JVC UX-J60 manual

GVT0102-005B [A] For Customer Use: Enter below the Model No . and Serial No. which are located either on the rear , bot- tom or side of the cabinet. Retain this inf or mation f or future reference . Model No . Se r ia l N o. SP-UXJ50 CA-UXJ50 RM-SUXJ50U REMOTE CONTROL SP-UXJ50 SP-UXJ60 CA-UXJ60 RM-SUXJ60U REMOTE CONTROL SP-UXJ60 UX-J60 — Consists[...]

G-1 W arnings, Cautions and Others CA UTION—ST ANDBY/ON button! Disconnect the mains plug to shut the pow er off completely (the ST ANDBY/ON lamp goes off). The ST ANDBY/ON button in an y position does not disconnect the mains line. • When the unit is on standby , the ST ANDBY/ON lamp lights red. • When the unit is turned on, the ST ANDBY/ON [...]

G-2 10 cm 15 cm 15 cm 1 cm 1 cm 15 cm 15 cm 15 cm Front vie w CA UTION: Pr oper V entilation T o a void risk of electric shock and fire, and to pre vent damage , locate the apparatus as follo ws: 1 F ront: No obstructions and open spacing. 2 Sides/ T op/ Back: No obstructions should be placed in the areas shown by the dimensions belo w . 3 Bottom: [...]

1 Introduction About This Manual This manual is org anized as follows: • The manual mainly explains operations using the b uttons on the remote contr ol. Y ou can use the buttons both on the r emote control and on the main unit f or the same operations if they ha ve the same or similar names (or marks), unless mentioned otherwise. The illustratio[...]

2 Contents Location of the Buttons and Control ..................................... 3 Front Panel ........................................................................................... 3 Remote Control .................................................................................... 5 Getting Started .......................................[...]

3 Front Panel UX-J60 1 2 3 4 8 9 p q e r y u i t w 5 6 7 MICRO COMPONENT SYSTEM FOR UX-J50: FOR UX-J50: Location of the Buttons and Control Become familiar with the b uttons and control on your unit. Front Panel EN01-13_UX-J60&50[A]f.pm6 03.2.25, 5:08 PM 3[...]

4 Front Panel 1 Disc tray 2 Display windo w 3 REV .MODE (re verse mode) b utton (17 – 19) 4 A UX b utton (9) Pr essing this button also turns on the unit. 5 ST ANDBY/ON button and ST ANDBY/ON lamp (9, 21) 6 REC (recording) button (18, 19) 7 Multi operation b uttons • DO WN/ 4 (re verse skip), 7 (stop) and ¢ (forward skip)/UP 8 CD ‹ / 8 (play[...]

5 See the pages in parentheses for details. 1 Number buttons 2 B ASS button (10) 3 Multi operation buttons • UP , 4 (rev erse skip), 7 (stop), ¢ (forward skip), and DO WN 4 SET button (15) 5 Source buttons • CD 3 / 8 , T APE 2 3 , FM/AM, and A UX Pr essing one of these buttons also turns on the unit. 6 CD 0 (disc tray open/close) b utton (14) [...]

6 Getting Started Supplied Accessories Make sure that y ou have all the follo wing items. The number in parentheses indicates the quantity of each piece supplied. • AM loop antenna (1) • FM antenna (1) • Remote control (1) • Batteries (2) • Speaker cords (ONL Y FOR UX-J60) (4) If anything is missing, consult your dealer immediately . Putt[...]

7 INPUT INPUT INPUT INPUT RIGHT LEFT MAIN SPEAKERS CAUTION: SPEAKER IMPEDANCE 6 -16 SUBWOOFERS RIGHT LEFT 1 If the cords are co ver ed with insulation, r emove a short section of insulation at the end of each cord by twisting and pulling it off. 2 Connect the AM loop antenna to the AM LOOP terminals as illustrated. 3 T urn the AM loop antenna until[...]

8 RL AUX L R L R Speaker grille T o remo ve the speaker grille, insert your f ingers at the top of the speaker grille, pull to wards you. Then pull the bottom tow ards you. T o attach the speaker grille, put the projections of the speaker grille into the holes of the speaker . Holes Projections 1 If the cords are co ver ed with insulation, r emove [...]

9 Common Operations Setting the Clock Before operating the unit any further , f irst set the unit’ s clock. When you plug the A C power cord into the wall outlet, “0:00” starts flashing on the display . Y ou can set the clock whether the unit is on or of f. • There is a time limit in doing the follo wing steps. If the setting is canceled be[...]

10 Adjusting the Volume Y ou can adjust the volume le vel only while the unit is turned on. The v olume le vel can be adjusted between “ V OL MIN ” and “ V OLUME 1 ” – “ V OLUME 40 (V OL MAX). ” On the remote contr ol: Press V OLUME + to increase the v olume or press V OLUME – to decrease it. On the unit: T urn V OLUME + / – contr[...]

11 Selecting the Display Color (ONL Y FOR UX-J60) Y ou can select the display color (COLOR 1 – COLOR 5 and A UT O mode). • A UTO mode changes the color (COLOR 1 to COLOR 5) gradually . T o select the color , press COLOR. • Each time you press the button, the color changes as follows: COLOR AUTO COLOR 1 COLOR 2 COLOR 4 COLOR 3 COLOR 5 DIMMER T[...]

12 Listening to FM and AM Broadcasts T uning in to a Station 1 Press FM/AM to select the band . The unit automatically turns on and tunes in to the pre viously receiv ed station — either FM or AM. • Each time you press the button, the band alternates between FM and AM. 2 Press and hold ¢ or 4 f or more than 1 second. The unit starts searching [...]

13 T uning in to a Preset Station On the remote contr ol ONL Y : 1 Press FM/AM to select the band . The unit automatically turns on and tunes in to the pre viously receiv ed station — either FM or AM. • Each time you press the button, the band alternates between FM and AM. 2 Press UP or DO WN to select a preset n umber . T o tune in to a preset[...]

14 Playing Back Discs This unit has been designed to play back the follo wing discs —CD, CD-R, and CD-R W . When playing a CD-R or CD-RW User-edited CD-Rs (CD-Recor dable) and CD-R Ws (CD-ReWritable) can be played only if they are alr eady “finalized . ” • Usually you can play back your original CD-Rs or CD- R Ws recor ded in music CD forma[...]

15 Basic Disc Operations While playing a disc, you can do the follo wing operations. T o stop playing for a moment During play , press CD 3 / 8 . While pausing, the elapsed playing time flashes on the display . T o resume playing, press CD 3 / 8 again. T o go to another track Before or during play , press ¢ or 4 repeatedly . • ¢ : Skips to the [...]

16 Repeating T racks — Repeat Play Y ou can have all the trac ks, the program or individual track currently playing, repeat as many times as you lik e. On the remote contr ol ONL Y : T o repeat playing, press REPEA T before or during play . • Each time you press the button, Repeat Play changes as follows, and the f ollowing repeat indicator lig[...]

17 Playing Back T apes Y ou can play back type I tapes. Playing Back a T ape 1 Press PUSH OPEN 0 on the unit. 2 Put a cassette in with the exposed part of the tape down. 3 Press PUSH OPEN 0 again to close the cassette holder . 4 Press T APE 2 3 . The unit automatically turns on and the tape starts playing. The tape direction indicator ( 3 or 2 ) fl[...]

18 Recording Recording on a T ape On the unit ONL Y : 1 Put a recordable cassette in with the exposed part of the tape down. 2 Close the cassette holder gently and check the recording dir ection f or the tape. • If the tape direction is not correct, press T APE 2 3 twice then 7 to change the tape direction. • If you want to record on both sides[...]

19 Disc Direct Recording Everything on the disc goes onto the tape in the order it is on the disc, or according to the order you ha ve set in Program Play . On the unit ONL Y : 1 Put a r ecordable cassette in with the exposed part of the tape down. 2 Load a disc. • If the current playing source is not the CD player , press CD 3 / 8 , then 7 befor[...]

20 Using the T imers There are three timers av ailable—Daily T imer, Recording T imer , and Sleep Timer . Before using the timers, you need to set the unit’ s clock (see page 9). Using Daily Timer and Recor ding Timer Y ou can set the timer whether the unit is on or of f. How the timer actually works When the on-time comes, the unit automatical[...]

21 5 Press UP or DO WN to set the volume le vel, then press CLOCK/TIMER. • Y ou can select the volume le vel (“V OLUME – –” and “V OLUME 0” to “V OLUME 40”). If you select “V OLUME – –, ” the volume is set to the previous le vel when the unit w as turned off. • T o turn off the v olume while the Recording T imer ( REC TU[...]

22 Maintenance Handling cassette tapes • If the tape is loose in its cassette, take up the slack by inserting a pencil in one of the reels and rotating. • If the tape is loose, it may get stretched, cut, or caught in the cassette. • Be careful not to touch the tape surface. • A void storing tapes in the follo wing places: —In dusty places[...]

23 T roubleshooting If you are ha ving a problem with your unit, check this list for a possible solution before calling for service. If you cannot solve the problem from the hints gi ven here, or the unit has been ph ysically damaged, call a qualified person, such as your dealer , for service. Symptom No sound is heard. Hard to listen to broadcasts[...]

24 Specifications Design and specifications ar e subject to c hange without notice. UX-J60 (CA-UXJ60 and SP-UXJ60) Amplifier Output Po wer: SUBWOOFERS: 90 W (45 W + 45 W) at 6 Ω (10% THD) MAIN SPEAKERS: 30 W (15 W + 15 W) at 6 Ω (10% THD) Audio input sensiti vity/Impedance (at 1 kHz) A UX: 400 mV/48 k Ω Speakers/Impedance: 6 Ω – 16 Ω T [...]

EN 0503MWMMDWJEM © 2003 VICTOR COMPANY OF JAPAN, LIMITED VICT OR COMP ANY OF JA P AN, LIMITED Cover_UX-J60&50[A]ff.pm6 03.5.23, 1:15 PM 2[...]