Kenwood KRC-466 manual

KRC-566 KRC-466 KRC-366 ©B64-2447-00/00 (MW/IW/MN) CASSETTE RECEIVER INSTRUCTION MANUAL KRC-566(M)_U.S r1 02.9.26 4:28 PM Page 1[...]

— 2 — English Contents Safety precautions ......................3 About Cassette tape ...................4 General features .........................5 Power Selecting the Source V olume Attenuator Loudness System Q Audio Control Speaker Setting Clock Display Adjusting Clock DSI (Disabled System Indicator) Theft Deterrent Faceplate T uner featur[...]

— 3 — To prevent injury or fire, take the following precautions: • Insert the unit all the way in until it is fully locked in place. Otherwise it may fall out of place when jolted. • When extending the ignition, battery , or ground wires, make sure to use automotive- grade wires or other wires with a 0.75mm 2 (A WG18) or more to prevent wir[...]

— 4 — English • If you experience problems during installation, consult your Kenwood dealer . • If the unit does not seem to be working right, try pressing the reset button first. If that does not solve the problem, consult your Kenwood dealer . •P ress the reset button if the Disc auto changer fails to operate correctly . Normal operatin[...]

Increasing V olume Press the [ u ] button. Decreasing V olume Press the [ d ] button. V olume Press the [SRC] button. Source required Display T uner "TUnE" T ape "T APE" External disc "DISC"/"CD" Standby (Illumination only mode) "OFF" Selecting the Source Tu rning ON the Power Press the [SRC] button[...]

1 Select the source for adjustment Press the [SRC] button. 2 Enter Audio Control mode Press the [AUD] button for at least 1 second. 3 Select the Audio item for adjustment Press the [FM] or [AM] button. Each time the button is pressed the items that can be adjusted switch as shown below . 4 Adjust the Audio item Press the [ 4 ] or [ ¢ ] button. Adj[...]

A red indicator will blink on the unit after the faceplate is removed, warning potential thieves. 1 Tu rn the power OFF Press the [SRC] button for at least 1 second. 2 Set the DSI While pressing the [#1] and [#3] button, press the [SRC] button. Each time the step 1 and 2 operation is done the DSI turns ON or OFF . DSI (Disabled System Indicator) 1 [...]

T uner features The faceplate of the unit can be detached and taken with you, helping to deter theft. Removing the Faceplate Press the Release button. The faceplate is unlocked, allowing you to detach it. • The faceplate is a precision piece of equipment and can be damaged by shocks or jolts. For that reason, keep the faceplate in its special sto[...]

Calling up the stations in the memory . 1 Select the band Press the [FM] or [AM] button. 2 Call up the station Press the [#1] — [#6] button. Preset T uning Putting the station in the memory . 1 Select the band Press the [FM] or [AM] button. 2 Select the frequency to put in the memory Press the [ 4 ] or [ ¢ ] button. 3 Put the frequency in the me[...]

Cassette player features Changing the tuning frequency step. The original setting is FM band 50 kHz, and AM band 9 kHz. 1 Tu rn the power OFF Press the [SRC] button for at least 1 second. 2 Switch the frequency step While pressing the [#1] and [#5] button, press the [SRC] button. The frequency step changes to FM band 200 kHz, and AM band 10 kHz. ?[...]

Repeating the present song. Press the [REP] button. Each time the button is pressed the Music Repeat turns ON or OFF . When it's ON, the "REP" indicator is ON. Music Repeat Fast forwarding automatically when an unrecorded portion continues for at least 10 seconds. Press the [B.S] button. Each time the button is pressed the Blank Skip[...]

Fast Forwarding Hold down on the [ ¢ ] button. Release your finger to play the disc at that point. Reversing Hold down on the [ 4 ] button. Release your finger to play the disc at that point. Fast Forwarding and Reversing Playing discs set in the optional accessory disc player connected to this unit. Press the [SRC] button. Select the display for [...]

Play the songs on all the discs in the disc changer in random order . Press the [M.RDM] button. Each time the button is pressed the Magazine Random Play turns ON or OFF . When it's ON, the "RDM" indicator is ON and the track and disc number blink. When the [ ¢ ] button is pressed, the next song select starts. Magazine Random Play (F[...]

[VOL.] buttons Adjusting the volume. [SRC] button Each time the button is pressed the source switches. For the source switching order refer to <Selecting the Source> (page 5). [A TT] button Tu rning the volume down quickly . When it is pressed again it returns to the previous level. Basic operations Use one lithium battery (CR2025). Insert th[...]

[ 4 ]/ [ ¢ ] buttons Doing track forward and backward. [DISC+]/ [DISC–]buttons Doing album forward and backward. [ 38 ] button Each time the button is pressed the song pauses and plays. In Disc source [ 4 ]/ [ ¢ ] buttons Do <T ape Advance> (page 11). [ 38 ] button Plays the reverse side of the tape. [FM ] button Fast forwards the tape. W[...]

English — 16 — The use of any accessories except for those provided might result in damage to the unit. Make sure only to use the accessories shipped with the unit, as shown above. 1. T o prevent a short circuit, remove the key from the ignition and disconnect the - battery . 2. Make the proper input and output wire connections for each unit. 3[...]

ANT. CONT. P.CONT FRONT • L FRONT • R REAR • L REAR • R – + — 17 — FM/AM antenna input 1 Rear left output (White) 23 Rear right output (Red) 28 Fuse (10A) 24 2 KENWOOD disc changer control input Wiring harness (Accessory 1 ) 25 29 White/Black 32 Gray/Black 38 Purple/Black White 31 Gray 34 Green 37 Purple 40 To front left speaker 30 To[...]

English — 18 — Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (for example, the sound may skip). Metal mounting strap (commercially available) Self-tapping screw (commercially available) Firewall or metal support Screw (M4X8) (commercially available) ■ Installation 8 mm MAX. ø5mm ø5mm 8mm[...]

— 19 — ■ Removing the hard rubber frame 2 When the lower level is removed, remove the upper two locations. The frame can be removed from the top side in the same manner . Catch Lock 1 Engage the catch pins on the removal tool and remove the two locks on the lower level. Lower the frame and pull it forward as shown in the figure. Accessory 2 R[...]

English — 20 — What might seem to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems. General ? The power does not turn ON. 01 ✔ The fuse has blown. ☞ After checking for short circuits in the wires, replace the fuse with one [...]

— 21 — ? Blank Skip functions at places that are recorded. 48 ✔ Because the recording level is low , it’ s recognized as not recorded. ☞ Tu rn Blank Skip OFF . Disc source ? "A Vin" is displayed without achieving External disc control mode. 50 ✔ O-N switch is set to "O" side. ☞ Set the switch to "N" side.[...]

English — 22 — The following messages are displayed when your system condition. E-01: No disc magazine has been loaded in the changer . The disc magazine is not completely loaded. ➪ Load the disc magazine properly . E01 No CD in the unit. ➪ Insert the CD. E-02: No disc has been loaded in the disc magazine. E02 ➪ Load a disc into the disc [...]

— 23 — FM tuner section Frequency range (50 kHz space) ...............87.5 MHz –108.0 MHz (200 kHz space) .............87.9 MHz –107.9 MHz Usable sensitivity (S/N = 30dB) ................... 9.3 dBf (0.8 µV/75 Ω ) Quieting Sensitivity (S/N = 50dB) .............. 15.2 dBf (1.6 µV/75 Ω ) Frequency response ( ± 3 dB) ...................[...]

KRC-566(M)_U.S r1 02.9.26 4:28 PM Page 24[...]