Hotpoint HP21WR manual

Thank you for selecting Hotpoint air conditioners. Please read this manual carefully before operation and keep it for further reference. Room Air Conditioner OPERA TING INST R UCTIONS HP21WC -Cooling Only HP21W R -Reverse Cycle[...]

[...]

Please read this op erating manual care- fully before operat ing the unit . Thank you for choosing a Hotpoint air conditioner. Our design is based on the best efficiency and the lowest noise operation and it can keep the room comfortable. Please read this operating manual carefully before operating the unit and keep it for consultation. CONTENTS Fu[...]

1 Function Introduction W indow type room air conditioners of Hotpoint can regulate the room temperature and dry the room. It is convenient for your work,study and life. It can be widely used in residence, shop, hotel, office, library and laboratory, and so on. Room temp. Spring Summer Autumn Wind direction Winter Cooling in summer In hot summer, A[...]

2 2 Operating Condition Please operate air conditioner in the correct conditions as follow s . Power requirement (15Amp/15Amp Circuit) COOL mode operatio n DRY mode operation Outdoor temperature should be in range of 18 to 43 , otherwise it is possible for air conditioner to breakdown. Outdoor temperature should be in range of 18 to 43 , otherwise [...]

The distance of obstructions from window unit inside should be upper 300mm, lower 1500mm, left 500mm,right 500mm, front1500mm. 3 Installation Installation precaution: W indow type conditioner is so valuable and the improper installa- tion of it will cause a lot of damage! Please consult with a licenced technician to install the unit and don’t ins[...]

Sunshade board Wall Wooden frame Rubber plate Support 4 Horizontal line Horizontal line Drain water: T o get the maximum cooling efficiency , the air conditioner is designed to splash the condensation water on the condenser coil. To the cooling only unit, If the splashing sound annoys you, you can provide an outside drain by using the follo -wing p[...]

5 Notes for i nstallation Remove Before removing air conditioner to an other place, you should contact the installer first. Then it must be done under the direction of a licenced technician. In addition, the charge of this must be paid. Noise Electric wiring Install in a location that is firm enough to avoid the enlargement of noise and vibration. [...]

6 P A R T IDENTIFIC A TION Vertical airflow direction vane (Airfl o w di r ection adjustment up and down). The vertical airflow direction vane is controlled by positioning the vane to discharge the air upwards, downwards or straight out. Air direction adjustment Air filter (behind the front intake grille) F ront inta k e g r ille) Control panel P o[...]

Main switch operation procedure 1.Main Control Knob Set to Low Cool,Med Cool or High Cool as desired(FAN setting operates the fan only.) CAUTION:If the main control knob is turned off of changed to a fan setting from a cooling operation setting. 2.Thermostat control Knob WAIT at teast 3minutes before resetting to cooling operation. not as des[...]

ON/OFF button ON/OFF Remote control Signal transmitter AUTO COOL DRY FAN Middle fan ● Press this button, Auto, Cool,Dry, Fan, Heat mode can be selected circularly. MODE button MODE Auto mode is default while power on. U nd e r Au to m od e, th e te mp er at ur e wi ll n ot be displayed; Under Heat mode, the ● Press this button, Sleep On and Sle[...]

Name and function of wireless remote control Note: This wireless remote control is universal, and it could be used for many units, some buttons of this control which are not available to this unit will not be described below. Remote control ● Under the Cool and Dry mode, press this button once, the unit will enter "energy ENERGY SAVER button[...]

Note: This wireless remote control is universal, and it could be used for many units, some buttons of this control which are not available to this unit will not be described below. Name and function of wireless remote control ● When it is pressed,the louvers start to rotate automatically and stop when SWING BUTTON TIMER OFF BUTTON ● At unit on,[...]

Guide for operation- general operation or timer off. When AUTO RUN mode is selected, the setting temperature will not be displayed on the LCD, the unit will be in accordance with the room temp. automatically to select the suitable running method and to make ambient comfortable. About lock Press +and - buttons simultaneously to lock or unlock the ke[...]

1. Press swing up and down button continuously more than 2s,the main unit will swing back and forth from up to down, and then loosen the button, the unit will stop swinging and present position of guide louver will be kept immediately. 2. Under swing up and down mode, when the status is switched from off to , if press this button again 2s later, st[...]

If wireless remote controller is lost, open the surface panel and operate manually. Note: ＣＬＯＳＥ　　　　　ＶＥＮＴ　　　　　ＯＰＥＮ ＣＬＯＳＥ　　　　　ＶＥＮＴ　　　　　ＯＰＥＮ -"OPEN" position,the ventilation door opens to allow air,smoke or odors to be expelled from the room. -"C[...]

Operation T ips Operation for comfort and economy Do not overcool the room temperature . This is not good for health and wastes electricity. Keep blind or curtains closed . Do not let sunshine enter the room directly when the air con- dition is in operation. Keep the room temp. uniform . Adjust the vertical and horizon- tal airflow direction to ens[...]

1 5 Caution Do not use the air conditioner for other purposes except for cooling the room. Do not use the air conditioner for other purposes such as drying clothes, preserving foods, or cultivating vegetables. Do not block the air intake and outlet vents . This causes lowered perfor- mance and irregular operation. Do not insert sticks or other obje[...]

1 6 Care and maintenance Always turn o f f the air conditioner and main power supply before cleaning to ensure safet y . Cleaning unit 1. Cut power o f f before cleaning. 3. Don ’ t use gas, benzene, solvent,wash, chemical solvent, etc. for cleaning. 4. Do not splash water directly into indoor * Check earth wire Vacuum cleaner Plug out only after[...]

T rouble shooting guide Fault phenomenon Trouble-shooting Air conditioner dose not operate at all. * Is there a power failure? * Is the plug out? * I s power fuse or switch off ? * Whether the voltage is too high or too low? * Is air inlet or outlet locking? * Is there any other heat /cool source in room? * Are air filters dirty very much? * Is ind[...]

*Operation starts or stops abnormally; *Power fuse or switch often breaks; *Carelessly splash water or something into air conditioner; *Electrical lines are much hot or lines cover breaks; *Other strange situations. Immediately stop all operations and plug out, please contact your dealer in the following situations. After service If your air condit[...]

NATIONAL SERVICE NUMBER – 1300 303 929 Hotpoint (Aust) Pty Ltd ABN 68 082 599 086 WARRANTY RECORD Please complete all details below should warranty service be required on your new Hotpoint air co nditioner. This form must be completed by the customer and the installer. Please retain this form and attach yo ur receipt to it. Should you require any[...]

NATIONAL SERVICE NUMBER – 1300 303 929 Hotpoint (Aust) Pty Ltd ABN 68 082 599 086 PROBLEMS THAT MAY NOT BE COVERED UNDER WARRANTY Hotpoint (Aust) P ty Ltd reserves the righ t to ref use warranty if reported problem s arise from situations outside their cont rol. For example: 1. Systems of inappropriate capacity for area(s ) served , e.g. not size[...]

Hotpoint (Aust) Pty Ltd W eb Site: www.hotpoint.com.au 66129905991[...]