Creative 920 Slim manual

[...]

1 Chapter 1 Attention 1-1 Safety Precautions……….....................…....…..…...2 1-2 How to Maintain Y our Camera…….........……..........2 1-3 Before Using Y our Camera…….............……...........2 1-4 Package Contents……… ........................… ……..…...3 Chapter 2 Getting to Know Your Camera 2-1 Names of[...]

2 Please read this manual carefully before using the camera and follow the instru ctions to av oid damage caused by improper operation. 1-1 Safety Precautions ● The software CD-ROM packaged with the camera is designed for PC use only . Us ing a stereo or CD player may damage the CD-ROM. ● This camera is a precision electronic device. Do not att[...]

3 law. ● Notes on the LCD (Liquid Crystal Display) monitor In the rare event that the L CD monitor breaks and the liquid within spills, follow the care instructions below: 1. If the liquid makes contact with the skin: Wipe the skin dry and wash it thoroughly with water . 2. If the liquid gets into the eye: Rinse with water immediately for at leas[...]

4 2-1 Names of Parts Front View 2. Getting to Know Your Camera (1) Shutter (2) Flash Light (3) Lens (4) Lens Cover/ P ower Switch (5) Strap Holder (6) Battery Cover (7) Memory Card Slot (8) T ripod Socket[...]

5 Rear View (1) Macro LED (2) Status LED (3) Mode Display Button (4) Mode Button (5) Set Button (6) Function Key (7) Macro Button (8) USB Cover (9) USB Port (10) LCD Monitor[...]

6 2-2 Specifications ● Lens: f=8.79mm ● Image Sensor: 1/2" CMOS with 2.0 mega pixels ● Focus: F / 2.8 ● Sensitivity: ISO 100 ● White Balance: White Balance: Auto , Sunny , T ungsten, Fluorescent. ● Shutter: Electrical ● Shutter Speed: 1/4 sec. ~ 1/2000 sec. ● Storage Medium: 16MB Internal Flash Memory SD Card Slot (support 4MB~[...]

7 System requirement (Macintosh Computer) OS Mac ® OS X 10.1 or above CPU PowerPC ® 601 processor or higher Memory 64 MB memory or above HDD Minimum 10MB free disk space on the hard drive Others One standard USB 1.1 or USB 2.0 port and CD-ROM[...]

8 3-1 LED Indicators The LED indicators located on the top of the LCD monitor are: M a c r o L E D S t a n d b y / B u s y (Green LED) (Red LED) Macro (Left Green LED) The g reen LED will be on when the Macro key on the left hand side of the camera is switched to Macro mode. Busy (Right Red LE D) The red LED will be on when the camera is recording [...]

9 3-3 Power Supply ● Gently slide the lens cover to the left as illustrated. A long beep indicates that the camera is turned on. ● T o turn off the camera, gently slide the lens cover to the right. ● When the camera is turned on, the red LED flashes, and the last recorded im age appears on the LCD monitor . ※ This camera has a power -saving[...]

10 3-5 Mode Selection ● Please press and hold ” ” button for 2 seconds to enter mode selection menu including “Play Mode” “Setup Mode” “Movie Mode” “Record Mode" "Function Selection” . 3-6 Function Key ● Y ou can perform different operations in the different mode by using the Function Key , e.g. select, go up/down [...]

11 4-1 Record Mode ↑ For more information, please refer to the "3-2 LCD Monitor Display" section on page 8. Index for Quick Menu: Press MODE to enter Press Mode again to Exit 4. Navigation Modes and Menus[...]

12 4-2 Play Mode (1) Possible Number of Shots (2) Remaining Battery P ower Index for Quick Menu: 1. Delete Pictures 2. Slideshow 3. DPOF (Digital Print Order Format) Settings ● There are three options when printing images with DPOF: Printing one image, printing all images and the option of printing the recorded date or not. ● DPOF function can [...]

13 4-3 Movie Mode (1) Movie Mode (2) Recorded Movie Time (seconds) (3) Recording (4) Remaining Battery P ower (5) Time/Date[...]

14 4-4 Setup Mode 1. Image Resolution 2048x1536 1600x1200 800x600 1280x960 2. Image Quality (Fine Quality) (Basic Quality) 3. White Balance ( A u t o ) ( S u n n y ) ( F l u o r e s c e n t ) ( T u n g s t e n ) 4. EV Compensation[...]

15 5. OSD Language 6. Date/Time 7. Light Frequency Select the correct frequency type (50Hz or 60Hz) according to your region. 8. Format Media ※ If the memory card has been inserted, it would only format the memory card, and not the internal memory . 9. Reset to Default F actory Settings[...]

16 4-5 PC Mode[...]

17 5-1 Attaching the Strap ● Insert the thin end of the strap into the str ap holder . . ● Pass the other end of the strap through the loop . ● Pull the strap tightly . 5-2 Loading Batteries ● T urn the camera off first. ● Insert 2 x AAA alkaline batteries or rechargeable batteries. Please make sure the batteries are fully charged. If the[...]

18 ● Close and lock the battery cover . NOTE: Do not open the cover roughly to avoid damagin g the battery compartment cover . ※ If the battery power indica tor only shows one black block, the flash light would be disabled. ※ When the battery indicator turns red, recordin g of still pictures and movies would be disabled. ※ The Date/Time wou[...]

19 memory card into the slot. If the memory card is full or contains other images, you can press the Mode Button to Format of the Setup Mode to format the memory card. ● There is 16MB internal memory built-in in the digital camera for Image Stor age. If a memory card is inserted, your data will be saved on this memory card. ※ The specification [...]

20 6-1 Setup Mode By using the Setup Mode , you can adjust the basic camera settings, including: Image Size, Image Quality , White balance, and EV Compensation. General setting format and factory default setting. Setup for language, date/time and light frequency is as follows: 1. T urn the camera on/off by sliding the lens cover . 2. Press Mode But[...]

21 ※ If the icon appears on the LCD Monitor for low battery power , please change the batteries immediately to maintain operation normality . ※ The countdown for the Self-timer is 10 seconds. ※ There are 4 types of resolu tions offered by the camer a: 2048x1536 , 1600x1200 , 1 280x960 , and 800x600 . ※ Please pay attention to the distance b[...]

22 screen, the LCD monitor will then display the menu. 4. The top left hand corner will display the recorded time in red while you are recording the movie pictures. 5. The green LED will be on when the Macro key on the l e f t h a n d s i d e o f t h e c a m e r a i s t o g g l e d t o Macro Mode. 6. Y ou can use Display button to toggle between di[...]

23 6. Please connect the USB cable to the camera and the PC when the diagram USB Connection pops up the screen. 7. A new item – removable disk will be added into my computer after the system installation is completed. 8. Y ou may start to operate with the newly added removable disk (SD device) offered by the digital camera. ● PC Camera The digi[...]

24 7-1 Installing the Camera Driver for PC Y ou can use the PC Camera and Mass Storage functions of the camera via PC. T o install the proper camera driver , perform the following: 1. Insert the installation CD into the CD-ROM drive. 2. The Auto-run program will be executed and the welcome screen will appear: (If your CD-ROM drive doesn't supp[...]

25 7-2 Installing the Application for PC Arcsoft application installation (In case of Photo Impression) 1. Insert the software CD-ROM supplied by the package into the CD-ROM drive. 2. The Auto-run program will be executed and the welcome screen will appear the following message : (If your CD-ROM drive doesn't support the auto-run function, ple[...]

26 7. Please follow the installation wizard to select the folder location and application components. 8. Please select the folder where you want to install the application in.[...]

27 9. After the installation the following diagram will appear . Press Finish to complete the application installation.[...]