Electrolux ER 6436 manual

2222682-51 I N F O INSTRUCTION BOOKLET ER 6436 U REFRIGERA T OR[...]

Instructions for the User Important Safety Instructions 3 Description of the Appliance 4 Operation 4 Before use 4 Setting the temperature 4 Fresh food refrigeration 5 The door shelves 5 Normal Operating Sounds 5 Health and safety guidelines 6 Defrosting 6 Maintenance and Cleaning 7 Internal cleaning 7 Periodic cleaning 7 Changing the light bulb 7 W[...]

3 IMPORT ANT SAFETY INSTRUCTIONS These warnings are provided in the interests of your safety . Ensure that you understand them all before installing or using this appliance. Y our safety is of paramount importance. If you are unsure about any of the meanings of these warnings contact the Customer Care Department. Prior to Installation ■ Check the[...]

DESCRIPTION OF THE APPLIANCE 4 OPERA TION Before use Remove all securing tapes. W ash inside the appli- ance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). Do not use soap or deter- gent as the smell may linger . Dry thoroughly . Setting the temperature The temperature inside the refrigerator is regulated by a thermostat [...]

5 D040 Important If the fridge is not defrosting correctly , it is pos- sible that because a very low temperature has been selected, the motor is working continuous- ly , which prevents the defrost cycle from oper- ating. During prologed periods of abnormally hot weathe r , if the thermostat is set on too high a number , the cooling system may oper[...]

Because of consumer demand, preservatives have been removed from many pre-prepared foods. This together with the changes in shopping habits to a once-a-week shop, mean that safe handling and storage of food is even more important than ever . The following tips should help you to ensure that the food in your home is in as perfect condition as possib[...]

7 Changing the light bulb Should the interior light fail to work, first switch off the appliance and disconnect from the electricity supply , then replace the bulb as follows: 1. Unscrew the light cover and then pull it outward by pressing as shown in the figure. Unscrew the bulb and replace it with a new 15 watt bulb (avail- able from your nearest[...]

8 If after the above checks, there is still a fault, call your local Service Force Centre. In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown. Please note that proof of purchase is required for any in-guarantee service calls. Symptom S[...]

9 SER VICE AND SP ARE P ARTS In the event of your appliance requiring service, or if you wish to purchase spare parts please contact your local Electrolux Service Force Centre by telephoning: 0870 5 929929 Y our telephone call will be automatically routed to the Service Centre covering your post code area. The addresses are listed on the following [...]

10 Standard guarantee conditions We, Electrolux, undertake that if within 12 months of the date of purchase this Electrolux appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour , materials or carriage on condition that: [...]

11[...]

12[...]

TECHNICAL SPECIFICA TIONS Positioning For this appliance to work efficiently , it should be located away from heat sources, e.g. cookers, radia- tors, boilers, direct sunlight etc. Best performance is obtained with ambient temperature between +10°C and +32°C. For building-in and door reversibility , if necessary , refer to the relevant instructio[...]

ELECTRICAL CONNECTION W ARNING: THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this safety measure not be observed. If the plug that is fitted to your appliance is not suit- able for your socket outlet, it must be cut off and the appropriate plug fitted. Remove the fuse from the cut off plug. The cut off plug should [...]

BUILDING-IN INSTRUCTIONS 15 Before carrying out any work, remove the plug from the power socket. Door Reversal Left door opening: 1. Remove the grid from the appliance pulling it towards you with hands. 2. Remove the left side (A) of the grid cutting it from the rear (see figure). T o reposition the grid on the appliance proceed as fol- lows: Apply[...]

T o reverse the opening direction of the door , proceed as shown in the figures: 16 Attention After completion of the door reversing opera- tion, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fit- ting of the[...]

17 Building the appliance in under a worktop The dimensions of the recessed installation area must correspond with those indicated in the figure. Remove covering and adjusting strips. Push the appliance into place. The plug socket neces- sary for connection of the appliance to the electricity supply should be positioned, so that the plug is not pla[...]

18 T o mount the furniture door proceed as shown in the figures:[...]

Screw appliance into place. Refit the covering strip. Fitting the plinth Important For the efficient operation of the appliance, it is important that the original ventilation grid is used. ■ For an opening height dimension A=820 mm and a plinth height dimension a=100 mm, the plinth may be fitted without adjustments. The same applies to an opening[...]

© Electrolux Household Appliances Limited 2000[...]