Audiovox APS-995C manual

Model APS-995C Owner ’s Manual IMPORT ANT ! In order to provide you with the highest level of security to your vehicle, this system is equipped with selectable manual override circuitry . It is possible that you will need to override you security system if the transmitter becomes lost, or inoperative due to battery failure. Reading the sections o[...]

Page 2 w Protected Push Button V alet/Override Switch w 7-Function LED-Arm / Disarm / Zone 1 / Zone 2 / Zone 3 / V alet / Arming w Intrusion Alert With Memory w Instant Siren Activation w Starter Disable Output w Additional Engine Immobilizer Output, (Optional Relay Required) w T rue Last Door Arming (Hardwire Only) w Defective Zone By-Pass w Defec[...]

Page 3 known as a code grabber , which will receive and store the signal from your keychain transmitter and re-transmit at a later time to disarm your system. Y our Keeloq Code Hopping transmitters will change their signal every time the button is pressed, so when a thief grabs then re-transmits your signal, the alarm system will not respond. If yo[...]

Page 4 þ Siren will not sound. If the siren sounds 3 chirps, then you have left a door , trunk, or hood lid ajar . Simply close the opened entry point to provide full protection o Doors Lock - Optional NOTE: If the optional Headlamp illumination feature has been added, and has been selected for operation when arming, as an added convenience, the s[...]

Page 5 þ Any mild impact to the vehicle’ s glass will cause the alarm to sound a short series of warning tones. þ Any strong impact to the vehicle’ s glass will cause the alarm to trigger for the full 30 second alarm cycle. NOTE: If the optional interior illumination circuit was installed, the interior light will flash as well for the full 30[...]

Page 6 The LED will start flashing rapidly , indicating that the system is re-arming automatically . Open any door to suspend the automatic arming. þ Parking Lights flash two times. If the parking lights flashed three times, then the alarm was triggered in your absence. Before turning the key on, examine the LED to identify which zone was triggere[...]

Page 7 When the system is in valet mode, all alarm functions are bypassed, however the remote panic feature and remote door locks will remain operational. In addition, the parking lights will flash to indicate locking and unlocking. T o use the valet mode, the system must first be disarmed either by using your keychain transmit- ter or by activatin[...]

If the new code was accepted, the unit will report back the newly entered code, by flashing the LED, first indicating the 10ths digit, pause and then the units digit. The unit will report the new code three times with a one second pause between each code, then the system will begin arming. If the LED flash pattern reports the previously stored code[...]

1. Enter the vehicle and turn the ignition switch to the on position. NOTE: The siren will sound. 2. Within 5 seconds, press and release the pushbutton switch 1 time. 3. Within 5 seconds, turn the ignition switch off then on. 4. Within 5 seconds, press and release the pushbutton switch 1 time. 5. Turn the ignition switch off then on and start the v[...]

R F SHOCK SENSOR MODE SELECTION The way in which your alarm system reacts to threatening vibrations, created by attempts to enter the vehicle by breaking a window , is adjustable by the transmitter immediately after arming. There are 4 modes of operation that can be selected by the operator: 1. Normal Operation (default mode) In this mode, any stro[...]

3. Within 10 seconds, move the control switch off, on, off, on (2 switch cycles) to select a 2 hour start timer . After 10 seconds expire, the parking lights will flash and the siren will chirp 2 times confirming that the two hour start cycle is set. Or, within 10 seconds move the control switch off, on, of f, on, off, on, of f, on (4 switch cycles[...]

the only means to keep the engine and engine fluids warm is to periodically start the engine. W ARNING! Be certain that the vehicle is outdoors before using this or any remote vehicle starting device. A running engine produces dangerous car- bon monoxide fumes which can be harmful or fatal if prolonged expo- sure occurs. DO NOT remote start the veh[...]

o Remote Electric Trunk Release o Remote Car Starter o Remote Window Closure o Remote Garage Door Interface NOTE: In addition there may be a second optional feature connected to your system that when the same transmitter button is pressed and released 2 times within 3 seconds (double pressed), the second optional feature will acti- vate. This outpu[...]

Page 14 ADDITIONAL REMOTE FUNCTION ( CHANNEL 6 ) Channel 6 is an alternate output that can be controlled by the unlock button of the transmitter , or by and independent button or combination of buttons. For your vehicle this output is: Controlled By: o Trunk/Key Button o Option Button o Lock + Unlock Buttons o Lock + Trunk/Key Buttons o Lock & [...]

Page 15 TRANSCEIVER ICONS AND THEIR INDICA TIONS When Disarmed, Press the Arm/Lock button to Lock and Arm the System. The Lock Icon is displayed on the LCD panel & the parking lights flash once. When Armed, Press the Disarm/Unlock button to Unlock and Disarm the System. The Unlock Icon is displayed on the LCD panel & the parking lights flas[...]

The following trigger patterns will be displayed. Triggered and the entry attempt was made to one of the vehicle doors. Triggered and entry attempt was made to the vehicles hood or trunk. Triggered and entry attempt was made to the vehicles glass, or the vehicle has been hit or bumped hard enough to cause a response from the vibration detec- tor . [...]

ADDITIONAL REMOTE FEA TURES: The two way remote control unit allows you to access status information from the vehicle, check temperature, light the display , toggle the transmitter from beep tones to vibrate mode, initiate daily start timer , and temperature start. Selection of these and other features are shown below: NOTE: Transmitter must be wit[...]

If you require more frequent starting please refer to auto start up timer mode shown earlier in this guide. NOTE: T o insure accurate 24 Hour Start up, it is advisable to reset the start time periodically as time may drift slightly each day . Page Call Out: From within the vehicle, if the valet push button is pressed for three seconds, the alarm un[...]

[...]

© 2002 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, NY 11788 128-6425 APS 995C SYSTEM FUNCTIONS A T A GLANCE DASH LED INDICA TORS RAPID FLASHING = P ASSIVE ARMING/ACTIVE REARMING SLOW FLASHING = ARMED OF F = DISARMED ON S OL ID = V ALET MODE 3 FLASH...P AUSE = INTRUSION ZONE 3 2 FLASH...P AUSE = INTRUSION ZONE 2 1 FLASH...P AUSE = INTR[...]