Electrolux E36WC45FSS manual

5995465548 U se & Car e Guide In stallation In struction s V ent Hood E36WC45FSS[...]

2 Finding Information PLEASE READ AND SA VE THIS GUIDE Thank you for choosing Electrolux , the new premium brand in home appliances. This Use & Care Guide is part of our commitment to customer satisfaction and product quality throughout the service life of your new hood. We view your purchase as the beginning of a relationship. T o ensure our a[...]

3 PRODUCT REGISTRA TION INFORMA TION The package containing this manual also includes your product registration information. W arranty coverage begins at the time your Electrolux vent hood was purchased. If you received a damaged product, immediately contact your dealer or builder . Do not install or use a damaged appliance. Please record the purch[...]

4 T ABLE OF CONTENTS Finding Information .............................................. 2 Please Read And Save This Guide ................... 2 Make A Record For Quick Reference ................ 2 Questions ........................................................... 3 T able Of Contents .............................................. 4 Safety ......[...]

5 Safety IMPORT ANT SAFETY INSTRUCTIONS Safety Precautions Do not attempt to install or operate your unit until you have read the safety precautions in this manual. Safety items throughout this manual are labeled with a W arning or Caution based on the risk type. Definitions This is the safety alert symbol. It is used to alert you to potential per[...]

6 Safety General Precautions WARNING • T o reduce the risk of a range top grease fire: a) Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium settings. b) Always turn hood ON when cooking at high heat or when flambeing food (i.e. Crepes Suzette, [...]

7 CA UTION • For general ventilating use only . Do not use to exhaust hazardous or explosive materials and vapors. • Do not store items of interest to children above or at the back of the cooktop or vent, as they could climb on the appliance to reach items and be injured. CA UTION • Begin by ensuring proper installation and grounding of the h[...]

8 CA UTION • For best capture of cooking impurities, the bottom of the hood should be a minimum of 24” and a maximum of 30” above the cooking surface. See “Install Mounting Bracket” section for mounting restrictions. • T wo installers are recommended because of the large size and weight of this hood. • This product is equipped with a [...]

9 Getting Started OPERA TING YOUR HOOD Controls The hood is operated using the (5) push-buttons located at eye-level, on the front edge of the hood. The light switch turns the halogen lights on and off. Push the light switch once to turn the lights ON - push a second time to turn the lights ON to a brighter level - push a third time to turn the lig[...]

10 Operation Halogen Bulbs This range hood requires two halogen bulbs (T ype JC, 12V olt, 20W att Max, G-4 Base). T o change bulbs: 1 Open the cover by prying from the proper slots. 2 Remove the bulb by pulling sideways. (DO NOT ROT A TE). 3 Replace with T ype JC, 12V olt, 20 Watt Max, G-4 Base halogen bulb. Do not touch replacement bulb with bare [...]

1 1 Care and Cleaning CARING FOR YOUR RANGE HOOD Proper maintenance of the Range Hood will assure proper performance of the unit. Grease Filters The grease filters should be cleaned frequently . Use a warm detergent solution. Grease filters are dishwasher safe. See “INST ALL FIL TERS” section for removal and installation instructions. Non-Duc[...]

12 Installation CHECK CONTENTS Unpack hood and check contents. Y ou should receive: 1 - Hood 1 - Decorative Flue Assembly 1 - Parts Bag (B080810604) containing: 1 - Mounting Bracket 1 - Discharge Collar 1 - Flue Mounting Bracket 6 - Mounting Screws (4,8 x 38mm Pan Head) 7 - Mounting Screws (3,9 x 9,5mm Pan Head) 2 - Mounting Screws (3.9 x 6mm Flat [...]

13 Installation INST ALL THE DUCTWORK 1 Decide where the ductwork will run between the hood and the outside. 2 A straight, short duct run will allow the hood to perform most efficiently . 3 Long duct runs, elbows, and transitions will reduce the performance of the hood. Use as few of them as possible. Larger ducting may be required for best perfor[...]

14 Installation INST ALL THE MOUNTING BRACKET Ducted and Non-Ducted Hoods 1 Construct wood wall framing that is flush with interior surface of wall studs. Make sure: a the framing is centered over installation location. b the height of the framing will allow the mounting bracket to be secured to the framing within the dimensions shown. 2 After wal[...]

15 Installation INST ALL THE FLUE MOUNTING BRACKET Ducted and Non-Ducted Hoods 1 Assemble the flue mounting bracket, adjusting outside width as shown. See Figure 8. 2 Carefully center the mounting bracket directly over the range hood location. 3 Secure the bracket assembly to the ceiling using (2) 4.8x38mm mounting screws and drywall anchors (Figu[...]

16 Installation PREP ARE THE HOOD Note: On stainless steel hoods, carefully remove the plastic protective film from all exterior surfaces of the hood and decorative flues, prior to final installation. Ducted Hoods Only 1. Remove the tape on the electrical system plate; place the electrical system plate on the hood (use a protection). Figure 10. [...]

17 Installation Non-Ducted Hoods Only 1 Remove the tape on the electrical system plate; place the electrical system plate on the hood (use a protection). Figure 12 2 Discard discharge collar/damper supplied with the hood. Install the 5” to 6” adapter supplied with the Non-Ducted Recirculation Kit. 3 Secure the plenum to the flue mounting brack[...]

18 Installation INST ALL THE HOOD 1 Raise the hood into its mounting position. 2 Align the rectangular opening on the back of the hood with the wall-mounting bracket. Gently lower the hood until it securely engages the bracket. Figure 14. 3 Level the hood with (2) 3.9x9.5mm mounting screws and secure with (2) 4.8x38mm mounting screws. Use drywall a[...]

19 Installation 9 Carefully place the decorative flue on the hood. Figure 16. - On ducted installation in rooms with 8-foot ceilings, the air vents are concealed. Install the flue with the air vents down. - On non-ducted installations in rooms with 8-foot ceilings, the air vents are exposed. Install the flue with the air vents up. - On ducted an[...]

20 Installation INST ALL THE FIL TERS Ducted and Non-Ducted Hoods 1 T o remove the GREASE filter , push in on the metal latch tab and tilt filter downward to remove. 2 T o install the GREASE filter , align rear filter tabs with slots in the hood. Depress the metal latch tab, push filter into position and release. Make sure filter is securely [...]

21 T roubleshooting IF SER VICE IS REQUIRED First, review the recommended checks listed in the T roubleshooting Guide . Then, be certain that the appliance has been installed properly and is being operated correctly . Familiarize yourself with the warranty terms and conditions listed in the W arranty section. If the above checks have been completed[...]

22 T roubleshooting TROUBLESHOOTING GUIDE IMPORT ANT Unnecessary service calls may be expensive, frustrating and time consuming. Before you call for service, please review the potential problems, possible causes and remedies shown in the table below . Problem T roubleshooting - What to check when problems occur Remedy Possible Cause Nothing works. [...]

23 Saving Energy ENERGY SA VING TIPS 1 Do not operate the blower at a speed that is higher than necessary to remove the cooking exhaust. Running at excessive speeds removes more air from the inside of the house that must be replaced by outside air . This may be especially costly when the housing air conditioning or heating system is in operation. 2[...]

24 14 W a r r a n t y I n f o r m a t i o n HOO D WA RR AN TY Your hood i s pr otected by this war ranty WARRAN TY PERIOD THROU GH OUR AUTHORIZE D SERVICERS, WE WIL L: THE CON SUMER WILL BE RESPONS IBLE FOR: FULL ON E-YEAR WARRAN TY One y ear from original p urchase date . Pay all costs for repairing or r ep lacing any pa rts o f t his product w h [...]