Hoover HF7 160E manual

® W ashing machine Instructions f or use HF7 160E 40000287.qxd 13/11/2003 13:02 Page 1[...]

Contents P age Introduction 3 General deliv er y notes 4 Saf ety notes 4 Quick start 5 Installation & testing 6 Useful advice f or the user 11 Description of controls 12 Detergent dra wer 14 Detergents, w ashing aids and amounts to use 15 Programme selector 17 The main wash 18 Consumption data 22 Programme T able 23 Cleaning and routine mainten[...]

Intr oduction Please read and f ollow these instructions carefully and operate the machine accordingly .This booklet provides impor tant guidelines f or saf e use, installation, maintenance and some useful advice f or best results when using your machine. K eep all documentation in a safe place f or future ref erence or f or any future owners . 3 N[...]

General delivery notes Please check that the f ollowing items are deliv ered with the appliance: – Instruction manual – Guarantee card – Blanking plug – Inlet hoses & brac ket – Base panel & x2 push clips Check that no damage has occurred to the machine during transit. If it has, call f or ser vice b y GIAS (tel: 08705 400 600). P[...]

K) When moving the appliance nev er lift it by the controls , the detergent dra wer , the hoses or the power cab le. T o avoid damaging the door when mo ving the appliance nev er rest the door against objects e.g a trolle y . L) IMPOR T ANT! If the appliance is installed on a car peted floor ensure that the v entilation through the base of the appl[...]

Remov e the machine from the packaging - close to where it will finally be positioned - and proceed as f ollows: On the back of the machine 1) Remov e the central screw A and side screws B and pull out the tr ansit brac ket C along with the red locator . 2) Tilt the machine f orward and remov e the polystyrene spacers. 3 Cov er the central hole usi[...]

Note: we recommend y ou keep the transit bracket and screws to pr otect the machine f or future transit. The Manufacturer s will not be responsible for an y damage to the machine caused b y not follo wing the instructions relating to releasing the transit pr otection. The user is responsible f or all installation costs. 7 Connecting the fill hoses [...]

If the inlet hose’ s connection point is changed, check that the 3/4” threaded f err ule on the inlet hose is firmly attached to the electrovalv e connector . W ater supply requirements Connect the machine to the drainage system used b y household sinks. 8 THIS MA CHINE MUST BE CONNECTED IN A CCORD ANCE WITH THE W A TER SUPPL Y REGULA TIONS. W [...]

T esting the installation Ref er to the programme guide f or details of how to select programmes. 1. T urn on the water supply and check f or leaks from fill hoses. 2. Switch on the electricity supply . 3. Select a spin programme and then press the ST ART/P A USE button to start the machine. Allow the progr amme to continue for one min ute and then[...]

T o ensure the dr um is thoroughly clean after testing and storage , select programme 1 and run the machine f or a complete cycle using only wash detergent and water . If the machine is not to be used immediately , s witch off the mains power supply and remov e the plug from the power soc ket. W e also recommend that the water stop taps are tur ned[...]

11 Useful washing ad vice Tips on using your appliance in the most en vironmentally-fr iendly and economical way Loading y our washing machine T o make fur ther reductions of energy , water and detergent consumption, w e recommend that you put a full load into y our machine. Energy savings of up to 50% can be achie ved by w ashing one full load com[...]

Description of Contr ols All the controls on your product’ s control panel are listed as f ollows . The button function is selected when the button neon is lit. Carefully read the relev ant descriptions detailed below: ST ART/P A USE ST ART After selecting the programme press the ST AR T/P A USE button once to start the machine. The door lock ed [...]

The tables in the w ashing section descr ibe the v ar ious prog rammes and illustrate the number or symbol to select f or them. 13 Note: this model is fitted with an electronic “sensor” device that chec ks the load is balanced correctly . If the load is slightly unbalanced the machine will re-balance it automaticall y to then carry out the norm[...]

– the third, labelled “ ” is f or special additives , fabric softeners, frag rances, starch, brighteners etc. The machine is programmed to automatically tak e up additives during the final rinse stage for all w ash cycles. 14 Note: only put special ad ditives, fabric softeners, fragrances, star ch, brighteners, etc, in the thir d compar tment[...]

Deter gents, washing aids and amounts to use Choice of detergent General purpose detergents – P owder detergents, f or a thorough wash, with bleaching agents , are par ticularly suitable f or use in hot wash progr ammes (60°C and over), f or heavily soiled and stained laundr y . – Liquid detergents, are par ticularly suitable f or grease stain[...]

Bef ore pour ing in the detergent chec k that there are no foreign bodies in the detergent dra wer . Dosage details are usually shown on the detergent pac kaging. Follo w those instructions! Dosages Only use detergents which are suitable f or use in a washing machine . Y ou will obtain the best results from your w ash with the minimum use of chemic[...]

17 Pr ogramme selector The washing machine has diff erent programme groups according to type of w ash, temperature, spin speeds and dur ation for handling the v ar ious types of f abric and their le vel of soiling (see wash prog ramme guide). 1. CO TTONS The programmes are designed f or maximum washing and rinsing. With spin cycles in between, the [...]

18 D AIL Y W ASH 40°C - F AST 29' A complete washing cycle (w ash, r inse and spin), ab le to wash in appro ximately 29 minutes: - a maximum load of 2 KGs; - lightly soiled f abr ics (cotton and mix ed fabrics). W e recommend, with this programme, a 20% detergent loading dose (compared to the nor mal one), in order to a void detergent w aste.[...]

Sor ting the laundry – It is recommended you w ash only items which are washable with w ater and detergent and not dr y-clean items . – If you need to w ash r ugs , bedspreads or other heavy items, it is best not to spin them. – Sor t the laundry according to fabric type, degree of soiling and w ash temperature: f ollow the labelling on the g[...]

Note: when sor ting laundry – check there are no metal objects in the laundr y (such as paper clips, saf ety pins, pins, coins etc...); In the e vent of a machine f ailure dur ing the warranty period and f oreign objects are f ound to be the cause of the f ailure a labour charge ma y be made for the call out of an engineer . – button up pillowc[...]

Putting detergent in machine D) Open the dra wer , choose the detergent and put in the correct amount, according to the manuf acturer’ s instr uctions and the detergent advice section within this manual. Add any other laundry aids (see page 15). Close the dra wer again. Liquid detergents that are to be placed directly into the drum should use the[...]

W ater and electricity consumption and appr o ximate length of programmes selected 22 The abov e results are based upon cold fill water (15°C) and maximum load capacities. * Programme length is v ariable depending on the type of f abr ic in the loads, the weight of the load, the wash temper ature and pressure of the water as it enters the machine.[...]

23 PROGRAMME F ABRIC TYPE PROGRAMME FOR LO AD W A TER DETERGENT TEMP °C II I Whites Colourfast f abrics Intensive - hea vily 7 90° ** Cotton, linen, hemp soiled Whites & Cotton, colourfast Normal soiling 7 60° ** * +P Prew ash mixed fibres Coloureds Cotton, mixed f abrics Normal-Light soiling 7 60° ** F ast Colour F ast Coloureds Cotton, mi[...]

24 P oints to consider: When washing hea vily soiled laundr y it is recommended the load is reduced by about 1-1.5 kg. By doing so the laundry is allowed to circulate more freely . Energy label data based on programme 3 tested in accordance with EN60456. PROGRAMME F ABRIC TYPE PROGRAMME FOR LO AD W A TER DETERGENT TEMP °C II I Special AA Cottons, [...]

25 Cleaning and r outine maintenance Do not use alcohol-based scourers and /or thinners on the outside of your washing machine , just a wipe with a damp cloth will suffice. The w ashing machine needs very little maintenance: – Cleaning the dra wer compar tments. – Cleaning the filter . Cleaning the drawer Clean the compar tments occasionally to[...]

T ransporting or storing the appliance f or long periods when appliance is not in use If the appliance is being transpor ted or is out of use f or long per iods in unheated places , all remaining water must be completely remo ved from all hoses. Ensure mains power plug is disconnected, then unclip the discharge hose and lower it into a basin on the[...]

27 T r ouble shooting What might be the cause of... Defects y ou can remedy y ourself Bef ore calling GIAS Ser vice f or technical advice please run through the follo wing checklist. A charge will be made if the machine is found to be w or king or has been installed incorrectly or used incorrectly . If the prob lem persists after completing the rec[...]

It is unlikely that water will be visib le in the drum! This is due to the latest technology that achie ves the same standar d of washing and rinsing b ut with far less water consumption. 28 Note: The use of environmentally-friendly , phosphate-free detergents (check detergent inf or mation on pack) can ha ve the f ollowing eff ects: – waste w at[...]

P o wer failure If there is a power f ailure the wash cycle will be interrupted, the wash prog ramme and functions will be suspended. When the power is restored, the w ash programme and functions will re-star t from the same point and complete the programme . The load can be remov ed from the machine dur ing a po wer failure as f ollows: The water [...]

T echnical data • Max. load of dry laundr y 7kg • W ater pressure (0.5-8 bar) 0.05-0.8 MP a • Spin speed 1600 r pm Measurements • Width 50cm • Depth 54cm • Height 85cm 30 NB: F or specifications regarding electr ical data, see the data plate on the front of the washing machine (door area). Y ou will also need to refer to the inf ormatio[...]

Customer Service The appliance is cov ered by a cer tificate of guarantee which allo ws you free use of the Hoov er T echnical Suppor t Service (ter med GIAS tel: 08705 400 600), e xcept for the price of the call, for a period of one y ear from the date of purchase. Remember to send off the guarantee cer tificate f or validation within 10 da ys of [...]

F or ser vice and repairs please call our national number: Hoo ver T ec hnical - T el: 08705 400 600 Suppor t Service [ Eire 018301 666 ] Alwa ys use genuine Hoov er spares, a vailab le direct from GIAS Ser vice: Hoo ver Spares Ser vice T el: 01204 556111 Hoo ver care T o maintain your Hoov er product in peak condition you ma y wish to take out a H[...]