Dacor DR30GFS manual

Ins t all a tio n I nst r u c tio ns Dis tin c t iv e ™ 30 - Inch Gas R ange Part No. 105908 Rev . D THIS APPLIANCE HAS BEEN TESTED IN ACCORDANCE WITH THE LA TEST EDITION OF ANSI Z21.1a-201 1 ST ANDARD FOR HOUSEHOLD GAS COOKING APPLIANCES. For use with models DR30GS, DR30GFS, DR30GIS and DR30GIFS[...]

T able of Contents Customer Ser vice Information IMPORT ANT : • Installer : In the interest of safety and to minimize problems, read these installation instructions completely and carefully before you begin the installation process. Leave these installation instructions with the customer . • Customer : Keep these installation instructions[...]

1 Impor tant Information About Safety Instructions The Important Safety Instructions and warnings in this manual are not meant to cover all possible problems and conditions that can occur . Use common sense and caution when installing, maintaining or operating this appliance. Always contact the Dacor Customer Service T eam about problems or conditi[...]

2 Impor tant Safety Instructions General Safety Precautions T o reduce the risk of fire, explosion, electric shock, serious injury or death when installing or using this appliance, follow basic safety precautions, including the following: • Read the accompanying use and care manual completely before operating this appliance. • Keep packag[...]

3 Impor tant Safety Instructions • Do not expose the knobs to direct flame, hot utensils or other sources of heat. • Always ensure that the light fixture lens cover is in place when using the oven. The lens cover protects the light bulb from breakage caused by high oven temperatures or mechanical shock. IMPORT ANT - This appliance is equi[...]

4 Installation Specifications Product Dimensions 1 1/8” (2.9 cm) DR30GI[F]S: 1/4” (6.4 mm) thick top trim Front of open door Front of handle Front panel Rear of front panel Backguard thickness 26 1/8” (66.4 cm) 28 9/16” (72.5 cm) Front of knobs 28” (71.1 cm) 24” (61.0 cm) 3” (7.6 cm) backguard* DR30G[F]S: Full stainless steel side pan[...]

5 Installation Specifications W ARNING • This appliance must be installed and electrically grounded in conformance to local codes. • In the absence of local codes, the appliance installation must conform with the National Fuel Gas Code, ANSI Z223.1/NFP A 54 and the National Electrical Code, ANSI/NFP A 70. • Installation of this range[...]

6 Installation Specifications W ARNING • Failure to meet or exceed the maximum and minimum dimensions/clearances stated may result in a fire hazard. • T o eliminate the risk of burns or fire by reaching over heated surface units, cabinet storage space located above surface units should be avoided. • Carefully check the location where[...]

7 Cabinet Depth Greater Than 24” Partial Side Panels Installed, Range Back Overhanging Countertop (T op View) 2 Cabinet Depth Greater Than 25 1/8” Partial Side Panels Removed, Range Back Overhanging Countertop (T op View) 2 Cabinets Less Than 24” Deep, Partial Side Panels Installed, Range Back Flush to W all (T op View) Cabinet Exactly 24” [...]

8 24” - 24 1/4” Cabinet Depth Partial Side Panels Installed (T op View) 2 24 1/4” - 27 1/2” Cabinet Depth Partial Side Panels Installed (T op View) Custom Cabinet 27 1/2” or Deeper , Partial Side Panels Removed (T op View) Side View - DR30GI[F]S Range and ERV3015 Raised V ent 1 T o create a “built-in look” on the front of the cabinet,[...]

9 Installing the Anti-T ip Bracket Locate the anti-tip bracket included in the parts box. There are two ways to mount the anti-tip bracket: • Floor mounting (preferred method) • W all mounting (alternate method). Use this method if floor mounting is not suitable. If any of the conditions below exist, then the wall mounting method can not [...]

10 Attaching the bracket to a concrete floor: • Drill four (4) 3/8” diameter countersink holes through any existing floor covering to the concrete slab below . • Drill the 4 holes for the anchors 1 1/4” (3.2 cm) deep into the concrete slab using a 3/16” masonry bit. This hole length is longer than the anchor , but is required for pr[...]

11 Installing the Anti-Tip Bracket on the W all 1. Determine the suitability of wall mounting the anti-tip bracket. T o use the wall mount option, the range front panel must not be more than 27 3/8” (69.5 cm) from the wall and the bracket screws must be able to thread into the base plate inside the wall behind. The notches on the sides of the bra[...]

12 Side Panel Removal (Model DR30GIS/DR30GIFS only) If the range will be installed with the partial side panels removed: 1. Remove the three screws just below the oven opening that hold the kick panel in place. 2. Pull the kick panel straight out to snap it off of the range. 3. Remove the three screws that hold the side panel in place as shown. 4. [...]

13 Rear T rim Piece Installation (Model DR30GIS/DR30GIFS only) For self-rimming installations, with or without a raised vent, install the included 1 inch deep rear trim piece to overhang the countertop/raised vent in back. Use the two (2) included #8 x 1/4 screws. Installing a Raised V ent (Optional) Install the ERV3015 raised vent before final ins[...]

14 Installation Instructions Moving the Range to Final Location 1. Peel the protective plastic coating off of the range, including the range door . 2. Uncoil the power cord and route it to the electrical outlet so that it does not become trapped behind the range when it is pushed back. Do not connect the power plug until you are ready to verify pro[...]

15 Cooktop Assembly W ARNING Never attempt to operate the range’s cooktop with any of the burner rings, burner caps or grates removed. 1. Remove the burner rings, burner caps and grates from their shipping cartons. 2. Install the burners as shown. Gently twist each piece back and forth after installation to make sure it is properly seated. A smal[...]

16 Installation Instructions V erifying Proper Operation W ARNING Before operating the range, read the accompanying use and care manual completely . 1. Before beginning the test procedure, make sure all range control valves are in the “OFF” position, and all burner rings, burner caps and grates are properly positioned on the spill tray . 2. T u[...]

17 Installation Instructions Installation Checklist W ARNING T o ensure a safe and proper installation, the installer must perform the following checklist to ensure that no part of the installation has been overlooked. Proper installation is the responsibility of the homeowner . □ Has the plastic coating been peeled off of the outside of the rang[...]

18 Notes[...]

19 Notes[...]

20 Notes[...]

[...]

Dacor ● 14425 Clark Avenue, City of Industry , CA 91745 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www .dacor.com[...]