Whirlpool RJE-362B Bedienungsanleitung

Ehpool 304NCH FREE-STANDING ELECTRIC RANGE Model RJE-362B -3 1 Control Panel One-Piece + Chrome He /ii Reflector Bowls Model and Serial Number Plate Automatic Oven Light Switch Removable Copy Your Model and Serial Number Here[...]

Oven Signal Light Lock Light Clean Light Oven Temperature Cdntrol Knob Oven Selector Knbb Table of Contents Page BEFORE USING YOUR RANGE USING THE SURFACE UNIT CONTROLS USING THE OVEN CONTROLS l Baking...... l Broiling l Variable Broil Feature l Resetting the Oven Temperature Con&l Knob SETTING THE CLOCK TO THE CORRECT TIME OF DAY.. USING THE M[...]

Surface Unit Signal Light Clock Stop Time Knob Surface Unit Control Knobs Minite Timer Start Time knob Before using vour range IMPORTANT This is the only fine print you‘ll find in this booklet. Please read it to be sure you use your range as it was meant to be used. We build appliances to last. but we can’t control how they are used. Before usi[...]

PUSH IN and turn to setting. To bake, turn the Oven Selector Knob to BAKE To broil, turn the Oven Selector Knob to BROIL. Using the surface unit controls The Surface Unit Control Knobs must be pushed in before turning them. This helps avoid turning them on accidentally when wiping off the Control Panel. And it helps keep small children from turning[...]

ALWAYS broil with the door open about 4 inches (10 cm). loosen the Locking Screw Lower: move black part toward “LO.” One notch equals about 10°F (5%). Higher: move black part toward “HI.” One notch equals about 10°F (5 C). The following chart suggests broiling times and oven-rack po- sitions for different kinds of meats when the Oven Sele[...]

Clock and Timer Knob Minute Timer Setting the clock to the correct time of day 1 Push in the Minute Timer Knob and turn it clockwise to set the hands to the correct time of day. 2. The Minute Timer hand will turn as you set the clock. When the clock is set, let the knob pop out. Then, while it is out. turn the Minute Timer hand clockwise to “OFF?[...]

3. Push in and turn the Start Time Knob clockwise to the time you want the oven to start. 5. Turn the Oven Temperature Control Knob to the temper- ature you want to use to cook the food. 4. Push in and turn the Stop Time Knob clockwise to the time you want the oven to stop. 6. Set the Oven Selector to “TIMED.” When cooking is finished, turn bot[...]

Oven rack positions Your oven has two racks. Always put the racks where you want them to be before you turn on the oven. To remove a rack. take hold of it on the front edge and pull it out until It stops. Then lift LIP the front edge and pull again. It will slide past the stops, out of the guides and out of the oven. To put it back. tit the back co[...]

The oven vent There is an ol’en vent under the right rear surface element. When the ol’en is on. heated air will escape through it. A vent is needed for air circulation in the oven durtng baking. You can cook on this surface unit whtle the oven is on A warm pan of food will stay warm on this unit while the oven is on. It may be warm enough to m[...]

Setting the controls to the Self-Cleaning cycle: I CJeleclor I 1. Set the Oven Selector Knob to “CLEAN.” 2. Set the Oven Temperature Control Knob to “CLEAN.” 3. The clock and dials for start and stop time should all have the right time of day. 4. Push in on the Stop Time Knob and set it ahead as many hours as you want for the clean- ing cyc[...]

7. When the oven has cooled ojf all the way, wipe out any residue or ashes from the bottom. How the Self-Cleaning cycle works: l When oven controls are set to “CLEAN.” the oven gets much hotter than it does for cooking This high heat causes soil on the inside oven walls to burn oft or break up and mostly disappear While this is happening, a spt[...]

Special tips: l If the cleaning cycle doesn’t get the oven as clean as it should be. the time set for cleaning was probably not long enough. Set the cleaning time longer next time You can set it for more than 3 hours. if you warlt. l Plan to clean tht> oven hefore it gets too heavily soiled. Other- wise, you may r:iotice more smoke than you wo[...]

I , Terminal To remove surface unit, lift and pull straight out. Hold surface unit level when replacing. Removing surface units and reflector bowls: 1 First. be sure the Surface Unit Controls are all “OFF“ and that the surface units are (001. 2 Set) where the surface units plug into the range? Lift each surface unit about an inch (2 5 cm) at t[...]

PART WHAT TO USE HOW TO CLEAN Outslde of appliance Soft cloth. warm soapy water l Wipe off regularly when range is cool. Nylon or plastic scouring pad l Do not allow food containing acids (such as for stubborn spots vinegar. tomato. lemon juice or milk) to remain on surface. Acids will remove the glossy finish. l Do not use abrasive or harsh cleans[...]

If you need service or help, we suggest you follow these three stem: 1. Before you call for service*: If your range does not seem to be operating properly. check the following before calling for service If nothing operates: l Is the range pluggc>d into an operating outlet or wired into a live circuit with the proper voltage? (See Installation In[...]

You’ll find your nearest TECH-CARE service company listed in your local telephone book Yellow Pages under APPLIANCES-HOUSE- HOLD-MAJOR-SERVICE AND REPAIR. Should you not find a list- ing, dial free, the Whirlpool COOL-LINE R service assistance telephone number. When calling from: Michigan . . . . . . . . . . . . . . . . . . Dial (800) 632-2243 Al[...]