Inserting the 2 AAA 1.5V batteries making sure the polarity (+ or -) of the batteries matches the polarity marks inside the unit, 3, Mount the battery cover, Replace with new batteries when the TV set begins to show the[...]

Connection Connection Power Cord Connection - Connect the power cord to a wall outlet as shown, and turn the switch (Page 6) on. - When you connect the power, the TV set comes into standby mode and the LED indicator (Page 5) lights red. -You can bring the TVout of standby mode by press the POWER button on TV set (page 5) or remote control(page 7), [...]

Connection Antenna cabJe connection AV Input ConnectionNote:AII cables shown are not included with the TV. V j" DVD VCR or RCAAudio Cable YPbPr Connection Note: All cables shown are not included with the TV. [ YPbPr Cabte DVD or VCR AudJ o Cab] e L V_ zzzzzz :::::::::::::::::::::::::::::::::::::::::::: i_ -9-[...]

Connection HDMI Connection Note:All cables shown are not included with the TV. ................................................ _ _ v _,62!4 _.................................. _ ........................... _ .................... [,_?F ?_Tf'_T .....................................................................................................[...]

Basic 0 eration Basic OSD Menu operation Press MENU button to display the OSD Use4i_ button to select the main menu, and press v button to enter the submenu.ln the submenu, useVAbutton to select the function item, and you could:adjust ("Contrast" item in Picture menu for example) with_l_ button; select ("Picture Mode" item in Pi[...]

OSD Menu 2.Audio menu Description Sound Mode: Select your desired sound mode as follow: Standard, Music, Movie, And personal. You may select the sound mode directly by pressing the SOUND Button on the remote control. Bass: control the intensity of low frequencies. Treble: control the intensity of high frequencies. Balance: Left and right stereo aud[...]

OSD Menu 4. Setup menu Description Menu Language: Select OSD menu language. Transparency: Turn on or off the transparency menu function. Aspect: Select the aspect mode between 16:9, Zoom, Cinema and Normal. Noise reduction: Select the noise reduction mode between Strong, Off, Weak and Middle. PC SETUP: If the video input signal comes from your PC, [...]

OSD Menu 5. P.G menu You must enter the password to gain access to the P.G menu. The default password is 6666. You may modify the following options: L?®so¢_Sfo# Change password: Change the password, you must enter the new password twice to confirm it. Note: Do not forget the password. P.G Switch: Allow you to turn on or off the system lock. If de[...]

OSD Menu MPAA: The Movie rating (MPAA) is used for original movies rated by the Motion Picture Association of America (MPAA) as broadcasted on cable TVand not edited for television. UseA_button to select N/A, G, PG, PG-13, R, NC-17 or X. Age No one 17 and under admitted. X is an order rating that is unified with NC-17 but may be encoded in the data[...]

OSD Menu 6. Channel menu L_esor_p#on Air/Cable: Allow you to select antenna between Air and Cable. If you selet Auto Scan: Enter the Auto Scan menu to start auto scan. If you select "Air" or "Cable" as input signal in Antenna item, you can press _button to search the channels automatically. The receivable channels will be stored[...]

OSD Menu Show/Hide:Allow you to show or hide the channels. Use_,_'button to highlight the desired item, then press OK button to show or hide the highlighted channel. Channel No.: Show and select the channel. Channel Label: Allow you to setup a label for the channel. Press ,_T button to select the position of the table, and press4_button to sel[...]

D VD OPERA TION Caution The DVD video player is A class t laser product. Use of controls or adjustments or performance of procedures other than those specified herein. May result in hazardous radiation Exposure. As the laser beam used in this DVD video player. Is harmful to the eyes, do not attempt to disassemble the Cabinet. Refer servicing to qua[...]

DVD OPERATION l. GeneraIStepsofsetupmenu 2. Setup items introduction A) Press the setup button, the main setup menu appears. 2.1 SYSTEM SETUP The system setup options are illustrated below: 2.1.1 TV SYSTEM According to the Color System of the TV, you can choose the TV System. B) Press the Left and Right arrow buttons to highlight the iconofthedesir[...]

DVD OPERATION 2.1.4 PASSWORD The password option is initially locked, and you can not set the ratings limit or change the password. In order for the Ratings feature to work, the password mode must be turned on. If you want to set the ratings limit, you will need to enter the default password. Which is 6666. then press Enter to confirm. To change th[...]

DVD OPERATION 2.2.3 SUBTITLELANG Highlight the SUBTITLE LANGoption, and press the Arrow buttons to choose the subtitle language you prefer. Press Enter to confirm. If the disc you are playing has that language available, it will display subtitles in that language. Note: The SUBTITLE LANGUAGE display is subject to sales country.. 2.4 VIDEO SETUP The[...]

DVD OPERATION 2.4.3 HUE Use the Up and Down arrow buttons to move the scroll and adjust the hue. 2.5 SPEAKER SETUP The speaker setup options are illustrated below: 2.5.1 DOWNMIX A)LT/RT Choose this setting when theDVD player is connected toa2Channel Analog Audio input. B)STEREO Choose this setting when the DVD player is connected toaTVor therefore [...]

DVD REMOTE CONTROL OPERATION _ 0-9 keys • These keys are used to input the time, as well as title, chapter and track numbers. • When a numeric item is displayed on the screen, press the 0-9 keys to select the desired entry, and press ENTER to confirm. • When a numeric item is larger than 9 press the GOTO key to select the display entry. _ UPI[...]

DVD REMOTE CONTROL OPERATION O% GOTO During pmayback, press GOTO show the current time counter position. Enter number to @_;' PREV Press PREV to skip to previous chapter or track. O _::_ DISPLAY ,, During playback, press DISPLAY to show the current time counter position. Enter number to choose the Play time. choose the title Total Chapter Ente[...]

DVD OPERATION Mp3 PLAYBACK When a MPEG and a Mp3 disc is loaded, the screen will be displayed as follows: Current directory name The p}aying file is a Mp3 audio file. Current MP3/JPEG file name, If a JPEG file is being played, the name should have a JPEG extension. File Switch Region: Displays the file type of the p}aying and the switching. The p}a[...]

DVD Trouble shooting If you have any questions, please consult the troubleshooting guide below: ® Ensure the power button is on. ® Ensure the power outlet is operational. • Ensure the power cord is not damaged. ® Ensure the power plug is connected firmly to the outlet. .... ...... ® Ensure the audio is not set to mute. ® Ensure you have set [...]

Viore,lnc. 7801 Hayvenhurst Avenue, Van Nuys,CA91406 Printed in China[...]