Lennox Hearth S260 T-TOP manual

INST ALLA TION AND OPERA TION MANUAL W ARNINGS • Hot! Do not touch! The glass and surfaces of this appliance will be hot during operation and will retain heat for a while after shutting off the appliance. Severe burns may result. • Carefully supervise children in the same room as appliance. Save These Instructions For Future Reference W ood S t[...]

2 USING THIS MANUAL Please read and carefully follow all of the instructions found in this manual. Please pay special attention to the safety instructions provided in this manual. PRODUCT IS SUBJECT TO CHANGE WITHOUT NOTICE CONGRA TULA TIONS! When you purchased your new wood stove, you joined the ranks of thousands of individuals whose answer to th[...]

3 IM POR T ANT SA F E T Y AND W AR NI ING IN FOR MA T IO N REA D TH IS MA NU AL IN I TS EN TI RE TY AN D UN DER - ST AND TH ES E RUL ES T O F OL LO W FOR S AF ETY . 1. When this room heater is not properly installed, a house fire may result. T o reduce the risk of fire, follow the installation instructions. Contact local building or fire offici[...]

4 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. T o pass inspection in nearly any jurisdiction, the chimney must meet both safety and exhaust flow requirements. The (3’ by) 2’ by 10’ rule applies to both masonry and factor y-built chimneys. * Ref. USA - National Standard, NFPA 211-latest edition and Canada National Standard CSA B365-[...]

5 This appliance is not designed to be operated in a negative pressure. In very airtight homes with large kitchen exhaust fans, furnace cold air returns, fresh air exchange systems and any other air system in close proximity to the heating appliance may create a negative pressure in the same room as the heating appliance. This can create dangerous [...]

6 WARNING: BE ABSOLUTEL Y SURE THE DIST ANCE BETWEEN THE HEA TER AND THE SURF ACE OF ANY COMBUSTIBLE CON- STRUCTION IS NOT LESS THAN SHOWN IN THE DIAGRAMS ON P AGE 7. Floor Protection USA - The floor in front and under the heater must be protected with a mini mum of 3/8” thick non combu stib le mate rial. The cover ing must extend 16” in front[...]

7 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Diagram A: T op View-Parallel Installation Diagram B: Side View-Alcove and Parallel Installations Footnotes: 1- These dimensions to the stove body are for reference only . Actual distances should be measured from the stove’ s flue collar . 2- Mi ni mum nonc omb ust ib le hea rt h pad di men[...]

8 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Figure 3 Figure 2 3. First, screw the threaded rods into the holes at the four corners on the bottom of the stove. Screw the threaded rods into the firebox three full rotations or 3/16” to 1/4” ( if the rear rods are screwed in too far they will lift the bricks off the bottom of the stove[...]

9 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. 1. If not previously installed, install floor protection and move the heater into the desired location. 2. Position the stove on your floor protection in the exact location where it is to be located, making sure all minimum clearances are met. 3. If you are installing outside air on your sto[...]

10 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. (For ash drawer pedestal see instructions included with pedestal) Residential and Mobile Homes (Bolting down and grounding are required only in mobile homes) CAUTION: Wear gloves during installation in case of sharp edges on the stove. 1. Remove the heater from the carton, if packaged, upon r[...]

11 1. Check that all chimney pipe joints are securely fastened. 2 . Check that the heater is securely fastened to the floor (if applicable). 3. Make sur e the int ake v ent h as c lear access to outsid e ai r (if applicable). 4. Make sure the outside air vent has been sealed properly to keep rodents out (if applicable). 5. Be sure all roof flashin[...]

12 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. CAUTION: Wear gloves during brick installation in case of sharp edges inside the stove. Note: Installation of the baffle boards and insulating blanket is easier when you can still access the flue outlet (before connecting flue vent). Be sure the baffle blanket is placed flat on the baf?[...]

13 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Be sure to clean the Nickel or Gold Plated door with a house - hold type glass cleaner and a ver y soft cloth to remove any fingerprints and residues prior to the first fire. 1. NEVER USE FLAMMABLE LIQUIDS TO ST ART OR REKINDLE A SOLID FUEL FIRE!! 2. Fully open the primar y draft control b[...]

14 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. W ARNINGS The blower must be plugged directly into a properly grou nded thr ee-p rong re cept acle , 12 0 V AC, 60 Hz, sin gle phase. Do not cut or remove the grounding prong from this plug. Do not route power cord under or in front of appliance. Installation must be in accordance with Nation[...]

15 It is important to know that for high, combustion efficient, clean burns, you will need to have sufficient temperatures inside the firebox for thorough combustion . The best method for determining if you have sufficient temperatures is to watch the brick lining in your firebox. When you first light your stove, the bricks will turn a dark b[...]

16 DOO R HI NGE S: If doo r hi nge s ne ed l ubr ic ati ng , use an an ti -se iz e com po und (never use oil) available from your Lennox Hearth Products dealer . DOOR LA TCH: If your door latch fails to latch tightly and the gasket is in good condition, place a length of pipe (cheater bar) over the inside portion of the door handle and bend slightl[...]

17 Problem Solution POOR DRAFT : Extend chimney in length or have the chimney realigned to the proper size flue. Oversized chimneys normally have poor drafts. Remember , the stoves’ draft depend solely on the natural draft of the chimney (See Drafting section on Page 4 ) . If your stove is not drafting properly , your chimney is the problem. All[...]

18 DO NOT : Install or operate this stove before reading this manual. DO NOT : Close the draft beyond the point at which the flames are completely extinguished. DO NOT : Open the stove door without fully opening the draft first. DO NOT : Burn driftwood or wood that has been in salt water . This includes some mill ends and scrap lumber that has be[...]

19 FRONT DOOR P ARTS LIST Item # Ca t . N o De s c ri p ti on 1 H5639 Door Rope Kit, 7/8” Dia. (6’ 2”) 2 H5629 Upper Hinge Pin 3 H5626 Upper Hinge Pin E-Clip 4 H5628 Lower Hinge Pin 6 H5640 Glass Gasket Kit (8’ 4”) 7 H5577 Set of 6 screws and 6 washers for door assembly 8 H5654 Spring Handle / Nickel H5653 Spring Handle / Gold 9 71099 T r[...]

20 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. REPLACEMENT P AR TS - MODEL S260[...]

21 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Door Parts Blower Parts 25 29 31 28 27 26 32 30 REPLACEMENT P AR TS - MODEL S260 7 11 10 6 9 5 4 4 1 8 2 3[...]

22 REPLACEMENT P AR TS - MODEL S260 22 24 18 20 21 23 Leg and Leg Parts NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE.[...]

23 REPLACEMENT P AR TS - MODEL S260 15 18 15 18 19 16 17 19 Ash Drawer Pedestal and Pedestal NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE.[...]

24 PE D E ST ALS ( RE Q U IR E D ) Ca t . N o . Mo d e l De s c ri p ti on 71 1 1 3 WL - PE D Pe d e st a l (ref. form #506033-16) 71 1 1 4 WL -P E D- ASH D A s h D r a we r Pe d es tal (ref. form #506033-15) OR L EG S ( REQ U IR E D ) (ref. form #506033-14) 70 0 0 0 LE G - OL Y -B Oly mpi c S c u lp t u re d Bl a ck s ( 4 p e r p k g .) 70 0 0 1 L[...]

25 SAFETY / LISTING LABEL - ENGLISH[...]

26 SAFETY / LISTING LABEL - FRENCH[...]

27 NOTES[...]

Printed in U.S.A. © 2007 by Lennox Hearth Products P/N 775,216M Rev . E 02/2010 Lennox Hearth Products reser ves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local distributor for fireplace code information. 28 Y our Appliance[...]