Yamaha RX-485 Bedienungsanleitung

IMPORTANT! Please record the serial number of this unit in the space below. Model: Serial No.: The serial number is located on the rear of the unit. Retain this Owner’s Manual in a safe place for future reference. WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. The lightning flash with arrowhead [...]

2 1 Read Instructions – All the safety and operating instructions should be read before the unit is operated. 2 Retain Instructions – The safety and operating instructions should be retained for future reference. 3 Heed Warnings – All warnings on the unit and in the operating instructions should be adhered to. 4 Follow Instructions – All op[...]

1. IMPORTANT NOTICE : DO NOT MODIFY THIS UNIT! This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product. 2. IMPORTANT : When connecting this product to accessories and/or another produ[...]

4 Indoor FM Antenna AM Loop Antenna Remote Control Transmitter Batteries (size AA, R6, UM-3) SUPPLIED A CCESSORIES After unpacking, check that the following parts are contained. This product complies with the radio frequency interference requirements of the Council Directive 82/499/EEC and/or 87/308/EEC. The apparatus is not disconnected from the A[...]

5 ANTENNA CONNECTIONS ● Each antenna should be connected to the designated terminals correctly, referring to the following figure. ● Both AM and FM indoor antennas are included with this unit. In general, these antennas will probably provide sufficient signal strength. Nevertheless, a properly installed outdoor antenna will give clearer recepti[...]

6 Before attempting to make any connections to or from this unit, be sure to first switch OFF the power to this unit and to any other components to which connections are being made. A UDIO CONNECTIONS When making connections between this unit and other components, be sure all connections are made correctly, that is to say L (left) to L , R (right) [...]

7 * : Refer to “ ABOUT THE ACCESSORY TERMINALS ” on page 8. RX-385 R L A B 75 Ω UNBAL PHONO CD AUX A B FM ANT GND AM ANT TAPE PB REC OUT TAPE 1 SPEAKERS Video cassette player etc. Turntable Compact disc player Tape deck To AC outlet Speakers A Right Left Right Left Speakers B R L OUTPUT GND AUDIO OUT OUTPUT LINE IN LINE OUT 120V 50Hz 100W MAX[...]

8 Connect the SPEAKERS terminals to your speakers with wire of the proper gauge, cut to be as short as possible. If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is, + and – markings are observed. If these wires are reversed, the sound will be unnatural and [...]

9 1 Set to the “ ∞ ” position. 2 3 Select a desired input source. * The name of the selected input source will appear in the display. * Note that pressing on each input selector button selects the source which is connected to the corresponding input terminals on the rear panel. 4 Select the speakers to be used. * If you use two speaker system[...]

10 1 Select the source to be recorded. * To dub from tape to tape, refer to the “ Notes ” shown below. * When you select AUX , TUNER , CD or PHONO , be sure that TAPE 1 and/or TAPE 2 are not also selected. 2 Play the source and then turn the VOLUME control up to confirm the input source. (For detailed information on the tuning operations, refer[...]

11 Using the PURE DIRECT switc h RX-485 only You can enjoy the purest possible sound from your audio sources by setting this switch ON. By doing so, the audio signal bypasses the BASS , TREBLE , BALANCE and LOUDNESS controls, eliminating any alterations to the audio signal. When y ou listen with headphones Connect the headphones to the PHONES jack.[...]

12 FM/AM AM FM 1 Select the reception band (FM or AM) while watching the display. 2 3 Tune to a desired station manually. * To continue tuning search, press and hold the button. 1 Select the reception band (FM or AM) while watching the display. 2 3 To tune to a higher frequency, press the right side once. To tune to a lower frequency, press the lef[...]

13 1 1 Select the page where the preset station is stored. 2 2 Select the preset station number. 1 Tune to a desired station. (Refer to the previous page for tuning procedures.) 2 3 Select a desired page (A – E) of preset stations while watching the display. 4 Select a preset station number (1–8) while watching the display before “MEMORY” g[...]

14 A UT OMA TIC PRESET TUNING You can also make use of an automatic preset tuning function for FM stations only. By this function, this unit performs automatic tuning and stores FM stations with strong signals sequentially. Up to 40 stations are stored automatically in the same way as in the manual preset tuning method on page 13. T o store station[...]

15 1 Recall the preset station on E1 (by following the method of “To recall a preset station” on page 13). 2 3 Next, recall the preset station on A5 by following the same method with step 1. 4 Shows the exchange of stations is completed. EXCHANGING PRESET ST A TIONS You can exchange the places of two preset stations each other by easy operation[...]

16 REMO TE CONTR OL TRANSMITTER The remote control transmitter provided with this unit is designed to control all the most commonly used functions of the unit. If the CD player, turntable and tape deck connected to this unit are YAMAHA components, then this remote control transmitter will also control various functions of each component. KEY FUNCTI[...]

17 NO TES ABOUT THE REMO TE CONTROL TRANSMITTER Battery installation Battery replacement If you find that the remote control transmitter must be used closer to the main unit, the batteries are weak. Replace both batteries with new ones. Notes ● Use only AA, R6, UM-3 batteries for replacement. ● Be sure the polarities are correct. (See the illus[...]

18 If the unit fails to operate normally, check the following points to determine whether the fault can be corrected by the simple measures suggested. If it cannot be corrected, or if the fault is not listed in the SYMPTOM column, disconnect the power cord and contact your authorized YAMAHA dealer or service center for help. TR OUBLESHOO TING Ampli[...]

19 SPECIFICA TIONS AUDIO SECTION Minimum RMS Output Power per Channel 8 ohms, 20 Hz to 20 kHz, 0.04% THD < RX-485 > .....................................65W+65W < RX-385 > [U.S.A. and Canada models] .......45W+45W [Australia, U.K., Europe and General models] ..........................40W+40W 6 ohms, 20 Hz to 20 kHz, 0.06% THD < RX-48[...]

YAMAHA ELECTRONICS CORPORATION, USA 6660 ORANGETHORPE AVE., BUENA PARK, CALIF. 90620, U.S.A. YAMAHA CANADA MUSIC LTD. 135 MILNER AVE., SCARBOROUGH, ONTARIO M1S 3R1, CANADA YAMAHA ELECTRONIK EUROPA G.m.b.H. SIEMENSSTR. 22-34, 25462 RELLINGEN BEI HAMBURG, F.R. OF GERMANY YAMAHA ELECTRONIQUE FRANCE S.A. RUE AMBROISE CROIZAT BP70 CROISSY-BEAUBOURG 7731[...]