ACTi D61A manual

Indoor Dome Series Hardware Manual D61A , D62A , D64A, D65A E62A, E63A, E64 A, E65A, E66A, E67A E68, E69 201 4/04/02[...]

w w w .a ct i. co m Hardware Manual 2 T able of Con tents Precautions ............................................................. 4 Safety Instructions .................................................................................... 6 Introduction ............................................................. 7 The List of Models .............[...]

w w w .a ct i. co m Hardware Manual 3 How to Adjust the Camera Vie wing A ngle and Focus .......................... 24 D61A, D62A, E66A, E67A Camera Models ........................................... 24 D64A, D65A, E62A, E63A, E64A, E65A, E68, E69 Ca mera Models .... 26 How to Replace the Dome Cov er ................................................[...]

w w w .a ct i. co m Hardware Manual 4 Precautions Read these instructio ns Y ou should read all the safety and op erating instructio ns before using this pro duct. Heed all warnings Y ou must adhe re to all the warnings on the produc t and in the instruction manual. Failure to follow the safet y instruction gi ven ma y directly endanger people, cau[...]

w w w .a ct i. co m Hardware Manual 5 Federal Communic ations Commission Statement This equipment has been tested and found to com ply with the limi ts for a class B digital device, p ursuant to Part 15 of the FCC Rules. T hese limits are desig ned to provide reasonable prote ction against harm ful interference in a r esidential installation. This [...]

w w w .a ct i. co m Hardware Manual 6 Safety Instructions Cleaning Disconnect this video prod uct from the po wer supply before cleaning. Attachments Do not use attachm ents not reco mm ended by the video product manufacturer as they may cause hazards. Do not use accessories n ot recommended b y the manufacturer Only install this device in a dry pl[...]

w w w .a ct i. co m Hardware Manual 7 Introduction The List of Models This hardware m anual contains the follo wing models: D61A 1 .3 MP Indoor Dome with SLLS, V ar i-f ocal lens D62A 2MP Indoor Dome with SLLS, V ari -focal lens D64A 1MP Indoor Dome with D/N , Adaptive I R, V ari-f ocal lens D65A 3MP Indoor Dome with D/N , Adaptive I R, V ari-f oca[...]

w w w .a ct i. co m Hardware Manual 8 Package Contents Camera (D61A, D62A, E66A, E67A) Camera Mounting Screw Kit Hexagon Screwdriver T erminal Block (for Audio a nd DI/DO) Drill T emplate Quick Installation Gui de War ranty Card Drill T emplate or[...]

w w w .a ct i. co m Hardware Manual 9 Physical Descri ption D61A, D62 A, E66A, E67 A D6 4A, D65 A, E62A , E63 A , E64 A , E65A, E66 A, E67A, E68, E69 NOTE: Actual cam era may slightly differ .[...]

w w w .a ct i. co m Hardware Manual 10 1) Ethernet Port Connects to a network using an Ethernet c able. 2) Memory Card Slot Insert a m emor y card into this slot f or local recording purposes. See How to Use a Memory Card on page 30 for m ore information. NOTE: Supports m icroSDHC and micr oSDXC cards. 3) Reset Button The purpose of reset b utton i[...]

w w w .a ct i. co m Hardware Manual 11 Mounting Options There are several m ounting options that you can use to install the cam era. Select the m ost suitable solution for your installation environm ent. Be lo w are some exam ples only . Mount T ypes Accessories Surface Mount Suitable when m ounting the cam era directly on walls or ceilings without[...]

w w w .a ct i. co m Hardware Manual 12 Mount T ypes Accessories Straight Wall Mount Suitable when m ounting the cam era on straight walls. PMAX-0308 (L- T ype Wall Mount) PMAX-0101 PMAX-0305 (Heav y Duty Wall Mo unt) V ertical Po le Mount Suitable when m ounting the cam era on vertical poles. PMAX-0101 PMA X-0305 PMAX - 0503 Horizontal Pole Mount S[...]

w w w .a ct i. co m Hardware Manual 13 Other Mounting Accessories Accessories PMAX-0104 (Extension T ube) NOTE:  For more inf ormation about the m ounting solutions and acc essories, please check the Mounting Accessory Selector in our website ( http://www .acti .com/m ountingselector ).  The above m ounting accessories are n ot included in th[...]

w w w .a ct i. co m Hardware Manual 14 Before Installa tion This section describes the procedures in preparing the externa l devices that you can connec t to the camera. Depend ing on your surveil lance needs, you m ay connect digital input (DI) or digital output (DO) or audio i nput / output devices to your camera. The cam era comes with one (1) t[...]

w w w .a ct i. co m Hardware Manual 15 The table below sho ws the DI/DO connec tion specifications: Device DI Connection design TTL - co m patible logic levels V oltage T o trigger (low) Logic level 0: 0V ~ 0.4 V Normal (high) Logic level 1: 3.1V ~ 3 0V Current 10mA ~ 100m A DO Connection design Transistor (Open Collector) V oltage & Curre nt &[...]

w w w .a ct i. co m Hardware Manual 16 High Voltage DO Device Connection Even though the cam era provides 12V po wer, this m ay not be enough for som e high voltage DO devices, such as a ceiling light or a m otor that opens o r closes a gate. In this case , there is a need to connect an ext ernal relay. See wirin g scheme belo w: Note that when cho[...]

w w w .a ct i. co m Hardware Manual 17 How to Connect A udio De vices Audio input / output de vices, suc h as an active micr ophone or speaker can be c onnected to the camera using the supp lied term inal block. Press and hold the orange tab as y ou insert the wire through the pin slot, then release the orange tab to secure the wire. T o connect au[...]

w w w .a ct i. co m Hardware Manual 18 Installing the Camera on a Surface This section describes the procedures in installing the cam era on a flat surface s uch as a hard or dropped ceiling and stra ight or tilted walls. Bef ore installation, m ake sure the wall or the ce iling can bear m ore than the weight of the cam era. NOTE: The camera im age[...]

w w w .a ct i. co m Hardware Manual 19 Step 2: Open the Dome Co v er NOTE: T o avoid scratches or leaving fingerpri nts on the dom e cover , it is rec ommended to r etain the plastic covering the dom e cover until the cam era is completel y installed. 1. W ith the bundled hex scr ewdriver , loosen the thr ee (3) screws securing the dome cover . 2. [...]

w w w .a ct i. co m Hardware Manual 20 4. If t he cables will be route d along the ceiling or w all , rem ove the cable tab from the dom e cover . 5. If t he cables will pass th rough the ceiling o r wall, route and pull the ca bles through the hole on the surf ace. Step 3: Install the Ca mera to th e Surface 1. If necessary , insert a m emory card[...]

w w w .a ct i. co m Hardware Manual 21 CAUTION: When u sing electric screwdri vers, be careful not to t ouch the cam era components while attaching the screws. Since electric screwdrivers vary in sizes, speed, and force, they ma y bruise and dam age the camera com ponents. DISCLAIMER: ACTi will not be responsib le for cam era damage caused b y im p[...]

w w w .a ct i. co m Hardware Manual 22 Step 5 : A cce ss the Camera Live View See Accessing the Cam era on page 31 for m ore information on ho w to access the Live View of the camera. Step 6: A dj ust the Viewing A ngl e and Focus Based on the cam era live view , adjus t the viewing ang le, orientation and f ocus of the cam era. Adjustments vary de[...]

w w w .a ct i. co m Hardware Manual 23 3. Tighten the three (3) scre ws to attach the dome cover to th e camera bo d y. 4. Rem ove the plastic coverin g the dome cover . Final installation s hould look similar to the illustration b elow .[...]

w w w .a ct i. co m Hardware Manual 24 Other Adjustments and Accesso ries How to Adjust the Camera Viewing Angle and Focus This section describ es procedures in a djusting the pan direction of the cam era , as well as the viewing angle and focus , if neces sary since the cam era comes with the focus and viewing ang le already pre-fixed. D 61 A , D6[...]

w w w .a ct i. co m Hardware Manual 25 1. Loosen the tilt adjustm ent screws, adjust the tilt, and t hen tighten back the screws to fix the tilt position. 2. Turn the rotation adjustm ent to rotate the viewing orientati on. 3. Loosen the pan adjustm ent screw , m ove the pan direction, an d then tighten back the screw to fix the pan pos ition. 4. I[...]

w w w .a ct i. co m Hardware Manual 26 D64A, D65A, E62A , E63A , E64A, E65A, E68, E69 Camera Models Camera Parts Overview Adjustment Procedur es 1. Loosen the tilt adjustm ent screws, adjust the tilt, and t hen tighten back the screws to f ix the tilt position. 2. Turn the rotation adjustm ent to rotate the vie wing orientation. 3. Loosen the pan a[...]

w w w .a ct i. co m Hardware Manual 27 How to Replace the Dome Co ver For more disc rete surveillance needs, th e bundled dom e cover can be replaced wi th a sm oke, vandal proof cover a vailable for purchase. T o replace the dom e cover , do th e following: 1. Loosen the three (3) scr ews to open the dom e cover . 2. Rem ove the three (3) s crews [...]

w w w .a ct i. co m Hardware Manual 28 4. Rem ove the shroud fr om the dom e cover . 5. Place the shroud on the re placement dome c over . 6. Insert the replacem ent dome cover into the co ver housi ng. 7. Align and attach the three ( 3) screws to secure the bracket to the cov er housing.[...]

w w w .a ct i. co m Hardware Manual 29 8. Attach the dome cover to th e camera b y tightening the three (3) scre ws. Final installation should look sim ilar to the illustration belo w .[...]

w w w .a ct i. co m Hardware Manual 30 How to Use a Memory Card The camera s upports local video recor ding or saving of snapshots to a m emory card. NOTE: Supports m icroSDHC and micr oSDXC cards. How to Insert the Memory Card Insert a mem ory card into the card slot with the metallic c ontacts facing down the c amera. Push the card until it click[...]

w w w .a ct i. co m Hardware Manual 31 Accessing the Camera Configure the IP A ddresse s In order t o be able t o com municate w ith t he cam era from your PC, b oth the c amera a nd the PC have to be within the same network segment. In most cases, it m eans that the y both sho uld have very s imilar IP addresses, where onl y the last num ber of th[...]

w w w .a ct i. co m Hardware Manual 32 Double-click on the cam era model name, the default browser of the PC is autom atically launched and the IP address of the target cam era is already f illed in the addres s bar of the br owser . If you work with our c ameras regularl y , th en ther e is even a bette r w ay t o discover the cam eras in the netw[...]

w w w .a ct i. co m Hardware Manual 33 Use the default IP address of a c amera: If there is no DHCP server in the give n network, the us er ma y have to ass ign the IP addresses to both PC and cam era manually to m ake sure the y are in the same network segment. W hen the camera is plugged into network and it does not detect a ny DHCP ser vices, it[...]

w w w .a ct i. co m Hardware Manual 34 Manually adjust the IP ad dresses of multiple cam eras: If there are more than 1 cam era to be used in the same local area network and there is no DHCP server to assign u nique IP addresses to each of them , all of the cam eras would then have the initial IP address of 192.168.0.100 , which is not a pro per si[...]

w w w .a ct i. co m Hardware Manual 35 Access the Ca mera Now that the cam era and the PC are both ha ving their unique IP addresses an d are under the same network segment, it is possible to use the Web browser of the PC to access the cam era. Y ou can use an y of the brow sers to access the camera, howe ver , the full f unctionality is provided o[...]

w w w .a ct i. co m Hardware Manual 36 The following examples i n th is manual ar e based on Internet Explorer brow ser in orde r to cover all functions of the camera. Assum ing that the camera ’ s IP address is 192.168.0.100 , you can access it by opening the W eb browser and t yping the following addres s into Web browser ’ s address bar: htt[...]

Copyright © 2014, A CTi Corporation A ll Rights Reserved 7F , No. 1, Alle y 20, Lane 407, Sec. 2, Ti-Ding Blvd., Neihu Distr ict, T aipei , T aiwan 1 14, R.O.C. TEL : +886-2-26 56-2588 F AX : +886-2- 2656-2599 Email: sales@acti.c om[...]