Creda W810 manual

INSTRUCTIONS for INST ALLA TION and USE Gas Hob W810 T o the Installer Before installation fill in the pr oduct details on the back co ver of this booklet. The information can be f ound on the rating plate. T o the User Y ou m ust read the instructions prior to using the appliance and then retain them for future ref erence . This appliance must be [...]

Introduction 3 CONTENTS For Y our Safety – Always 4 For Y our Safety – Never 5 Installation 9 - 14 Using The Hob 6 Care & Cleaning 7 Something Wrong? 8 Key contacts Back Cover 2 Retention of this Instruction Book This Instruction Book must be kept handy for reference as it contains important details on the safe and proper use of the applian[...]

INTR ODUCTION Y our new hob is guaranteed* and will give lasting service. This guarantee is only applicable if the appliance has been installed in accordance with the installation instructions detailed in this booklet. T o help make best use of your cooking equipment, please read this booklet carefully . The hob is designed specifically for domesti[...]

FOR Y OUR SAFETY When used properl y , y our appliance is completely safe b ut as with any product there are certain precautions that must be observed. PLEASE READ THE PRECA UTIONS BELO W BEFORE USING Y OUR APPLIANCE. AL W A YS ● Always make sure you understand the controls prior to using the appliance. ● Always keep children away from the appl[...]

NEVER ● Never leave children unsupervised where a cooking appliance is installed as all cooking surfaces will be hot during and after use. ● Never allow anyone to sit or stand on any part of the appliance. ● Never store items above the appliance that children may attempt to reach. ● Never leave anything on the hob surface when unattended an[...]

USING THE GAS HOB - FEA TURES 6 DO NO T allow y oung children near to the appliance when the hob is in use as the surfaces get extremely hot. In order to obtain maximum performance from the burners, use pans with the following diameters: Rapid burner 22 - 28 cm Standard burner 14 - 22 cm Auxillary burner 10 - 14 cm All pans should be positioned cen[...]

Clean the hob regularly and wipe up spills soon after they occur to prevent them from becoming burnt on. 1. Household abrasive powders, e.g. Vim. 2. Oven chemical cleaners, aerosols and oven pads. Caustic cleaners such as these will etch the surface and attack the metal frame. 3. Bath and sink cleaners may mark the surface. Wipe with a cloth wrung [...]

8 This appliance conforms to the following EEC Directives: Low V oltage Equipment 73/23/EEC 93/68/EEC Electromagnetic Compatibility 89/336/EEC 92/31/EEC 93/68/EEC Gas Appliances 90/396/EEC 93/68/EEC T o minimise the risk of injury to children please dispose of your product carefully and safely . Remove all doors and lids (where fitted). Remove the [...]

INST ALLA TION - electrical requirements 9 Connection to the electricity supply should be made via a properly ear thed, readily accessible wall socket which is adjacent to but not directly above , and not more than 1.25m away from the appliance and capable of electrical isolation. Should this plug not fit the socket outlet in your home it should be[...]

INST ALLA TION INSTR UCTIONS 10 Gas Connection Pressure test point Gas rate adjustment Aeration adjustment Electrical Connection Rp 1 / 4 ( 1 / 4 ” BSP female) Burner injector None None 230-240V ac. 50Hz Heat resistant PVC 85 o C 0.75mm2 Flexible cord. T echnical Data BURNER HEA T INPUT INJECTOR Natural Gas Front Left Rear Right and Rear Left Fro[...]

GAS SAFETY (INST ALLA TION & USE) REGULA TIONS LOCA TION PRO VISION FOR VENTILA TION INST ALLA TION INSTR UCTIONS 11 Prior to installation, ensure that the local distributions (nature of the gas and gas pressure) and the adjustment conditions are compatible. The adjustment conditions for this appliance are stated on the rating plate which is fi[...]

The hob is designed to fit into worktop and base unit(s) with a cutout as shown in Fig.1. Any obstruction such as supports or side panels must be removed to allow 30mm minimum depth below the worktop cutout. Any overhead surface of combustible material must not be closer than 600mm. When installing next to a tall cupboard, partition or wall, for a [...]

13 INST ALLA TION Fig. 1 IMPORT ANT Minimum unobstructed depth 50mm Worktop thickness Preferred 30-40mm 19mm minimum recommended 30mm 489mm 558mm Front edge of worktop Note: Do not over tighten the hob c lamps as distor tion of the hob may occur . Fig. 2 FIXING CLAMP FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 13[...]

INST ALLA TION INSTR UCTIONS 14 Read the Gas Hob instructions before conversion, installation and using the Gas Hob. 1 Rapid burner injector marked 92 - 1 off 2 Semi-rapid burner injector marked 72 - 2 off 3 Auxillary burner injector marked 55 - 1 off Ensure that the Gas Hob is disconnected from the gas and electricity supply (Fig.1) 1. Remove pan [...]

15 FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 15[...]

FP089 - 01 K ey Contacts Service Creda has the largest appliance manufacturer ’s service team in Europe, trained specialists directly employed by us to ensure your complete confidence. Repair Service UK: 08709 066 066 Republic of Ireland: 1850 302 200 Y ou will be asked for the following information:- Name, address and postcode. T elephone number[...]