Fujitsu Fi-6240 manual

■ FCC Decl aration ............... ................ ............... i ■ Liability Note ...... ................ ................. ........... ii ■ Safety Precautions .......... ................ ............. iii Chapter1 PREPARING THE SCANNER .................. 1 1.1 Checking the C ontents of the Scanner Package .............. ................[...]

i INTRODUCTION Thank you for purchasing the fi -6140/fi-6240 Duplex Color Scanner. This document describes how to use fi-6140 /fi-6240 and basic operation methods. Before yo u start using fi-6140/fi-6240 be sure t o thoroughly read this manual to ensure correct use. The "fi-6140/fi-62 40 Operator’s Guide" stored on the Setup CD-ROM prov[...]

fi-6140/fi-6240 Image Sc anner Getting Started ii ■ Liability Note READ ALL OF THIS MANUAL CAREFULL Y BEFORE USING THIS PRODUCT . IF THIS PRODUCT IS NOT USED CORRECTL Y , UNEXPECTED INJUR Y MA Y BE CAUSED TO USERS OR BYST ANDERS. Also, keep this manual in a safe place so that it c an be easily referred to during use of this product. While all ef [...]

iii Manufacturer PFU LIMITED International Sales Dept., Imaging Business Division, Products Group Solid Square East T ower, 580 Horikawa-cho, Saiwai- ku, Kawasaki-shi Kanagawa 212-8 563, Japan Phone : (81-44) 540-4538 All Rights Reserved. Copyright © PFU LIMITED 2007 About Maintenance The user must not perform repairs on this scanner . Contact the[...]

fi-6140/fi-6240 Image Sc anner Getting Started iv T urn the scanner OFF if it is damaged. If the scanner is damaged for any reason, turn the scanner off and unplug the power cable. Contact the store where you purchased the scanner . Do not put liquids inside the scanner . Do not insert or drop metal objects in to the scanner . Do not scan wet docum[...]

1 Chapter1 PREP ARING THE SCANNER 1.1 Checking the Contents of the Scanner Package When you open the scanner package, make sure it contains all the parts listed in the package cont ents list that is included in the package box. If any parts are missing or defective, contact the dealer you purchased the scanner or an authorized Fujitsu scanner servi[...]

fi-6140/fi-6240 Image Scanner Getting Started 2 ■ Removable Parts The following shows the parts that can be remove d from the scanner. 1.3 Operator Panel The operator panel is located on the right side of the scanner. This panel is comprised of a Function Number Disp lay, four buttons, and a LED. *) About the settings on the launcher, refer to FU[...]

3 Chapter2 INST ALLA TION OF THE SCANNER 2.1 Installing the Scanner 1. Place the scanner at its installation site. For details on the scanner's dimensions and required installation space, refer to chapter 9 "Installation Specifications" of "fi-6140/fi-6240 Operator’s Guide" in the Setup CD -ROM. For fi-6140, go to Step 3.[...]

fi-6140/fi-6240 Image Sc anner Getting Started 4 ■ Connecting with the USB Cable 1. Connect the USB cable to the USB connector. 2. Connect the other end of th e USB cable to the PC. ■ Connecting with the SCSI Cable When using the scanner with a SCSI interface, the following SCSI cable and SCSI card must be purchased. • SCSI cable: Use a cable[...]

5 2.3 Installing the Scanner Software To scan documents with this scanner, you must install a scanner driver for operating the scanner as well as scanning software (hereinafter called the "application") for launching the driver and performing a scan . The scanner drivers and application provided with the scanner are as follows: • Scanne[...]

fi-6140/fi-6240 Image Sc anner Getting Started 6 5. Click [INSTALL PRODU CTS], and then click [TWAIN Driver]. 6. The Error Recover y Guide Installation dialog box appears. Error Recovery Guide is an application with wh ich you can view on-screen information for troubleshoot- ing errors that may occur in the scanner. This guide helps solve prob lems[...]

7 3. When the scanner is auto matically detected, [Found New Hardware Wizard] or [Add/Rem ove Hardwa re Wizard] dialog box app ears. Click the [Cancel] button to close the Wizard dialog box. 4. Insert the "Setup CD-ROM" into the CD drive. ⇒ <SETUP DISK ST ART UP SCREEN> appears. 5. Click [INSTALL PRODUCTS], and then clic k [ISIS D[...]

fi-6140/fi-6240 Image Sc anner Getting Started 8 3. Select a language for the installa tion on [Choose Setup Language] dialo g box, and then click the [OK] button. 4. Proceed with the inst a llation, following the on- screen instructions. 5. When the [InstallShield Wizard Complete] dialog box appears, click the [Finish] button. Error Recovery Guide[...]

9 3. In the dialog box below, click the [Next] button. 4. Install the applicati on, following the on-screen instructions. 2.4 Checking Scanner Driver Operation This section explains how to check the operation of the installed scanner driver by using ScandAll PRO. Make sure that the scanner dr iver is installed prop erly, following the procedure bel[...]

fi-6140/fi-6240 Image Sc anner Getting Started 10 7. Select a scanner in the displaye d dialog box. To use FUJITSU TWAIN 32: Select [FUJITSU fi-6140dj] or [FUJITSU fi-6240dj], and then click the [Select] button. To use FUJITSU ISIS : Select [Fujitsu fi-6140] or [Fujitsu fi-6240d j] and then click the [Select] button. 8. Select [Scan] on the menu, a[...]

11 If the scanned document image is displayed in the windo w, it means that the scanner driv er is installed properly . For further information about how to scan documents, refer to "fi-6140/fi-6240 Operato r’s Guide" contained in t he Setup CD-ROM . 2.5 Uninstalling Supplied Programs The following explain s how to uninstall software ap[...]

fi-6140/ fi- 6240 Image Scanner Getting Started AP-1 Appendix1 TROUBLESHOOTING ■ Troubleshooting checklist Symptom Check this item Remedy Scanner does not turn on. Have you pressed the power button on? Push the power button. Are the AC cable and AC adapter properly connected to the scanner? Correctly connect the AC cable and the AC adapter. Disco[...]

AP-2 Appendix2 D AIL Y CARE ■ Cleaning Materials *1: For details about the clean ing materials, contact the FUJITSU scanner dealer where you purchased the scanner. *2: Pre-moistened with Cleaner F1, Cleaning Wipes are used instead of moistened cloths. ■ Cleaning Method The ADF must be cleaned with a lint-free cloth moistened with the Cleaner F1[...]

fi-6140/ fi- 6240 Image Scanner Getting Started AP-3 Appendix3 REPLA CING CONSUMABLES ■ Consumables and Replacement Cycles The followings are the specifi cations of consumables and their recommended replacement cycles. To purchase consumables, cont act the store where you pur- chased the scanner or an aut horized FUJITSU scanner service provider.[...]

z Copying of the contents of this manual in whole or in part and copying of the scanner application is prohibi ted under the copy- right law. z The contents of this manual are subject to change without notice. z PFU LIMITED is not liable whatso ever for any damages resulting from use of this scanner and proc edures described in this manual, profit [...]