Frigidaire 316495063 manual

or Visit our W ebsite at: READ CAREFULL Y . KEEP THESE INSTRUCTIONS . Installation Over the Range Instructions Microwave Oven Read these instr uctions completely and carefully . • IMPORT ANT – Save these instructions for local inspector’ s use. • IMPORT ANT – Obser ve all governing codes and ordinances. • Note to Installer – Be sure t[...]

2 Before Y ou Use Y our Micr owave CONTENTS General information Important Safety Instr uctions .................................. 3 Electrical Requirements .......................................... 3 Damage – Shipment/Installation .............................. 4 Parts Included .......................................................... 4 T ools [...]

This product requires a three-prong grounded outlet. The installer must per form a ground continuity check on the power outlet box before beginning the installation to insure that the outlet box is properly grounded. If not properly grounded, or if the outlet box does not meet electrical requirements noted (under ELECTRICAL REQUIREMENTS), a qualifi[...]

P ART QUANTITY Wood Screws 2 ( 1 ⁄ 4 “ x 2“) T oggle Bolts (and 4 wing nuts) ( 3 ⁄ 16 “ x 3“) Self-Aligning Machine 3 Screws ( 1 ⁄ 4 “-28 x 3 1 ⁄ 4 “) Nylon Grommet 2 (for metal cabinets) Power Cord Strap 1 (plastic) • If the unit is damaged in shipment, return the unit to the store in which it was bought for repair or replace[...]

TOOLS YOU WILL NEED # 1 Phillips screwdriver Pencil Ruler or tape measure and straight edge Carpenter square (optional) T in snips (for cutting damper , if required) Electric drill with 3 ⁄ 16 “ , 1 ⁄ 2 “ and 5 ⁄ 8 “ drill bits Hammer (optional) Stud finder or Filler blocks or scrap wood pieces, if needed for top cabinet spacing (used o[...]

Find the studs, using one of the following methods: A. Stud finder – a magnetic device which locates nails. OR B. Use a hammer to tap lightly across the mounting sur face to find a solid sound. This will indicate a stud location. After locating the stud(s), find the center by probing the wall with a small nail to find the edges of the stud. Then [...]

DETERMINING W ALL PLA TE LOCA TION UNDER YOUR CABINET C. Y our cabinets may have decorative trim that inter feres with the microwave installation. Remove the decorative trim to install the microwave properly and to make it level. THE MICROW A VE MUST BE LEVEL. Use a level to make sure the cabinet bottom is level. If the cabinets have a front over h[...]

ALIGNING THE W ALL PLA TE Draw a vertical line on the wall at the center of the 30 ″ (76.2 cm) wide space. Use the mounting plate as the template for the rear wall. Place the mounting plate on the wall, making sure that the tabs are touching the bottom of the cabinet or the level line drawn in Step C for cabinets with front overhang. Line up the [...]

A INST ALLA TION TYPES This microwave oven is designed for adaptation to the following three types of ventilation: A. Outside T op Exhaust (V er tical Duct) B. Outside Back Exhaust (Horizontal Duct) C. Recirculating (Non-V ented Ductless) proceed to that section. OUTSIDE TOP EXHAUST (VER TICAL DUCT) OUTSIDE BACK EXHAUST (HORIZONT AL DUCT) RECIRCULA[...]

EQUIV ALENT NUMBER EQUIV ALENT DUCT PIECES LENGTH x USED = LENGTH Roof Cap 24 Ft. (7.3 m) x (1) = 24 Ft. (7.3 m) 12 Ft. (3.6 m) Straight Duct 12 Ft. (3.6 m) x (1) = 12 Ft. (3.6 m) (6”/15.2 cm Round) Rectangular -to-Round 5 Ft. (1.5 m) x (1) = 5 Ft. (1.5 m) T ransition Adaptor* Equivalent lengths of duct pieces are based on actual tests and reflec[...]

EQUIV ALENT NUMBER EQUIV ALENT DUCT PIECES LENGTH x USED = LENGTH Rectangular -to-Round 5 Ft. (1.5 m) x ( ) = Ft. or m T ransition Adaptor* Wall Cap 40 Ft. (12.2 m) x ( ) = Ft. or m 90° Elbow 10 Ft. (3 m) x ( ) = Ft. or m 45° Elbow 5 Ft. (1.5 m) x ( ) = Ft. or m 90° Elbow 25 Ft. (7.6 m) x ( ) = Ft. or m 45° Elbow 5 Ft. (1.5 m) x ( ) = Ft. or m [...]

Place the mounting plate against the wall and insert the toggle wings into the holes in the wall to mount the plate. NOTE: Before tightening toggle bolts and wood screw , make sure the tabs on the mounting plate touch the bottom of the cabinet when pushed flush against the wall and that the plate is properly centered under the cabinet. CAUTION: Be [...]

13 USE TOP CABINET TEMPLA TE FOR PREP ARA TION OF TOP CABINET Y ou need to drill holes for the top support screws, a hole large enough for the power cord to fit through, and a cutout large enough for the exhaust adaptor . A2. • Read the instructions on the TOP CABINET TEMPLA TE. • T ape it underneath the top cabinet. • Drill the holes, follow[...]

3 MOUNT THE MICROW A VE OVEN FOR EASIER INST ALLA TION AND PERSONAL SAFETY , WE RECOMMEND THA T TWO PEOPLE INST ALL THIS MICROW A VE OVEN. IMPORT ANT : Do not grip or use handle during installation. NOTE: If your cabinet is metal, use the nylon grommet around the power cord hole to prevent cutting of the cord. NOTE: W e recommend using filler block[...]

4 Attach the microwave oven to the top cabinet. 8 7 6 Cabinet Front Cabinet Bottom Shelf Tighten the outer two screws to the top of the microwave oven. (While tightening screws, hold the microwave oven in place against the wall and the top cabinet.) Filler Block Microwave Oven T op Equivalent to Depth of Cabinet Recess Insert 2 self-aligning screws[...]

INST ALLA TION OVER VIEW B1. Prepare Rear W all B3. Attach Mounting Plate to W all B4. Prepare T op Cabinet B5. Adjust Blower B6. Mount the Microwave Oven IMPORT ANT NOTES: • Make sure the screws for the blower motor and blower plate are securely tightened when they are reinstalled. This will help to prevent excessive vibration. • Make sure the[...]

A TT ACH THE MOUNTING PLA TE TO THE W ALL B3. USE TOP CABINET TEMPLA TE FOR PREP ARA TION OF TOP CABINET B4. • Read the instructions on the TOP CABINET TEMPLA TE. • T ape it underneath the top cabinet. • Drill the holes, following the instructions on the TOP CABINET TEMPLA TE. CAUTION: W ear safety goggles when drilling holes in the cabinet b[...]

Attach the exhaust adaptor to the rear of the oven by sliding it into the guides at the top center of the back of the oven. AFTER: Fan Blade Openings Facing Back Place the blower unit back into the opening. Replace the blower plate in the same position as before with the screw . Make sure the screw is tight. Roll the blower unit 90° so that fan bl[...]

Attach the microwave oven to the top cabinet. Installation Instructions 3 MOUNT THE MICROW A VE OVEN B6. FOR EASIER INST ALLA TION AND PERSONAL SAFETY , WE RECOMMEND THA T TWO PEOPLE INST ALL THIS MICROW A VE OVEN. IMPORT ANT : Do not grip or use handle during installation. NOTE: If your cabinet is metal, use the nylon grommet around the power cord[...]

USE TOP CABINET TEMPLA TE FOR PREP ARA TION OF TOP CABINET C2. INST ALLA TION OVER VIEW C1. Attach Mounting Plate to W all C2. Prepare T op Cabinet C4. C5. Mount the Microwave Oven IMPORT ANT NOTES: • Make sure the screws for the blower motor and blower plate are securely tightened when they are reinstalled. This will help to prevent excessive vi[...]

Attach the microwave oven to the top cabinet. Cabinet Front Cabinet Bottom Shelf Filler Block Microwave Oven T op Equivalent to Depth of Cabinet Recess Installation Instructions 3 MOUNT THE MICROW A VE OVEN FOR EASIER INST ALLA TION AND PERSONAL SAFETY , WE RECOMMEND THA T TWO PEOPLE INST ALL THIS MICROW A VE OVEN. IMPORT ANT : Do not grip or use h[...]

5 MOUNT THE MICROW A VE OVEN (cont.) Installation Instructions 8 7 6 Tighten the outer two screws to the top of the microwave oven. (While tightening screws, hold the microwave oven in place against the wall and the top cabinet.) Insert 2 self-aligning screws through outer top cabinet holes. T urn two full turns on each screw . Tighten center screw[...]

KEEP INST ALLA TION INSTRUCTIONS FOR THE LOCAL INSPECTOR’S USE. Plug power cord into a dedicated 15- to 20-amp electrical outlet. 7. 6. Replace house fuse or turn breaker back on. 4. Remove all packing material from the microwave oven. 2. Make sure the microwave oven has been installed according to instructions. 1. BEFORE YOU USE YOUR MICROW A VE[...]

24 Printed in China[...]