Yamaha CDR200tx Bedienungsanleitung

CDR200tx CDR-200tx POWER Recordable READ/ WRITE ON/ DISC VOL 6 2 READ WRITE User Guide Guide de I’utilisateur Bedienungsanleitung[...]

FCC INFORMATION (U.S.A.) 1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT! This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product. 2. IMPORTANT: When connecting this product to accessori[...]

T his output is value measured at a distance 200mm from the objective lens surface on the optical pick-up block. ANSI Class : Class 1 Material : GaAlAs Wavelength : 780-790 nm Emission Duration : Continuous Laser Output Power : Less than 44.6 µ W* * Laser Diode Properties CAUTION Use of controls or adjustments or performance of procedures other th[...]

Important Precautions i Impor tant Precautions Please read the follo wing precautions before operating CDR200tx. • Do not remov e the CDR200tx’ s top co v er . This de vice uses semiconductor laser . Refer all servicing to qualified personnel. • Do not attempt to touch the inside of the CDR200tx. Electricity may hav e been built up e ven aft[...]

Important Precautions ii Installation Precautions • Install CDR200tx on a le vel surface. • Do not install CDR200tx near water , in direct sunlight, close to heating units, or in areas subject to high or lo w temperature extremes, e xcessive dust, vibration, or se vere shocks. • Do not expose CDR200tx to e xtremes of humidity . • The ambien[...]

Important Precautions iii Operating Precautions • Do not subject CDR200tx to impact or shock when in use. This may impair recording or playback. • Do not place heavy objects on CDR200tx. • A void moving CDR200tx from cold to warm places, and av oid sudden room temperature rises, as condensation that could cause CDR200tx to malfunction may occ[...]

Preventing Premature Disc Failure iv Preventing Premature Disc F ailure The NUMBER ONE cause of premature disc failure with recordable CDs is contamination of the recording surface before recording is completed. T o minimize disc failure, use the follo wing disc-handling guidelines: • Keep the disc tray and disc as clean and dust-free as humanly [...]

Table of Contents v Table of Contents Introduction ............................................................................. 1 Accessories .................................................................... 1 CDR200tx Features ....................................................... 2 Orange Book Compatible Recording ...........................[...]

Introduction 1 Intr oduction Thank you for purchasing a Y amaha CDR200tx dri ve. Please read this manual before using the driv e in order to make the best use of the superior CDR200tx functions. After reading, please retain this man- ual for future reference. Accessories The package should contain the following items along with the dri ve. Check to[...]

Introduction 2 CDR200tx Features ■ 2xS Recording - 6xS Reading The CDR200tx is a CD-R OM recorder capable of recording at double speed (2xS), or normal speed (1xS). It can read discs at up to 6xS. ■ Compatible with Seven Diff erent Formats The CDR200tx can both record and read sev en different formats: CD-R OM, CD-ROM XA, CD-I, CD-D A, CD-Bridg[...]

Introduction 3 Orange Book Compatible Recording T rac k at Once In this mode, data can be recorded to disc one track at a time. Discs recorded in this mode cannot be played in CD players or CD-R OM driv es other than the CD-R drive until the session is closed. Multisession In this mode, data can be recorded to disc in stages (one session at a time)[...]

Chapter 1 - System Configuration 4 Chapter 1 - System Configuration In order to use the CDR200tx, you will require the following. For an IBM-PC computer with DOS or Windows The following operating en vironment is required: • An IBM/A T or compatible PC with a 486/33MHz or better CPU • A vacant slot in which to install a SCSI card or a pre-inst[...]

Chapter 1 - System Configuration 5 About Discs CD-R Discs On the CDR200tx, you can use con ventional CD-R discs that con- form to the Recordable Compact Disc Systems Part II (Orange Book). Y amaha recommends the follo wing Y amaha CD-R discs: > CDM12Y63 ( φ 120mm, 63 minutes) > CDM12Y74 ( φ 120mm, 74 minutes) > CDM12Y74M ( φ 120mm, 74 m[...]

Chapter 2 - Touring Around CDR200tx 6 Chapter 2 - T ouring Ar ound CDR200tx Front P anel 1 Disc tray The disc is inserted and ejected here. Pressing the eject button will open the tray . 2 Headphone jack This stereo mini jack allows you to connect headphones and listen to audio. 3 Headphone v olume control This control adjusts the volume le vel of [...]

Chapter 2 - Touring Around CDR200tx 7 Rear P anel 1 A C IN Connect the included power cable here. 2 CDR ID Use this switch to set a unique SCSI ID number for the CDR200tx. 3 TERMINA TOR This switch is used to set termination. Refer to the terminator setting section for details. 4 LINE OUT (L, R) These jacks are used to output audio to the amplifie[...]

Chapter 3 - Installing the Yamaha CDR200tx Drive 8 Chapter 3 - Installing the Y amaha CDR200tx Drive CDR200tx drive settings ♦ SCSI ID settings The SCSI ID number is used so that the computer will recognize a connected SCSI device. Y ou can assign 0 through 7 as the SCSI ID number . Usually , “7" is reserved for the SCSI card ID number , a[...]

Chapter 3 - Installing the Yamaha CDR200tx Drive 9 Cable Connection P ower cable Insert the power cable securely to the “ A C IN” connector on the rear panel. SCSI cable Connect the SCSI cable to either of the CDR200tx rear panel SCSI connectors (1) or (2), and connect the other end of the SCSI cable to the host computer . The CDR200tx is not s[...]

Chapter 4 - Operation 10 Chapter 4 - Operation Loading a Disc 1. Press the eject button to open the tra y . 2. Carefully place the disc, label-side up, on the disc tray . 3. Press the disc tray softl y or press the eject button a gain to close the disc tra y . Important: T ake great car e when handling CD-R OM discs. They ar e mor e sensi- tive to [...]

Chapter 4 - Operation 11 Ejecting the Disc If the CDR200tx is powered on: Press the eject button to eject the disc. Note: Y ou cannot eject the disc if the SCSI command prohibits the eject operation while the CDR200tx is r eading data. Caution: Be sur e to remove the disc after it is completely ejected. (T rying to r emo ve the disc befor e it is c[...]

Troubleshooting 12 T r oubleshooting If CDR200tx is not performing as expected, look up the symptoms in the follo wing table, then see what to do. Symptoms What to Do The power to the CDR200tx is of f • Check the AC po wer cable connection. The power to the computer is of f • Check to see if the SCSI card is correctly installed. The CDR200tx is[...]

Appendix 13 Specifications Specifications are subject to change without prior notice. Interface SCSI 2 Data Capacity 1.2m/sec: 666MB 1.4m/sec: 540MB Record/Read Speed 1xS (real-time), 2xS, 4xS(read), 6xS (read) Data T ransfer Rate 6xS: 900KB/sec 4xS: 600KB/sec 2xS: 300KB/sec 1xS: 150KB/sec Burst T ransfer Rate 4.2MB/sec (record asynchronous) 3.4M[...]

Appendix 14 Fr ont P anel Indicator Ke y ● on: green ✦ flashing: green — off ❍ on: orange ✧ flashing: orange Status ON/DISC Read/Write Reset —— Ready (no disc) ❍ — Inserting disc ✧ — Ejecting disc ✦ — Ready (disc inserted) ● — Seeking ●✦ Preparing to write ●✧ Writing ●❍ Writing (test mode) ●✧ Playback[...]

Y AMAHA CORPORA TION Electronic Systems Division VY75130-0[...]