Zanussi MIXED FUEL COOKER ZCM 600 Bedienungsanleitung

MIXED FUEL COOKER ZCM 600 ZCM 610 INSTRUCTION BOOKLET Please read this instruction booklet before using the appliance GB[...]

2 Import ant Safety Information Y ou MUST read these warnings carefully before installing or using the hob. If you need assistance, contact our Customer Care Department on 0 8705 727727 Inst allation l This cooker must be installed by qualified personnel, according to the manufacturer s instructions and to the relevant British S t andards. l Thi[...]

3 This appliance is manufactured according to the following EEC directives: 73/23 EEC - 90/683 EEC - 93/68 EEC - 89/336 EEC - 90/396 EEC, current edition. Content s The following symbols will be found in the text to guide you throughout the Instructions: Safety Instructions S tep by step instructions for an operation Hin ts and T ip s Environmental[...]

4 Fitting the Splash back (only in model ZCM 610 X) A stainless steel splash back is supplied with the appliance. This is meant to be fitted on the rear edge of the cooker's hob. The splash back package is in the oven cavity . 1. Unpack the splash back and dispose of the packaging with due regard to safety and the environment. 2. Slide the two[...]

5 BACK LEFT FRONT LEFT FRONT RIGHT BACK RIGHT OVEN FUNCTION TEMPERA TURE MAINS ON THERMOST A T OVEN PROGRAMMER IGNITION STOP SET TIME PUSH BOTH - + Control Panel 1. Cooker Operation Pilot Light 2. Oven Thermostat Pilot Light 3. Electric ignition push button 4. Back left burner control knob (semi-rapid) 5. Fron t left burner control knob (rapid) 9 8[...]

6 Hob burners T o light a burner: - turn the relevant control knob anticlockwise to maximum position. - At the same time push the electric ignition button which is marked with a little sp ark. - Then adjust the flame as required. If the burner does not ignite, turn the control knob to zero, and try again. When switching on the mains, after installa[...]

7 Burner mi nim um maximum diameter diameter Large (rapid) 180 mm. 260 mm. Medium (semi-rapid) 120 mm. 220 mm. Small (Auxiliary) 80 mm. 160 mm. Oven Function Control Knob Oven Light - The oven light will be on without any cooking function Defrost Setting - This setting is intended to assist in thawing of frozen food. Fan cooking - This allows you t[...]

8 1. ( - ) DECREASE CONTROL & TIMER SETTING BUTTON 2 . ( + ) INCREASE CONTROL ( ) COOKPOT SYMBOL ( ) PUSH BOTH CLOCK SETTING SYMBOL 1. Set the time of day When the electricity supply is first switched ON, the display will flash 0.00 . See Fig. 1. Press buttons (1) and (2) together . The display will momentarily read 88.88 . See Fig. 2. Release [...]

9 2. The timer IMPORT A NT The timer can be used to time a set cooking period. At the end of the cook time the timer will automatically switch o ff the oven if in use. The timer gives an audible reminder at the end of any period of cooking up to 23 hours and 59 minutes. T o set, press button (1) and the display will read 0.00, see Fig. 6. Release b[...]

10 Hint s and Ti p s Condensation and steam When food is heated it produces steam in the same way as a boiling kettle. The oven vents allow some of this steam to escape. However , always stand back from the oven when opening the oven door to allow any build up of steam or heat to release. If the steam comes into contact with a cool surface on the o[...]

11 The air inside the oven is heated by the element around the fan situated behind the back p anel. The fan circulates hot air to maintain an even temperature inside the oven. The advantages of cooking with this function are: l Faster Preheating As the fan oven quickly reaches temperature, it is not usually necessary to preheat the oven although yo[...]

12 Runner positions are not critical, but make sure the shelves are evenly spread. When cooking more than one dish in the fan oven, place dishes centrally on the shelves rather than several dishes on one shelf. When the oven is full, you may need to allow slightly longer cooking time. A shelf may be placed on the floor of the oven. Place dishes on [...]

13 The oven fan operates without heat and circulates the air , at room temperature, inside the oven. This increases the speed of defrosting. However , please note that the temperature of the kitchen will influence the speed of defrosting. This function is particularly suitable for delicate food which could be damaged by heat, e.g. cream filled gate[...]

14 Grilling Grilling must be carried out with the oven door closed. The grill pan handles must be removed from the pan. How to Use the Grill 1. T urn the oven control function knob to . 2. Turn the thermostat control knob on the required tem- perature. 3. Adjust the grid and grill pan runner position to allow for dif ferent thicknesses of food. Pos[...]

15 Before any maintenance or cleaning can be carried out, you must DISCONNECT the cooker from the electricity supply . The Hob T o p The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool. Regularly wipe over the hob top using a soft cloth well wrung out in warm water to which a little was[...]

16 Before cleaning always allow the cooling fan to cool the oven down before switching off at the electricity supply . The oven should be kept clean at all times. A build-up of fat s or other foodstuffs could result in a fire, especially in the grill pan. Cleaning materials Before using any cleaning materials on your oven, check that they are suita[...]

17 Oven Cavity The enamelled oven cavity is best cleaned whilst the oven is still warm. W ipe the oven over with a soft cloth soaked in warm soapy water af ter each use. From time to time it will be necessary to do a more thorough cleaning, using a proprietary oven cleaner . If the soilage has become set, after the oven has cooled down, the followi[...]

18 If the aplliance is not working correctly , please carry out the following checks, before contacting your local Zanussi Service Centre. IMPORT ANT : If you call out an engineer to a fault listed below , or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. SYMPTOM n There is[...]

19 Zanussi guarantee conditions W e, Zanussi, undertake that if, within 12 months of the date of the purchase, this Zanussi appliance or any part thereof is proved to be defective by any reason only of faulty workmanship or materials, we will, at our option, repair or replace the same FREE OF ANY CHARGE for labour , materials or carriage on conditi[...]

20 ISLE OF LEWIS ND Macleod 16 James Street Stornoway Isle of Le wis P A87 2QW KELSO 2, 6 & 8 Woodmarket Kelso Borders TD5 7AX ORKNEY 7 King Street Kirkwall Orkney KW15 1JF PER T H Scottish Hydro Electric Central Warehouse Inveralmond (OWN SALES) Perth PH1 3AF SHETLAND 3-4 Carlton Place Lerwick Shetland (OWN SALES) ZE1 0PW SHETLAND Bolts Shetla[...]

21 To contact your local Service Force Centre telephone 08705 929 929 MIDLANDS BIRMINGHAM 66 Birch Road East Wyrley T rading Est ate Witton Birmingham B6 7DB BOURNE Pinfold Road Bourne PE10 9HT BRIDGNORT H 6 8 St. Mary s Street Bridgnorth Shropshire WV16 4DR GLOUCESTER 101 Rycroft S treet Gloucester GL1 4NB HEREFORD Un i t s 3 & 4 Bank Build[...]

22 Import ant Safety Requirement s This appliance must be installed in accordance with the Gas Safety (Installation and Use) Regulations (current addition) and the I.E.E. Wiring Regulations. Detailed recommendations are contained in the following British Standard Codes of Practice - B.S. 6172, B.S. 5440: Part 2 and B.S. 6891: Current Editions. Prov[...]

23 11 5 780 420 A B C D E Inst allation Fig. 1 Positioning the Appliance (Fig. 1) Note A: The appliance is designed to be flush fitted with 2mm clearance at each side to allow for it to be pulled forward for cleaning etc. Note B: The hotplate side trims should be flush with the cabinets and must not be below . Adjustable levelling feet at the front[...]

24 LEVELLING FEET PENCIL LINE ON THE FLOOR PLAN VIEW OF THE COOKER 580 mm. 100 mm. 300 mm. 295 mm. WALL F ACE A BACK OF COOKER SIDE VIEW OF THE COOKER BASE OF COOKER ENGAGEMENT EDGE FOR ST ABILITY BRACKET Fig. 3 Fitting the St ability Bracket (Not supplied) If the cooker has to be installed with a flexible supply pipe, it is necessary that a stabil[...]

25 Electrical connections Any electrical work required to install this cooker should be carried out by a qualified electrician or competent person, in accordance with the current regulations. THIS COOKER MUST BE EARTHED. The manufacturer declines any liability should these safety measures not be observed. This cooker is designed to be connected to [...]

26 Commissioning When the hob has been fully installed it will be necessary to check the minimum flame setting. T o do this, follow the procedure below . - T urn the gas tap to the MAX position and ignite. - Set the gas tap to the MIN flame position then turn the control knob from MIN to MAX several times. If the flame is unstable or is extinguishe[...]

27 Conversion from Natural Gas to LPG It is important to note that this model is designed for use with natural gas but can be converted for use with butane or propane gas providing the correct injectors are fitted and the gas rate is adjusted to suit. Method  Ensure that the gas taps are in the 'OFF' position  Isolate the hob from t[...]

Grafiche MDM - Forlì 35672-7602 07/01 CUST OMER CARE Zanussi 55-77 High S treet Slough Berkshire, SL1 1DZ T el: 08705 727727 © Electrolux Household Appliances Limited 2001 From the Electrolux Group. The world s No.1 choice. The Electrolux Group is the worlds largest producer of powered appliances for kitchen, cleaning and outdoor use. More [...]