Clifford concept 50x manual

Owner' s Manua l World-Clas s Aut o Securit y T M concep t 50 x[...]

The Concept 50x is covered by one or more of the following Clifford Electronics U.S.A. patents: 4,158,874; 4,233,642; 4,327,444; 4,383,242; 4,430,685; 4,845,464; 4,887,064; 4,890,108; 4,922,224; 4,997,053; 5,081,667; 5,146,215; 5,157,375; 5,467,070 and other patents pending.[...]

Table of Contents Standard Features of the Concept 50x . . . . . . . . . . . . . . . . . . . . . . . 2 Your 4-button/12-channel remote controls . . . . . . . . . . . . . . . . . . . . . 6 How to use your keychain remote control . . . . . . . . . . . . . . . . . . . . . . . 6 What each button/channel does . . . . . . . . . . . . . . . . . . . . . . [...]

Standard Features of the Concept 50x ✔ Lifetime Warranty — For as long as you own the vehicle, Clifford will repair or replace the control unit and remote controls free of charge (see warranty card for full details). ✔ FA CT — F alse A larm C ontrol and T est — One of many patented Clifford innovations, FA CT absolutely, positively ends r[...]

Standard Features of the Concept 50x (cont.) ✔ Remotely Adjustable Dual-Zone Proximity Sensor — Two sensor zones provide full protection: If someone is lurking near your car, the system will sound a warning tone. But if a thief actually leans into the passenger compartment, the system will instantly blast the siren. It is impervious to wind and[...]

Standard Features of the Concept 50x (cont.) ✔ Remote Window/Sunroof Closure Capability — On certain vehicles (including several models of Mercedes Benz, Jaguar, V olkswagen and BMW), the system ’s integrated timer and an optional relay can be used to automatically close the power windows and sunroof every time you remotely arm your system. ?[...]

Standard Features of the Concept 50x (cont.) ✔ Patented Smart Auto Testing — Automatically tests all system triggers and sensors every time you remotely arm and warns you if you accidentally arm your Concept 50x system with the hood or trunk open. If there is a genuine trigger or sensor malfunction, the system will specifically identify the pro[...]

Your 4-button/12-channel remote controls The 4-button/12-channel remote controls are ultra-sophisticated miniature radio transmitters powered by a tiny 12-volt battery. Range is up to 30 meters. A weak remote control battery will reduce range. Electrical interference and even sunspots can interrupt the signal from your remote control to the system.[...]

What each button/channel does Your Concept 50x remote controls come pre-programmed so that certain channels command certain functions. If you wish, you can actually assign any channel to any function (see pages 16-20). The following chart indicates what each remote control channel number does, and how to transmit each channel number. Factory settin[...]

TO SILENTLY ARM OR DISARM THE SYSTEM . . . . . . . Press button 3 (channel 3). Your Concept 50x system will arm or disarm with all the indications noted above except for the chirp acknowledgments. TO REMOTELY TURN ON A TIMED ACCESSORY . . . . . . Button 2 (channel 2) controls an electronic interlock that lets you separately command two functions wi[...]

How to interpret the chirps and indicator light flashes When you use the remote, the system responds with chirps and indicator light flashes: Chirps and flashes Meaning 1 Your system is disarmed 2 Your system is armed 2 and then 4 Armed but there is a door open or the sensor is malfunctioning (see Smart AutoTesting on page 13) 3 Disarmed but there [...]

UltraSecure™ Coded Valet Mode In seconds, thieves can disable all other alarm brands by hotwiring the ignition and flicking an easy to find “hidden” valet switch. Your system has safeguards that absolutely ensure a thief cannot enable the valet mode as a way of “turning off” your system. How? To enable valet mode, the driver must first en[...]

To exit valet mode 1. Turn the ignition switch to its “ON” position or start the engine. 2. Flick the switch back to its center position. The LED will turn off to confirm that the system is now in its normal operating mode. Setting your own secret valet code Since all Concept Series systems have the same factory-set code, it is highly advisable[...]

Remote controlled valet mode entry and exit You can even enable or exit valet mode with your remote control simply by transmitting channel 9 (LevelShift twice, then button 1). In addition to the above indications, two parking light flashes will confirm that you have remotely enabled valet mode, while a single flash confirms exiting of valet mode. R[...]

Built-In Two-Point AutoImmobilizer Thirty seconds after you turn off the ignition, the system’s built-in two-point AutoImmobilizer electronically disengages your vehicle’s starter motor and electronic fuel pump to ensure against theft of your vehicle. The LED Status Indicator will repeatedly flash to indicate that AutoImmobilization has been ac[...]

Automatic malfunction bypass In the event of a component malfunction, the system will automatically bypass any faulty point and arm all other triggers and sensors to provide the utmost possible protection until you can have the system serviced by your local Authorized Clifford Dealer. If you accidentally armed with the hood, trunk or a door open, j[...]

Smart Self-Powered Siren with Unbreachable Digital ComLink This siren has its own built-in back-up battery, so even if a thief cuts all the wires, the siren will continue to wail. Furthermore, this unique Clifford-designed and manufactured siren has all these important additional enhancements: Unbreachable Digital ComLink: Clifford’s ingenious Di[...]

User-selectable features Your Concept 50x allows you to set many of its features to your own personal preferences. Although the system’s capabilities are extensive, we made the programming procedures very simple: to make a change, you just flick the PlainView switch a few times. Once you’ve changed a few settings, you’ll find that programming[...]

EXAMPLE 1: Turn on AutoArm & Lock When the system AutoArms (see page 9), it does not normally lock the doors to ensure that you cannot accidentally lock the keys inside the vehicle. To enable this feature, you’ll note that “AutoArm & Lock” is in column 3, row 2 of the table on pages 19-20. The “ off ” in bold type indicates the fa[...]

4. Note that the QuietChirps feature is in the same column 2, row 5. Simply press the momentary side 5 times.. After a brief pause, you’ll hear two chirps to confirm that the QuietChirps feature is now on. 5. To exit the program mode, turn the ignition off . You’ll hear 3 chirps to confirm program mode exit. You just made three programming chan[...]

Table of user-selectable features: 1 chirp = OFF, two chirps = ON. Feature Select Column 1 1st latched Column 2 2nd latched Column 3 3rd latched Column 4 4th latched Row 1 1st momentary Add new remote to channel 1 info on page 9 NOTE 1 AutoLock on /off info on page 12 AutoArming: on /off info on page 11 Sound 1: on /off info on page 16 Row 2 2nd mo[...]