Dual Electronics Corporation XDVD8130 manual

INSTALLATION/OWNER'S MANUAL DVD Multimedia Receiver with 2.5 ” TFT Display XDVD8130 The DVD video display of the in-dash unit will not operate while the vehicle is moving. This is a safety feature to prevent driver distraction. In-dash DVD video functions will only operate when vehicle is in Park and the parking brake is engaged. It is illeg[...]

2 Table of Contents 2 3 4-7 8 9 10-12 13 14 15-19 20-22 23-24 25 26-27 28 29 30 31 DVD Region Management Some DVD discs can be played only in certain playback modes according to the intentions of the software. As the XDVD8130 plays discs according to their intentions, some functions may not work as intended. Please be sure to read the instructions [...]

3 Please read all instructions carefully before attempting to install or operate. Due to its technical nature, it is highly recommended that your DUAL XDVD8130 is installed by a professional installer or an authorized dealer. This product is only for use in vehicles with 12VDC negative ground only. Safety Notes: The DVD video display of the in-dash[...]

4 XDVD8130 INSTALLATION Preparation Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. Consult a qualified technician for instructions. • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or exces[...]

5 XDVD8130 INSTALLATION Wiring Diagram - Inputs/Outputs FUSE When replacing the fuse, make sure new fuse is the correct type and amperage. Using an incorrect fuse could damage the radio. The XDVD8130 uses one 10 amp ATM fuse located beside the wiring connector.[...]

6 Wiring Diagram - Power/Speakers XDVD8130 INSTALLATION Connecting the parking brake lead (Yellow/Blue - ) The Yellow/Blue lead MUST be connected for the in-dash monitor to operate properly. The DVD video display of the in-dash unit will not operate while the vehicle is moving. This is a safety feature to prevent driver distraction. In-dash DVD vid[...]

7 XDVD8130 INSTALLATION Wiring Diagram - Optional A/V Connections The diagram above illustrates the connection capabilities of the XDVD8130. Two separate Audio/Video inputs allow the connection of a DVD player or game console. The video output provides signal to external monitors - such as an overhead or headrest type. A rear view camera can be con[...]

8 Open Rotary Volume Reset Power Menu/Audio TFT LCD Band/Play/Pause Mode Tune/Track Down Loudness/Sub On/Off 1 2 3 4 5 6 7 8 9 10 Eject Tune/Track Up Auto Store/Preset Scan Navigation Mode EQ Display Infrared Sensor Tilt Control/Video Mode Mute 11 12 13 14 15 16 17 18 19 18 19 17 16 15 14 13 1 2 4 6 7 8 3 9 5 10 11 12 Caution • Due to its highly [...]

9 XDVD8130 Power DVD Menu Band/Play/Pause 4-Way Up 4-Way Left 4-Way Down Mute Volume Down Stop Tune/Track/Chapter Down Setup Audio Zoom 1 2 3 4 5 6 7 8 9 10 11 12 13 XNAV9525 Power* Preset #2/System* Preset #1/Escape* Preset #4/Volume Down* Key #8/Function 2* Key #7/Function 1* Slow/Function 4* Mode Tilt Control/Video Mode Enter 4-Way Right Volume [...]

10 Power On/Off Reset Mode Video (AUX) Notes Tilt Contr ol (monitor angle) Volume Press PWR or any other button (except EJECT or OPEN ) to turn the unit on. Inserting a disc will turn the unit on automatically. Press PWR to turn the unit off. Press RESET the unit upon initial installation or if abnormal operation occurs. Refer to page 8 for the res[...]

11 Programmable Turn-On Volume Loudness Subwoofer Output Preset EQ Curves Display Set the Clock 12/24-hour Clock Programmable Display Priority Press and hold PWR for 3 seconds to program currently selected volume level. "ON VOL" and the current volume level will momentarily appear in the display. The unit will return to this volume level [...]

12 Press AUD to select between Volume (default), Bass, Treble, Balance, Fader & Subwoofer (if activated). Press AUD until BAS appears Rotate encoder left/right or use the VOL   to adjust (-6 minimum / +6 maximum) Press AUD until TRE appears Rotate encoder left/right or use the VOL   to adjust (-6 minimum / +6 maximum) Press AUD unti[...]

13 Press MENU/AUD for more than 3 seconds to access the Audio/Video setup menu and adjust the following settings: Press MENU/AUD until Beep appears. Rotate encoder to turn the confirmation beep on or off. Press MENU/AUD until Rear View appears. Rotate encoder to select the V3 input to be mirrored (On) or normal (Off). Press MENU/AUD until Bright ap[...]

14 Press TUNE nn or TUNE ll momentarily to seek the next strong station. Press TUNE nn or TUNE ll for more than 2 seconds, then release. "MANU" will momentarily appear in the display. Press TUNE nn or TUNE ll momentarily to move radio frequency up or down one step at a time. Press and hold to advance quickly. If tuning is not adjusted for[...]

15 XDVD8130 OPERATION DVD Setup Menu With a disc inserted, press SETUP to access DVD setup menu. Press  or  to select between menu pages and  /  /  /  to adjust settings and or levels. When selectable, the menu item will be highlighted in blue. The current setting is indicated by a  . Press ENTER to select/confirm each setting.[...]

16 Press  or  to select DISPLAY setup page and  to select options. Press  or  to select 4:3 or 16:9. This option also affects the composite video output signal. Press  or  to select Letterbox or Panscan . This option is only available when the aspect ratio is set to 4:3. Display Setup Page TV Aspect Display Mode General Operati[...]

17 Audio Setup Page Dolby Digital Sample Freq. Digital Output DRC (Dynamic Range Compression) Downmix Press  or  to select AUDIO setup page and  to select options. Press  or  to select Bitstream or PCM . This option is only available when the Digital Output is turned on. Press  or  to select 48kHz or 96kHz sampling frequency. T[...]

18 Press  or  to select LOCK setup page and  to select options. Press  or  to select desired parental control level (default setting is Unlock ). The Unlock setting provides no parental control. After a password is set, a password is required to change the parental controls setting. See below for details. Press  or  to select N[...]

19 Press  or  to select OTHERS setup page and  to select options. Press  to load default factory settings. The DVD must be fully stopped before loading the default factory settings. See page 20 for details. Press  or  to select On or Off . Selecting Last Play On will remember the DVD playback position (for up to 10 DVDs) after the[...]

20 XDVD8130 OPERATION DVD Operation Press EJECT to allow the rear panel to slide down. With the label facing up, insert a disc at least half way into the disc slot. The disc will auto-load and the rear panel will close. Some discs will play automatically when inserted. Press EJECT to allow the rear panel to slide down and eject the disc. If the dis[...]

21 XDVD8130 OPERATION DVD Operation Press SLOW to activate slow playback. Slow playback speed includes I  1/32, 1/16, 1/8, 1/4, and 1/2. Press  / II to resume normal playback. There is no audio output during slow playback mode. Press ZOOM to increase the image size from 400% to 1600%. Press  /  /  /  while zooming to scroll the im[...]

22 Press DISP to access the DVD display console. Highlight desired menu item using  or  . Press  or  t o s e l e c t desired title and press ENTER to select/confirm. Press  or  t o s e l e c t desired chapter and press ENTER to select/confirm. Enter desired title/chapter using the 1~0 buttons on the remote. Enter desired time usin[...]

23 XDVD8130 OPERATION CD Operation Insert a standard size CD into the disc slot. The CD will automatically begin playback when inserted. The currently playing track is shown in blue and highlighted in black. Press  momentarily; the unit will stop and display II  . Press l / II to resume operation from the last position in memory. Press  tw[...]

24 Program Play Start Program Play XDVD8130 OPERATION Press  or  to select desired track; press  to highlight the additions/deletions column. Press to add a single track to the Program playlist. Press ENTER to confirm. Press to add all tracks to the Program playlist. Press ENTER to confirm. Press to delete a single track from the Program p[...]

25 Playing an MP3/WMA disc .. Folder/File Repeat Track Random Note When an MP3/WMA encoded disc is first inserted, playback will automatically begin with the first file in the root folder or first folder (if there are no files in the root folder). The current folder/filename information is displayed at the bottom of the screen. MP3/WMA operation is[...]

26 XDVD8130 OPERATION DVD/MP3/WMA Information The following types of discs/files are compatible: • CD-ROM (ISO), CD-R, CD-RW, DVD+R/RW, DVD-R/RW • CD-DA , DVD Video • MP3 data • WMA data The following types of discs/files are not compatible: • WMA files that are protected by DRM (Digital Rights Management). • WMA lossless format • Dis[...]

27 XDVD8130 OPERATION DVD/MP3/WMA Information An internal buffer provides ESP (Electronic Skip Protection) to virtually eliminate skipping. When playing a disc recorded with regular audio files (CD-DA or .WAV) and MP3/WMA files, the unit will play the MP3/WMA files only. Only MP3 files with filename extension (.mp3) can be played. Only WMA files wi[...]

28 Press NAVI to select navigation mode (only available when connected to the XNAV9525 navigation system). The voice guidance and MP3 audio is routed to the left front channel by default. When a voice command is executed, the audio will mute to allow the voice command to be heard. Press NAVI for more than 2 seconds to select between viewing the nav[...]

29 This warranty gives you specific legal rights. You may also have other rights which vary from state to state. Dual Electronics Corp. warrants this product to the original purchaser to be free from defects in material and workmanship for a period of one year from the date of the original purchase. Dual Electronics Corp. agrees, at our option, dur[...]

30 Problem Cause Action Unit will not turn on (no power) Yellow wire not connected or incorrect voltage Red wire not connected or incorrect voltage Check connections for proper voltage (11~16VDC) Black wire not connected Check connection to ground Fuse blown Replace fuse Unit has power (but no sound) Speaker wires not connected Check connections at[...]

31 XDVD8130 OPERATION Specifications CEA-2006 Power Standard Specifications (reference: 14.4VDC +/- 0.2V, 20Hz~20kHz) Power Output: 17 Watts RMS x 4 channels at 4 ohms and < 1% THD+N Signal to Noise Ratio: 80dBA (reference: 1 watt into 4 ohms) DVD Player FM Tuner AM Tuner Monitor General Frequency response: 10Hz-20kHz Channel separation @ 1kHz: [...]

32 Dual Electronics Corp. Toll Free: 1-866-382-5476 www.dualav.com ©2006 Dual Electronics Corp. All rights reserved. NSA0206-V01[...]