Frigidaire 316135924 manual

Contents Product Registration ......................................................... 2 V ersión en español ........................................................... 2 V ersion française .............................................................. 2 IMPORT ANT SAFETY INSTRUCTIONS ............................... 3-4 Grounding Instructions .[...]

2 Thank you for choosing your new range. The information contained within this Owner's Guide will instruct you on how to properly operate and care for your range. Please read through the information contained in your literature pack to learn more about your new range. Record Y our Model and Serial Numbers Record in the space provided below the[...]

3 IMPORT ANT SAFETY INSTRUCTIONS Read all instructions before using this appliance. Save these instructions for future reference. This guide contains important safety symbols and instructions. Please pay attention to these symbols and follow all instructions given. Here is a brief explanation of the use of these symbols. This symbol will help alert[...]

4 IMPORT ANT INSTRUCTIONS FOR USING Y OUR COOKTOP Use Proper Flame SizeAdjust flame size so it does not extend beyond the edge of the utensil. The use of undersized utensils will expose a portion of the burner flame to direct contact and may result in ignition of clothing. Proper relationship of utensil to flame will also improve efficiency. [...]

5 Grounding Instructions (electric ignition models only) Avoid fire hazard or electrical shock. Do not use an adapter plug, an extension cord, or remove grounding prong from electrical power cord. Failure to follow this warning can cause serious injury, fire or death. This appliance is equipped with a 3-prong grounding plug for your protection agai[...]

6 V enturi Surface Burner Models - Setting Surface Controls Each burner lights from either an electric ignitor or a standing pilot, depending on your model. Standing pilots must be lit initially. Refer to your installation instructions for instructions on lighting the standing pilot. Standing pilot will remain lit when the burners are turned off. M[...]

7 Before Setting Oven Controls Oven V ent Location The oven vent is located below the backguard. When the oven is on, warm air is released through the vents. This venting is necessary for proper air circulation in the oven and good baking results. Arranging Oven Racks ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO OPERATING THE OVEN). Al[...]

8 The oven control shown below may not look identical to the oven control on your range. They are only representational. Bake 1. Arrange oven racks while the oven is still cool. See "Arranging Oven Racks" under Before Setting Oven Controls . 2. Push in and turn the Temperature Control knob counter-clockwise to the desired temperature. 3. [...]

9 Oven Cleaning Follow these cleaning precautions:  Allow the oven to cool before cleaning.  Wear rubber gloves when cleaning the appliance manually. REMOVE SPILLOVERS AND HEAVY SOILING AS SOON AS POSSIBLE. REGULAR CLEANINGS WILL REDUCE THE NUMBER OF MAJOR CLEANINGS LATER. Ammonia must be rinsed before operating the oven. Provide adequate ven[...]

10 Surfaces Aluminum (Trim Pieces) & Vinyl Glass, Painted and Plastic Body Parts, Control Knobs and Decorative Trim Pieces Control Panels Porcelain Enamel Burner Grates, Cooktop Surface, Below Cooktop, Broiler Pan & Insert, Broiler Drawer, Door Liner and Oven Bottom Stainless Steel, Chrome Parts, Drip Pans Oven Racks Oven Door How to Clean [...]

11 When lowering the top, grasp the sides with fingertips only. Be careful not to pinch fingers. Also, DO NOT drop or bend the rangetop when raising or lowering. This could damage the surface. DO NOT turn the burners on when the cooktop is raised for cleaning. Be sure that the top is completely lowered and securely in place before turning on the bu[...]

12 T o Remove and Replace Oven Bottom To Remove Oven Bottom: 1. Remove the oven racks. 2. Remove the two hold-down screws (Figure 1) at the rear of the oven bottom panel. If the screws are too tight to remove by hand, use a screwdriver. 3. To lift out the bottom panel, place fingers in the slots in the bottom. Lift the rear of the panel up and back[...]

13 Changing Cooktop and/or Oven Lights (if equipped) Be sure the range is unplugged and all parts are COOL before replacing the surface or oven lights. Wear a leather-faced glove for protection against possible broken glass. T o Change the Oven Light (some manual clean models) On some models, the oven light automatically turns on when the door is o[...]

14 POS SIBLE CAUSE/SOL UTION Poor installation. Place oven rack in center of oven. Place a level on the oven rack. Adjust leveling legs at base of range until the rack is level. When range is level, cooktop may appear out of alignment if countertop is not level. Weak, unstable floor. Be sure floor is level and can adequately support range. Contact [...]

15 Meat too close to the broil burner. Reposition the rack to provide more clearance between the meat and the broiler. Meat not properly prepared. Remove excess fat from meat. Slash remaining fatty edges to prevent curling, but do not cut into the lean. Broiler pan used without grid or grid covered with foil. DO NOT use the broiler pan without the [...]

GIBSON RANGE PLA TINUM ADV ANT AGE W ARRANTY Your Gibson range is protected by this warranty In the U.S.A., your appliance is warranted by Electrolux Home Products North America, a division of White Consolidated Industries, Inc. We authorize no person to change or add to any of our obligations under this warranty. Our obligations for service and pa[...]